New Electronic Components & Devices Products

ETX Module offers customized, embedded solution.

Measuring 114 x 95 mm, AMD Geode GX533 offers clock speed of 400 MHz as well as support for Windows 98/2000/XP/XP Embedded/CE.NET and Linux. Processor core enables rapid time-to-market, and connectors allow for low profile final design.

Analog-To-Digital Converter targets PA linearization.

Housed in 9 x 9 mm QFN package, 12-bit, 185 Msps Model LTC2220-1 uses 910 mW and achieves 67.5 dB SNR and 80 dB SFDR up to 140 MHz input. Digital outputs can be differential LVDS or single-ended CMOS. Separate digital output power supply allows CMOS output swing to range from 0.5-3.3 V, minimizing switching noise. With 775 MHz full power bandwidth, ADC is suited for digital predistortion power...

Graphics Card suits multi-display applications.

Able to support up to 4 displays at a time, QID LP PCIe has single chip to control displays and to support x16 PCI Express natively. It includes 128 MB of graphics memory and supports resolutions up to 1,600 x 1,200 per display. Suited for mission critical environments, QIC LP PCIe features FanAlert software for system security and support for MicrosoftÃ-® WindowsÃ-® 2000 and Windows XP.

Sweep/Function Generator suits analog/digital applications.

Model 4012A utilizes standard 115 Vac power source and can produce precision sine, square, or triangle waves over the 0.5 Hz to 5 MHz range. It combines waveform generation, pulse generation, and frequency sweep into one device while also providing built-in frequency counter. Continuously variable dc offset allows output to be injected directly into circuits at correct dc bias level. Unit suits...

Design Guide: Heat Sinks for High-Power Applications

Without appropriate thermal management, electronic components will degrade over time, causing problems ranging from minor errors to critical failures.

Signal Conditioner supports LVDT, RVDT, or VRT sensors.

Model LVC-2412 single-channel DIN-rail mounted modular unit works either from 24 Vdc, for operation with systems using PLCs or mini-PLCs, or from 12 V for use in mobile and vehicular testing systems. Choice of 3 analog outputs is offered: 0 to +10 Vdc, 0 to 10 Vdc, or 4 to 20 mA current loop. DC input power is isolated from analog outputs allowing unit to be connected in either 4-wire fully...

N-Channel MOSFET Drivers feature 1 A drive capability.

Models SiP41103, SIP41104, and SiP41105 drive lower and upper MOSFETs in half-bridge configuration, and work in systems with supply voltages from 4.5-50 V. Units operate at switching frequencies of 250 kHz to 1 MHz with driver impedance of less than 1 ohm. Equipped with brake function for motor drive applications, Model SiP42101 operates at 50 kHz. Break-before-make logic prevents shoot-through...

Commercial Surge Suppressors protect sensitive equipment.

Eclipse-T TVSS Series includes single- and 3-phase models offering peak capacities from 100-500 kA in modular and non-modular panels. All feature audible alarm, LED indicators, and dry contacts to notify users of system status, as well as individually fused metal-oxide varistors. Most include surge counter and LightningTemp fuse to prevent thermal runaway if MOVs are damaged. SineWave Tracker...

Charge Pump Doubler is offered in 2 x 2 mm DFN package.

Model LTC3204-3.3 features low-noise constant-frequency operation at 1.2 MHz and generates regulated boosted output voltage of 3.3 V from minimum input voltage of 1.8 V, at output currents up to 50 mA. LTC3204-5 produces 5 V output from minimum 2.7 V input at currents up to 150 mA. Automatic Burst ModeÃ-® operation at light loads provides low supply current of 48 uA and helps extend battery...

FPGAs consume as little as 0.18 W at 25-

StratixÃ-® II FPGAs feature total I/O pin capacitance from 3.3-6.1 pF. Maximum operating frequencies include 350-400 MHz for M-RAM and M4K blocks, 350-420 MHz for DSP block, and 370-380 MHz for M512 block. LVDS provides signaling speeds of 800-1,040 Mbps. Quartus II v4.2 development software provides tools for generation of toggle information from simulation vectors, automatic model...

Surface Mount RF Chokes target lighting industry.

Series HL 8527 can handle high voltage spikes associated with starter circuits and electronic ballasts within lighting industry. With current ratings from 67-50 mAdc, units feature inductance from 16,000-55,000 Ã-µH at 79 kHz. Additional applications include RF signal circuitry in communications equipment, medical diagnostic equipment, and industrial process control equipment.

SRG Global Coatings Enhance Surface Durability, Efficiency, Design Flexibility

SRG Global's automotive coatings enhance the structural integrity of the finished part while also improving vehicle efficiency. Check out our video to learn more.