Electronic Components & Devices

Processor Blades are PICMG 2.16 compliant.
Switches

Processor Blades are PICMG 2.16 compliant.

Single-slot Model cPB-4325 offers choice of one or two 933 MHz Intel Pentium III processors with 512 KB L2 caches. Model cPB-4321 comes with 1 GHz Intel Pentium III processor, with 256KB L2 cache and 440GX chipset with 100 MHz front side bus. Model cSB-4240 hot-swappable Managed Layer 2/3 switch provides 2 Gigabit and 24 Fast Ethernet ports in 6U x 4HP CompactPCI form factor blade. Model...

Read More »
Electronic Amplifiers

Op Amps feature typical quiescent current of 600 nA

Series MCP614X features gain bandwidth product of 100 kHz and maximum quiescent current of 1 Â-µA. Units offer rail-to-rail input and output that allows full voltage supply range to be utilized from 5.5 V down to 1.4 V supply operation. They are fully specified from -40 to +85°C. Devices are stable for applications with gain of 10 V/V or better. They are available in 8-pin PDIP, SOIC,...

Read More »
Feedthrough Capacitors withstand temperatures up to 300°C.
Capacitors

Feedthrough Capacitors withstand temperatures up to 300°C.

Feedthroughs eliminate noise and frequency interference in discoidal capacitance filtering applications and eliminate need for externally mounted capacitor chips. Utilizing glass and proprietary soldering techniques, single-pin design styles can be custom manufactured for unique applications. Capacitance values range from 5 to 27,000 pF, with tolerances as tight as ±10%. Units are available...

Read More »
Frequency Transmitters come in rangeable and fixed range models.
Converters

Frequency Transmitters come in rangeable and fixed range models.

Rangeable Model JH7580 Frequency to DC Transmitter compliments fixed-range Model JH7010. Inputs run from 10 Hz to 100 kHz with voltages from 50 mV to 700 V peak-to-peak. Output ranges may be as low as 0/1 V or as high as -10/+10 Vdc. Current choices range from 0/1 to 0/25 mA and include 4/20 mA. Transmitters feature built-in pull-up resistor for open-collector or contact-closure inputs and 18 Vdc...

Read More »
PC/104 Board combines interfaces for military applications.
Electronic Boards

PC/104 Board combines interfaces for military applications.

Model PRV-0950X-01 1553/Ethernet Interface Board utilizes MIL-STD-1553 support chip to operate as data bus controller, remote terminal, or bus monitor, and operates over -40 to +85°C. Four 16-bit register locations allow complete access to interface functions through PC/104 I/O space. Test routines enable access to memory and internal registers. Ethernet portion is fully NE2000 and...

Read More »
Oscillators produce low-jitter sine wave signal.
Oscillators

Oscillators produce low-jitter sine wave signal.

M4001/M4002 2.488 GHz VCSOs oscillators are suited for applications between 600 MHz and 2.5 GHz. Housed in 9 x 14 mm J-lead ceramic package, the M4001 is a 3.3 V device, and M4002 is a 5 V device. They offer sub-picosecond jitter at .15 ps RMS typical, and are suitable for use as IF local oscillators or mixer local-oscillator drivers for IQ modulators, mixers, and IEEE802.11b (WLAN), and ISM band...

Read More »
Surge Suppressors

Surge Protectors plug into outlet or computer.

Models 2R8 and 2R8IEC are 2 receptacle, 8 A stand-alone models that protect typical computer systems. IEC model comes with IEC connector and cord, with standard 120 V plug. This allows surge protector to be plugged into standard outlet or used directly with IEC connectors. Model 2R8IEC, with optional Spectrum WVR(TM) (wide voltage range) technology, operates from 85 to 265 V and allows unit to be...

Read More »
Electronic Adapters

Ethernet Driver works with KEPServerEX OPC server.

Siemens S7-300/400 Ethernet device driver works in conjunction with OPC Server KEPServerEX, to provide data exchange between OPC Clients and Siemens S7-300 and S7-400 PLCs using TCP/IP Ethernet protocol. Driver talks directly to S7 PLC using standard PC network interface card. No additional software packages or libraries are required. KEPServerEX automatically optimizes data acquisition based on...

Read More »
Power/Snubber Resistors suit power electronics circuits.
Resistors

Power/Snubber Resistors suit power electronics circuits.

Non-inductive, heat sink mountable designs, suitable for high power density designs, allows TO-Style resistors to operate up to 500 MHz in 25 to 100 ohm range. Power ratings range from 25 W (TO-126) to 100 W (TO-247), at +25°C case temperature. Resistance range varies from 0.005 ohm to 100 K ohm, and tolerances are rated at 1% standard (most resistances) with 5% tolerance also available.

Read More »
Motor Amplifier drives linear or rotary devices.
Amplifiers

Motor Amplifier drives linear or rotary devices.

Available in a small box and for use with all standard Nanomotion motors, AC4 provides motor power for maximum of four elements (up to HR4 Motors). Amplifier is 50% smaller than previous version and accepts 12 V input. AC4 is available with analog input (±10 V) or SPI digital input.

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers