Converter extends serial network connections to 40 km.
JetCon 2401 transmits RS232/422/485 serial protocols over fiber media for data collection, industrial, and security applications. Fiber transmission extends serial signals up to 40 km in single mode or up to 5 km in multi-mode. Fiber optic network link is immune to EMI, RFI, cross-talk, ground loops, and other electrical problems. Product supports P2P full duplex and serial fiber ring half duplex...
Read More »Carrier Card integrates PMC boards into cPCI racks.
Model cPCIBPMC6U-ET has 2 PMC card slots mounted to universal voltage 6U 4 HP cPCI card. Bridge allows for isolation and for differing clock rates on cPCI backplane and PMC, which can operate at speeds above, same, or below the cPCI clock rate. Bridge has built in features for local address spaces, using PMC clock in monarch mode for secondary side, and operating in transparent or non-transparent...
Read More »
Amplifiers optimize distortion power and noise performance.
Integrating precision gain-setting resistors on-chip, Model LT6402 and LT6411 differential amplifiers can be used as high-speed ADC drivers, twisted-pair line drivers, and single-ended to differential signal converters. Model LT6402 has -3 dB bandwidth of 300 MHz, and is available in 6, 12, and 20 dB fixed gain options. With -3 dB bandwidth of 650 MHz and slew rate of 3,300 V/Ã-µs, Model...
Read More »
Power Connectors provide high current carrying capacity.
Providing current-carrying capacity of up to 20 A per contact and voltage rating of 150 V, AirMax VSÃ-® power connectors feature flat contacts and enable use of high conductivity base metal. Available as right-angle header and vertical receptacle, compact 2x2 and 2x3 connectors match 11.5 mm above-board height of VS 3-pair signal connectors. Open passages allow air flow over contact's...
Read More »
Design & Manufacturing Process of a Coil
Because the design and manufacturing of electromagnets are critical to the successful operation of the application, it's important to spend time defining your requirements before purchasing coils for an application. This eBook will guide you through the process of evaluating the application's constraints, identifying the needed specifications, and collaborating with a manufacturer to develop an appropriate coil solution for the application.
Read More »Connector Modules target 10 Gigabit Ethernet applications.
Suited for use with 10 Gb hot-pluggable optical transceivers, XFP001/2/3-L Series supplies EMI protection. Cage and connector comply with MSA 3.0 standard and support OC192/STM-64, 10 Gb Fibre Channel, G.709, and 10 Gb Ethernet protocols. Standard 1 x 1 cage measures 21.7 x 65.3 x 13.2 mm and comes with clip and heat sink. Cage is made of nickel-plated copper alloy to prevent oxidation....
Read More »
Bag Filter Housing suits high-flow rate applications.
Designed for liquid filtration applications with flow rates to 4,500 gpm, MAXILINE(TM) MBF HD Multi-Bag Filter Housing features hand wheel-operated davit cover that withstands industrial and commercial use. Design facilitates filter media changeout, and 3-point filter bag hold downs or bayonet fittings ensure seal between filter bag and housing body protects against process media bypass. Offered...
Read More »
Inline Filters are rated from 3-3,000 microns.
Accommodating flows from 25-4,000 gpm, Inline Filters are available in simplex or duplex models with variety of housing materials and coatings. Duplex design allows continuous operation since one filter element may be isolated and serviced while system is operational. Media on replaceable elements ranges from pleated synthetic glass fiber and Dutch weave wire mesh for finer filtrations to square...
Read More »
Power Resistors provide optimal heat dissipation.
Rated up to 75 W, Series BHP75 is housed in TO-220 open-screened substrate package with insulated tapered venturi bonded to substrate for maximum heat dissipation. Resistance ranges from 1 W to 100 KW, with tolerances of Ã-
Read More »QNX Neutrino RTOS Now Works with National Instruments Data Acquisition Devices
OTTAWA, Nov. 13 -- QNX Software Systems today announced that its QNXÃ-® NeutrinoÃ-® realtime operating system (RTOS) is now supported by the National Instruments Measurement Hardware Driver Development Kit (MHDDK) and PCI multifunction data acquisition (DAQ) devices. As a result, design engineers can choose from the immense range of NI DAQ products -- from low-cost single-function units...
Read More »
Video Analytics for Multi-Core Embedded Systems
Berkeley, California -- November 13 - Eutecus, Inc. now offers video analytics for high-speed image processing on embedded security/surveillance applications. These complex algorithms process images from security cameras and identify a wide range of behaviors that require further investigation by human security staff--such as people loitering, removing or abandoning an object, or cars or people...
Read More »
Neagle Choice, LLC Announces New Available Services
Neagle Choice has long been known as a quality source for commercial sewing, printing, die cutting, and the manufacturing of a wide range of custom products. Enhancing our service capabilities has been the key to our success, and has driven our growth into many new and exciting markets. Continuing on this trajectory, we now offer precision laser cutting and etching, adding to our long line of manufacturing services. See our video to learn all about it.
Read More »
