New Electronic Components & Devices Products

High Temperature Resistors withstand up to 200-

TaNFilm products allow engineers to maintain critical electrical characteristics in high temperature applications. Product line includes PFCD-HT series surface mount voltage dividers in 1206 size package, PFC-HT Series chip resistors in industry standard 0603, 0805 and 1206 chip sizes, and 1900HT and 4700HT high temperature DIP and SIP networks. Devices suit applications where parts are subject...

Concentrator System converts HART signals to MODBUS RTU.

HCS HART Concentrator System converts HART digital signal to RS-485 MODBUS RTU communication protocol, permitting up to 16 smart HART-capable transmitters and valves to interface directly with MODBUS-based monitoring and control systems. Users can monitor primary and non-primary process variables from various devices, and MODBUS system can monitor HART instrument diagnostics using Field Device...

Dimming Ballast works with metal halide lamps.

Offered in 150 W model (IZT-MH-150-CLF), e-VisionÃ-® Electronic HID Ballast features 0-10 V dimming interface with dimming to 60% lamp power. Unit incorporates IntelliVoltÃ-® technology, which enables operation at any input from 120-277 V, 50/60Hz. Ballast also features lamp wattage regulation and electronic circuitry. Safety features include automatic lamp power control/monitoring, power...

Electronic Interface works with turbine flow meters.

PC-programmable F5140 K-Factor Scaler acts as field-adjustable frequency divider, converting pulsed frequency output from turbine flow meter to scaled, square wave output. It provides interface for PLC, RTU, PC DAQ cards, or any frequency counter or data input device. With optional software, unit also converts turbine meter output into frequency for other units of measurement. Interface includes...

Metal Finishing Selection Guide

This unique chart compares different metal finishes by cost, corrosion resistance, applications and more.

Solar Cell extends battery life by up to 2 years.

Intended for outdoor gate applications, Model SCP 44 provides 9 Vdc power source to thru beam photoelectric sensors and enables direct connection between cell and signal emitter though one 6 m cable. Cell makes it unnecessary to install moving cable for sensitive edge and replaces photocells that are normally mounted in internal part of automatic gate.

Adapters allow inductive sensors to see around corners.

Right-angle Banking Screw Adapters (BSA) enable non-contact sensors to sense around corners and stop up to 4,600 lb loads. Suited for automation applications, BSA-A devices consist of heat-treat hardened, zinc-plated alloy steel components; threaded barrel; and spring-loaded piston. Sensors trigger on/off with displacement of threaded barrel's piston. Various barrel lengths/diameters, spring...

SMB Interconnect suits board-to-board applications.

Eliminator(TM) Series SMB right-angle interface allows direct connection to PCB without additional cables or connectors. Available in 50 and 75 Ω impedance, unit provides broadband performance with reflection from dc through 4 GHz. It is made from precision-machined brass with TFE insulators and gold-plated contacts. Connector features insulation resistance of 1,000 mΩ min, dielectric withstand...

Connectors suit high voltage applications.

Designed for cables with jacket OD from 0.73-Ã-½ in., LC and LT Connectors can also be adapted to smaller diameter cables. Units are rated to 5,000 V standard, and up to 10,000 V with specific cable preparations. Operational range is DC to 1 GHz. Specified to MIL-PRF-39012 or MIL-C-3650 standards, both connectors maintain 50 ohm impedance, but are not interchangeable.

Power Modules suit high-efficiency applications.

Manufactured in isolated packages, Field Stop Trench Gate IGBT standard power modules include 600, 1,200, and 1,700 V devices in SP4 and SP6 packages with min VCE(sat) saturation voltage of 1.5, 1.7, and 2 V. Modules are offered in 10 configurations, including buck, boost, dual common source, full bridge, triple phase leg, and triple dual common source. Optimal switching frequency is 20, 10-20,...

Boards provide PCI data acquisition.

DaqBoard/3000(TM) Series consists of 4 boards equipped with custom data acquistion engine capable of making analog measurements at 1 Ã-µs/channel, and concurrently reading digital and counter inputs, while generating up to four 1 MHz/16-bit analog waveform outputs plus digital pattern generation. Boards include 8 differential or 16 single-ended analog inputs, 24 high-speed digital I/O lines,...

High or Low Volume Custom Crates and Boxes Available from Reid Packaging

Reid provides mil-spec crates and corrugated boxes in custom dimensions from single to triple wall and will even package them on-site. Check out the video to learn more.