New Electronic Components & Devices Products

Chip Inductors combine low RDC and high-current operation.

Measuring 3.2 x 1.8 x 1.8 mm, LB3218 series wire-wound chip inductors combine functionality of two 3225-size low-resistance (RDC) and high-current inductors into one 3218-size device. Series, comprised of 16 part numbers rated from 0.05-6.5 ohms and 1,000-60 mA, offer inductance ratings from 1.0-330 Ã-µH at operating frequencies of 796 kHz to 7.96 MHz. Non-polarized electrodes enable mounting...

Signal Conditioner monitors temperature in transformers.

Designed for direct and hot spot monitoring in small and medium generation, transmission, and distribution transformers, multi-channel Nortech TT is intended for Energy Utilities concerned about safety and operation of high voltage equipment. Equipped with RS-232 and RS-485 ports, fiber optic unit offers MODBUS communications for integration with existing substation platforms. It is available...

Connectors suit sealed bulkhead applications.

Available in 4, 6, 9, and 12 contact position versions for 20-14 AWG wire, Universal MATE-N-LOK Connectors provide environmental sealing protection to IP56 by employing wire entry seals, interfacial seal, and bulkhead seal. Four-contact position version handles up to 15 A/contact using 14 AWG wire, while 12-position unit handles up to 11 A with 14 AWG wire. Rear mount flange allows connectors to...

Backplane utilizes CompactPCI Express architecture.

Based on PICMG specification, EXP0 four-slot CompactPCI Express backplane contains system slot, one Type 1 slot, and 2 Type 2 slots. Backplane, featuring 10-layer stripline design and user available backplane I/O of P3, P4, and P5 connectors. CompactPCI Express supports Intel PCI Express architecture in 6U-160 Eurocard form factor. It connects cards via serial point-to-point bus with read-only...

A Quick Guide to MASKING SOLUTIONS

This guide will provide an overview of the different masking options, and provide insight on which to use for your product.

Frequency Converter has modular design.

Featuring motor shaft power to housing volume ratio of 3.6 kW/dmÃ-³, size 7 b maXX can be extended in accordance with application requirements. Construction incorporates short conductor rails, water cooling system, and continuous platform. User can add new functionality to controller via plug-in modules, and all controllers in b maXX range are parameterized via WinBASS II. Product enables...

Lead-Free IC Package offers green-certified solution.

Optimized for lead-free manufacturing, package integrates HysolÃ-® GR828H mold compound with Hysol QM1519 die attach adhesive for wire sweep properties and adhesive strength, respectively. Green solution, designed for 16- and 14-lead, Pb-free SOIC packages, uses Cu/Ni/Au leadframe. It achieves MRT reliability for MSL L1 up to 260Ã-

Analog-to-Digital Converters suit software defined radios.

Featuring sampling rate of 105 MS/sec, 14-bit, dual ADC Model LTC2284 delivers flat SNR response of 72.2 dB up to 70 MHz as well as SFDR of 88 dB at baseband. Models LTC2280 and LTC2282 are 10-bit and 12-bit dual ADCs also with 105 MS/sec bandwidth sampling rate. Housed in 9 x 9 mm QFN package, all devices consume 270 mW per channel, with crosstalk between channels of -110 dB. They are optimized...

GPS Chipset integrates total functionality in one package.

SiRFstarIIx chipsets are available in GSC2x, GSC2xr, and GSC2xrx versions that integrate RF and baseband into one package; models GSC2xr and GSC2xrx also eliminate need for external flash memory. Measuring 10 x 7 mm, single-chip solutions require 60 mW power for nominal operation and 25 mW for TricklePower operation. Internal software allows use of various configurations from blinking LEDs and...

GPS Receiver comes in 10 x 10 x 1.8 mm, 36-pin package.

RF-shielded MN1010 Module, designed for portable consumer electronic applications, is complete 12-channel Global Positioning System (GPS) receiver that requires power and antenna for operation. Drawing less than 75 mW, receiver allows all satellites in view to be tracked, minimizing position jumps caused by individual satellite blockage. GPS chipset, from u-Nav microelectronics, features uN1008...

Flat Chip Resistor Arrays offer matched tolerances to 0.1%.

Housed in 1.6 x 3.2 mm package, ACAS 0612 Series has absolute TCR down to 25 ppm/K and tracking TCR as low as 10 ppm/K. Available in precision and professional versions, devices offer resistance values from 100 ohm to 221 kohm in numerous configurations including 4 equal, 4 different, or 2 equal value pairs. Each resistance element is rated to 0.1 W dissipation, up to max of 0.3 W per package....

How SpinSelect Can Save You Time and Money

Thanks to the unique SpinSelect™ Multi-Pocket selectable quick change tool holder, it's time to rethink the range, complexity and volume of parts that your lathe can produce. Our Spin-Select™ tool was created to increase productivity and consistency by decreasing downtime associated with lathe cutting tool and insert setups or changeovers. This product is a game-changer for the industry and we're pleased to show you why.