New Electronic Components & Devices Products

Interface Adapter expands DeviceNet(TM) capabilities.

Coupled with POINT I/O(TM), 1734-ADNX DeviceNet network interface adapter, with subnet expansion, provides control, configuration, and data-collection capabilities for industrial devices. It increases reach of DeviceNet to 1,500 m and, depending on scanner capability, to more than 126 nodes per scanner. Top connector connects adapter to main DeviceNet network and to controller scanner module....

Converter offers 15 Hz output rate with 50/60 Hz rejection.

Model LTC2435 20-bit analog-to-digital converter maintains 2 ppm integral nonlinearity performance and common-mode-rejection-ratio of 140 dB. On-chip oscillator eliminates need for external frequency setting components. No latency architecture allows single cycle settling for multiplexed applications. Converter comes in 16-pin SSOP package and operates from 2.7-5.5 V supply range. It consumes...

Backplane Chassis come in 6- and 8-slot versions.

Compact Packet Switching Backplane (cPSB) chassis solutions are compliant to PICMG 2.16 specifications. Chassis with 8-slots offers dual star topology for redundancy, 2 fabric slots, and optional second switch card. Version with 6-slots features one fabric slot and 5 node slots with cPCI. Horizontal 4U chassis includes flush mounted 6U x 160 mm IEEE 1101.10 card cage, rear 6U x 80 mm IEEE 1101.11...

VCXO Oscillator suits extreme temperature applications.

Based on fundamental crystal design, VPLD6* Series is housed in surface mount, 9 x 14 mm, VCXO package. It offers stabilities from 100-20 ppm and is available in frequencies from 16.384-200 MHz. Low jitter and temperature stability make oscillator suitable for use in PLL circuits, SONET/SDH applications, and remote or external locations where environment is not controlled. Series has differential...

Design Guide: Heat Sinks for High-Power Applications

Without appropriate thermal management, electronic components will degrade over time, causing problems ranging from minor errors to critical failures.

Panel Connectors suit freestanding wall applications.

Aluminum panel connectors provide solutions to freestanding wall applications where metal wall standards are required for product display. Structural profiles feature formed channels that nest traditional metal standards, and Corner Posts and 3-Way Posts accept Ã-¾ in. plus predrilled countersunk holes. Connectors are available in 96 in. lengths in satin anodized aluminum finish. Products may...

Half-Bridge Driver offers 6 A peak output drive current.

Model IX6R11 surface mount IC is optimized for high power, high frequency gate drive applications up to 650 V and 1 MHz. It drives large MOSFET and IGBT die sizes at higher frequency without need for additional discrete output transistors. Unit has 50 V/ns dV/dt noise immunity and 200 V negative voltage transient immunity. Chip enable signal is provided for controlled shutdown along with high and...

Schottky Diodes suit high-density power conversion applications.

Surface Mount Schottky Diodes offer voltage ratings of 40, 60, and 100 V. SMA products are rated for 1 A, while SMB products are rated for 2 A. Rectifiers with Schottky barriers are suited for power applications with high switching frequencies and requirements of low conduction losses, such as low voltage power supplies. Smaller device footprint, SMA and SMB cases enable designer to increase...

Precision Rail-to-Rail Op Amp draws 150 -µA supply current.

Suited for low-power instrumentation applications, LT6011 offers input offset voltage below 75 Ã-µV, input bias current of less than 0.9 nA, and noise voltage density of 14nV/HzÃ-½. Additional characteristics include open loop gain of 120 dB (min), CMRR of over 115 dB, and input offset voltage drift of 0.8 Ã-µV/Ã-

Data Acquisition Boards offer GPS time stamping.

Model PAR4CH consists of one 4-channel, 24 bit, A/D system that employs converter per channel architecture. Dedicated A/D chip for each channel eliminates crosstalk and settling problems. Able to connect to PC parallel port, unit includes 2 MB memory buffer and offers continuous, user-programmable acquisition rates from 0.1-5,000 Hz. Timing module PARGPS connects to PAR4CH and PC, providing 10...

Test/Burn-In Socket accommodates devices up to 13 mm-².

Type BGA/CSP test and burn-in socket handles devices with pitch from 0.50 mm or larger in applications up to 1 GHz. Solderless, pressure-mount, compression spring probes are located by 2 molded plastic alignment pins and secured with 4 stainless steel screws. Socket accommodates up to 500,000 cycles. Spring probe contacts are 9-12 g per contact for 0.50-0.75 mm pitches, and 17-20 g per contact...

TPA Motion Introduces Industry's First Compact Robotic Positioner for Medical Devices

TPA Motion's microplate handling robots are designed specifically for medical instruments and lab automation devices. Check out the video to learn more.