New Electronic Components & Devices Products

Catalytic Converter fits 1998-2000 Honda Accords.

Specifically designed for Honda Accords equipped with 4-cylinder, 2.3 L engine, Universal-fit Model 70262 is configured with center-mounted O2 sensor port to facilitate installation. It features round body that measures 14 x 10 x 4 in. Converter meets emissions and performance requirements and is OBDII-compliant in 49 states. It is not for installation on OBDII-equipped vehicles in California.

Portable TEDS Reader reviews transducer sheets via PDA.

TEDS Reader lets users review full contents of any embedded IEEE P1451.4 TEDS (Transducer Electronic Data Sheet) via PDA. Utilizing Dell Axim X3 PDA as its control/readout device, system displays contents of TEDS memory chip located inside transducer, including location and calibration coefficients. It shows entire transducer data sheet in full detail, and allows engineers to write task-specific...

Overvoltage Protector works with leading dispatch systems.

Solid state, silicon surge suppressor, Model VPR-30, protects first responder headsets and CIE processor applications. Unit offers protection against lightning strikes, electrostatic discharge, and power line crossing events for Centracom, Centracom Gold, and Centracom Gold Elite dispatch consoles. Designed to meet UL 497A specifications, suppressor measures 2 x 2 x 1.75 in. and includes 12 in.,...

Digital Signal Processor has 512 Kbytes of L2 memory.

With BDTImark2000(TM) benchmark score of 5,480 at 600 MHz, TMS320C6418 features Viterbi coprocessor and capacity for 2,400 16-bit or 4,800 8-bit million multiply accumulate cycles per second peak performance. Used for software radio and terrestrial and satellite broadcast applications, product includes 2 Multi-channel Buffered Serial Ports, 2 Audio Serial Ports, one 16-/32-bit microprocessor Host...

Confused About Which Screw Drive Style to Choose? Don't Lose Your Head!

This white paper outlines the different types of screw head and drive designs.

IDE Adapter supports both Type I and Type II cards.

Featuring 40-pin and 44-pin IDE connectors, remote CompactFlashÃ-® to IDE adapter, Model CFII-IDE(TM) enables both solid-state CompactFlash and IBMÃ-® MicrodriveÃ-® media to be used as bootable IDE disk drive in any computer with IDE interface. It includes power and drive activity LEDs, master/slave selection jumper, 4 mounting holes, and front panel mounting brackets. Model CFII-IDE...

Dimming Ballast offers ballast factor of 1.18.

Packaged in low-profile housing, Mark 7 0-10 V Electronic Dimming Ballast is rated at 277 V, allowing operation of four 32 W T8 fluorescent lamps. With dimming ability down to 3% relative light output, ballast will operate between 149 and 27 W. Unit includes programmed-start lamp ignition, total harmonic distortion below 10%, automatic restrike, and operation above 42 kHz. It is suited for big...

Power Inductors stay cool in high-frequency applications.

Low Loss Series 2100LL, 2200LL, and 2300LL High Current Toroid Power Inductors incorporate MAGNETICS Kool MÃ-µÃ-® or equivalent toroid core. Distributed air gap cores are made from ferrous alloy powder, enabling component to maintain low temperature rise at elevated frequencies. Available in horizontal and vertical mounting configurations, units feature inductance range of 1-1,000...

Electronic Ballast saves energy.

QUICKTRONICÃ-® High Efficiency Series uses up to 6% less energy than conventional electronic ballasts, without compromising light output or lamp life. It operates 17, 25, 28, 30, and 32 W T8 fluorescent lamps and features less than 10% THD and Universal Voltage. System operates from 120-277 V. Parallel lamp operation provides independent lamp operation, with same wiring and footprint as...

DAQ Boards provide simultaneous sampling.

Models PCI-6143/PXI-6143 are 8-channel, 16-bit devices that sample at 250 kS/sec per channel. They include digital triggering, 8 digital I/O lines, and two 24-bit counter/timers. Models PXI-6133/PXI-6132 are 8- and 4-channel, 14-bit devices that sample at 2.5 MS/sec per channel. In addition to flexible input ranges from Ã-

Solderless Connectors facilitate field installation.

Suited for LMR-240 low-loss coaxial cable, EZ-240-SM straight and EZ-240-SM-RA right angle SMA plugs attach to cable without soldering. Center contact attaches to center conductor of cable via beryllium-copper spring fingers, and outer contact crimps onto outer braid of cable. Each connector comes with dual-wall, adhesive-lined shrink boot for strain relief and weather protection.

TPA Motion Introduces New Curved Linear Rail Guides: the CR40 Series

For the ultimate in precision open and closed loop guided motion systems, TPA Motion is the leader in curved rail, liner guides. We specialize in engineering excellence, with products that exhibit an elevated level of precision, delivering robust performance, even under the most challenging conditions. See our video to learn more.