Electronic Components & Devices

Raintight Couplings feature external inspection aid.

Raintight Couplings feature external inspection aid.

UL listed Raintight EMT steel compression-type couplings and connectors feature InspectoRidge for visual identification. By observing the ridge, electrical inspector can determine if outdoor, wet, or damp installation requiring raintight couplings and connectors is up to code. Products are offered in Â-½-1 in. sizes with internal sealing ring and gasket. Rugged steel construction has a zinc...

Read More »
Filter Protectors cover frequency range of 100-700 MHz.

Filter Protectors cover frequency range of 100-700 MHz.

Series HF protects multiple or high-power single RF transmitter applications where dc voltage is not required. Capable of handing up to 750 W, dc blocked filter features multi-strike capability and fully weatherized housing. Insertion loss is 0.1 dB or less. Suited for operating temperatures between -50 and +85Â-

Read More »
Low Pass Filter works as drop-in component.

Low Pass Filter works as drop-in component.

Measuring .550 x .440 x .025 in., thick film drop-in low pass filter is integral, planar, and surface-mountable. Bilaterally symmetric design incorporates lumped/distributed parameters and contains 7 sections with 50 Ohm input and output. Passband is 1,200 MHz Â-

Read More »
Amplifier loads transducer data with single key stroke.

Amplifier loads transducer data with single key stroke.

Model ML801B multi-channel amplifier module features TEDS identification. Digitally stored data is electronically transferred to amplifier, allowing it to select correct settings and start taking measurements. ML801B permits number of sub-channels to be reduced to 8, 4, or 2 as needed, giving corresponding sampling rates of 2,400 Hz, 4,800 Hz, and 9,600 Hz. All channels are measured synchronously...

Read More »
Telecom Blade is based on PowerPC 750FX processor.

Telecom Blade is based on PowerPC 750FX processor.

Katana(TM) 750v cPSB blade features 2 PTMC sites, 5 Ethernet channels, and CTBus/H.110 TDM interconnect. Unit combines 800 MHz processor with Marvell MV64360 system controller, which provides high-speed access to as much as 1 GB SDRAM and 128 MB of flash memory. PTMC sites, which support 32-bit PCI data transfers at 33 MHz or 66 MHz, are equipped with dedicated CTBus and RMII interfaces. Blade's...

Read More »

Fiber/Triax Adapters provide camera power using triax cable.

Hybrid Models HFT-BS and HFT-CA deliver means for deploying HDTV cameras in large venues with power provided through triax cable or locally with batteries. Units convert SMPTE hybrid electrical and fiber optic interfaces for HDTV cameras into standard single-mode fiber optics interface, eliminating portion of SMPTE 311M hybrid cable between camera and CCU.

Read More »
Chips offer serial communications.

Chips offer serial communications.

Known as center device, Model G9001 has 256 bytes of RAM available for I/O and 512 bytes of RAM for motion control and data communication. I/O Models G9002 and G9003 serve as local devices that can be connected to G9001. Model G9002 has four 8-bit ports, and single-axis Model G9003 outputs 5 Mpps to control stepper or servomotors. CPU emulation device, Model G9004 can operate in CPU emulation...

Read More »

Digital Signal Processors target packet-switched telecom.

Models TMS320C6410 and TMS320C6413 include 2 standard McBSPs for multi-channel clocked serial communication, 2 Audio Serial Ports compatible with IIS and common stereo codecs, 16-/32-bit microprocessor Host Port Interface, and 2 IIC control serial ports. Model TMS320C6410 runs at 400 MHz with 160 Kbytes total memory, while 500 MHz Model TMS320C6413 offers 288 Kbytes total memory. Both come in 23...

Read More »

DSP Chip comes in ball grid array package.

At 500 MHz, TMS320C6413 digital signal processor (DSP) employs parallel architecture with 8 parallel functional units in DSP core and 256+ KBytes on-chip memory. Tailored telecom peripherals include 2 multi-channel buffered serial ports, 2 audio serial ports, 2 IIC control serial ports, and 3 general 32-bit timers. Chip's 1 mm ball pitch on BGA package facilitates 4 layer board routing. Device...

Read More »
Magnetic Latching Valve suits limited power applications.

Magnetic Latching Valve suits limited power applications.

With pressures to 500 psi, Magnetic Latching Valve is offered in 6-60 Vdc and draws approximately 7 W when energized. Encapsulated into single package, coil and rare earth magnet assembly come with either lead wire or male DIN style connection. Valve requires only 30 ms of power application to latch or unlatch. It is suited for tight spaces and remote areas where continuous power may not be...

Read More »
Basalt America Announces Stronger, Lighter, and Corrosion-Free FRP's (Fiber Reinforced Polymers)
Sponsored

Basalt America Announces Stronger, Lighter, and Corrosion-Free FRP's (Fiber Reinforced Polymers)

Fiber Reinforced Polymers (FRP), represents a truly groundbreaking advancement in structural reinforcement. Lightweight, strong, and green, they are changing the way the construction industry thinks about rebar. Unlike steel, FRPs don't rust and are far stronger than standard rebar. To learn why Fiber Reinforced Polymers are poised to change the way the world builds, see our video.

Read More »

All Topics