Gate Arrays facilitate custom algorithm development.
GateFlow(TM) Field Programmable Gate Arrays offload computational-intensive DSP functions from processor. They implement data formatting, timing, and specialized glue logic needed to connect real-time peripherals to programmable processors. Installed Cores offer streamlined Fast Fourier Transform (FFT) implemented on FPGA-based, dual-channel receiver Model 6235, and deliver spurious-free dynamic...
Read More »
Digital I/O Board plugs into PC/104 slot or stack.
Model 104-IIRO-16 32-channel board provides change-of-state detection, 60 V optical isolation on input lines, and standard Form C SPDT relay outputs. Isolated, non-polarized inputs may be driven by dc sources of 3-30 V or ac sources at frequencies of 45 Hz to 10 kHz. The 16 input channels are available via 34-pin header, while relay outputs are available via 50-pin IDC type header. Board is...
Read More »
USB Serial Converters suit scientific laboratory research.
Serial converter models NI USB-232 and NI USB-485 allow engineers and scientists to connect to existing serial instruments using USB technology. NI USB-232 converters use RS-232 Serial protocol, while NI USB-485 models use RS-485 or RS-422 serial protocols. Both converters are available in 2- or 4-port configurations. Data throughput rates are rated to 230.4 kb/s (NI USB-232) and 460.8 kb/s (NI...
Read More »
Disc Varistors provide surge protection.
NVD series metal oxide disc type varistors withstand surge currents and suppress transient voltages. Varistors are non-polarized and available in sizes of 5, 7, 10, 14, and 20 mm dia. Maximum allowable voltages are 14 to 1000 Vac and 18 to 1465 Vdc. Maximum peak current ratings are 125 to 7000 A and capacitance ratings are 70 to 10,000 pF. Varistors feature UL94V-0 rated flame-retardant coating...
Read More »
Reducing Risk Through On-Demand Manufacturing
Check out this white paper to learn how putting manufacturing safeguards in place stimulates growth and reduces risk in your supply chain.
Read More »
Quick Connect Receptacle is fully insulated.
PIDG FASTON brass receptacle features nylon insulation and copper support sleeve, allowing wire to bend in any direction without damaging insulation or conductor. It accepts .250 x .032 tabs and accommodates 22-18, 16-14, and 12-10 AWG wire ranges. Additional insulation helps prevent electrical shorts between terminals, while metal support sleeve provides wire support for applications subject to...
Read More »
Filter Elements resist pressure, temperature, and corrosion.
Knitted Wire Mesh Filter Elements (KWFE) offer alternative to sintered metals, plastics, paper, and cloth. Continuous lengths of uniform interlocking wire loops strengthen KWFE to provide vibration resistance. Available in plastic and metal alloy materials, KWFE can be used in applications that require flame resistance. Wire gauge, knit spacing, and degrees of compression provide various...
Read More »
Signal Conditioner controls multiple units.
Rack-mountable Model 2775B fits 1 to 6 units in 19 in. enclosure. It allows centralized control of up to 20 units per COMM port via RS-232 computer interface. Offerings include dynamic range from 0.01 to 100,000 engineering units and sensor input sensitivity range of 0.0001 to 10,000 mV/EU or pC/EU. It provides 3 outputs: AC output voltage proportional to input, DC output voltage proportional to...
Read More »
Bus Clock Synthesizers replace up to 8 discrete ICs.
SY89532/3/4/5 PLL-based precision bus clock synthesizers integrate 3 clock dividers, translator, and 3 fanout buffers into single, 64-pin TQFP package. They accept quartz-crystal oscillator input or differential or single-ended reference input, and provide LVPECL or LVDS output frequency between 33 and 500 MHz. Three output banks are independently programmed for target output frequencies. Jitter...
Read More »
Battery Formation Rectifier suits automotive applications.
BC/HD (battery charging/high density) system is suitable for formation of automotive, or flooded, lead-acid batteries. It can also be used for VRLA and high-production, water-bath formation installations. System is available with output currents of 10 to 60 A and output voltages up to 450 Vdc. Depending upon output and control requirements, it uses either Micro Me cabinet controller or...
Read More »
MOSFET BGAs work with battery packs.
FDZ2551N and FDZ2553N dual N-channel and FDZ2552P and FDZ2554P P-channel 20 V MOSFET ball grid arrays have physical and electrical characteristics that are suitable for Li-Ion battery pack protection applications. Each BGA is housed in 4 x 2.5 mm surface mount package, and has common drain connection and 0.8 mm mounted height. RDS(On) is 28 mohm and 14 mohm for N and P channel devices,...
Read More »
ISO-Certified Plastic Injection Molding from Rodon
The Rodon Group is a proven leader in high-volume, close tolerance injection molding. We offer globally competitive, innovative manufacturing solutions for a broad range of industries. Check out our video to learn more.
Read More »
