Electronic Components & Devices

Electronic Components & Devices, Mounting & Attaching Products

Push-On Coax Connector terminates cable.

Nov 13, 2001

Designed for commercial and residential applications, EZ Twist requires no tools or crimping. To terminate, twist connector onto cable for secure connection. Device eliminates screw-on connections to outlets by pushing connector onto outlet to lock in place and pulling to remove. Straight push-to-lock method is used in high-density installations like home cabling enclosures, where space for... Read More

Electrical Equipment & Systems, Electronic Components & Devices

Transformers are for full rate or ADSL applications.

Nov 09, 2001

Engineered to match Texas Instruments' AC5 octal chipsets, Bel S560-6600-Z6 and S560-6600-CE transformers offer total harmonic distortion in EP10 packages. They are suited for Digital Subscriber Line Access Multiplexer equipment and may be specified for remote site Digital Loop Carrier multi-port applications. Devices feature electromagnetic interference suppression, operating temperature range... Read More

Electronic Components & Devices

Terminal Block rises up to 3 tiers.

Nov 08, 2001

ELVM series of 0.150 in. pitch-rising cage terminal blocks is compatible with SMT reflow and wave soldering processes. Blocks are available in tiered, three-row configurations ranging from 2 to 10 poles per row, or a maximum of 30 circuits per block. Tiers are offset to facilitate host equipment wire installation and field service. Blocks may be stacked end-to-end on PCB without losing a contact... Read More

Electronic Components & Devices

Aluminum Electrolytic Capacitors are compact and snap into place.

Nov 08, 2001

Snap-in capacitors are manufactured with can-wall groove that supports top, which is added after insertion of capacitor element. Because cans are nearly full, units are more compact than previous models. Type 380LQ is rated for -40 to 85°C operation; Type 381LQ is rated for -40 to 105°C operation; and Type 380LQ has a voltage range from 160 to 450 Vdc in capacitance values from 82 to 3900... Read More

Electronic Components & Devices

Male Connectors are designed for use in backplanes.

Nov 08, 2001

Type D Vertical Male Connectors are 8+2-row x 25-position headers that provide up to 220 signal contacts evenly distributed on 2 mm grid. They are UL approved and comply with requirement of IEC 917 and IEC 61076-4-101 specifications. Featuring multipurpose center incorporating pre-alignment guides, connectors feature press-fit design for gas-tight connection to PC board and are available in a... Read More

Electronic Components & Devices

Oscillator features frequency range to 156.25 MHz.

Nov 08, 2001

F4100 Crystal Oscillator offers standby mode for lower power consumption. Miniature 3.3 V oscillator features operating temperature range of -10°C to 70°C. Frequency stability is +/-100 ppm for all conditions. Output symmetry is 40% to 60% at 1.65 V over entire frequency range of 125 to 156.25 MHz; input current is 60 mA maximum. Unit is suitable for Fibre Channel, SONET, ATM,... Read More

Electronic Components & Devices

Oscillators and VCXOs offer low noise performance.

Nov 08, 2001

LVDS products are available in 9 x 14 mm J-lead ceramic packages as well as 5 x 7 mm leadless ceramic packages. UVC series oscillator is housed in 5 x 7 mm leadless ceramic package. M5R series oscillator comes in 9 x 14 mm J-lead ceramic package. MPV3 series is 9 x 14 mm J-lead ceramic package SMT VCXO. UVV series is 5 x 7 mm leadless SMT VCXO. LVDS output and frequencies up to 800 MHz are... Read More

Electronic Components & Devices

Switch Modules can be stacked to achieve desired voltage.

Nov 08, 2001

PowerMod(TM) Solid-State Switch Modules are available as 6 kV (500 kW peak power), 9 kV (270 kW peak) and 12 kV (1 mW peak) plates. They are immune to arcing, emissions and lifetime limiting factors associated with conventional vacuum tubes. Modules require only dc voltage source and input signal, and can be passively air-cooled. Individual units measure 7 x 7 x 3 in. (6 and 9kV) and 12 x 12 x 3... Read More

Electrical Equipment & Systems, Electronic Components & Devices

Flyback Transformer features corona-free design.

Nov 08, 2001

Model 4283-1100 High-Voltage Transformer drives high impedance loads requiring up to 7,500 Vrms. Providing primary-to-secondary isolation up to 18 kVdc, unit is suitable for applications requiring high-voltage, low to medium power including industrial lasers, ion generators, cathode ray tube transformers and traveling wave tube power supplies. Model 4283-1100 is particularly reliable in... Read More

Electronic Components & Devices

Capacitors are for use in high power ac filtering.

Nov 08, 2001

Series 5MPA film capacitors are supplied with bolt-down terminations at voltage ratings of 530 Vac. Capacitance values to 10 µF are supplied with brass bolt termination and values to 100 µF are supplied with bridge and bolt construction. Units provide continuous operation to 85°C with current handling spectrums from 50 Hz line to 20 kHz sumperimposed feedback. Wrapped in flame-retardant... Read More

Electrical Equipment & Systems, Electronic Components & Devices

Dual Transformers feature low profile.

Nov 08, 2001

TLP-1000 Series 1553 dual side-by-side tranformers satisfy height constraints of demanding PCB designs. They are 0.155 in. high, 0.930 in. long and 0.630 in. wide, and available in all popular ratios. Single, dual and triple-stub 1553 box couplers, in-line couplers and related hardware are also available. Read More

Electronic Components & Devices

Anodes can be supplied as wire, rod and woven mesh.

Nov 08, 2001

Platinum Clad Anodes feature complete metallurgical bond of metals and are available as platinum clad niobium or platinum clad titanium, with or without copper core. Platinum thickness can range from 10 to 600 µin. Supplied as wire and rod 0.031 in. to 1 in. dia, and as woven mesh up to 24 in. wide, anodes are dimensionally stable which provides uniform plating in metal finishing applications... Read More

Electronic Components & Devices

LED Lamps have extra-large lenses.

Nov 08, 2001

Series L806T 20 mm Big Dome Discrete LEDs have 6 SMT LED diode chips arranged in a circle on printed circuit board and a large lens that together improve viewing and light dispersion. Lens height is 0.543 in. at apex with 0.898-in. dia. Applications include large dot matrix displays, color screens, moving signs, utility monitoring boards, industrial control equipment, dot matrix clocks, soft-glow... Read More

Electronic Components & Devices

Capacitors are designed for high voltage applications.

Nov 08, 2001

MVDR Inductive Capacitors feature capacitance range of 500PF and 1000PF, with voltage range from 10 to 15 kV, and capacitance tolerance at ±10%(K). Self-healing and equipped with tinned copper-clad steel axial leads, MVDR types may be combined in parallel and/or series to achieve various capacitances and voltages. Construction features include internal multi-series connection windings with... Read More

Electronic Components & Devices

Clock Oscillators support fibre channel data storage.

Nov 08, 2001

CB3 106.25 MHz clocks are available in stability grades of 25, 50 and 100 ppm. They are offered for 3.3 and 5.0 Vdc systems and draw 40 and 50 mA, respectively. Output is CMOS compatible and includes output enable/disable feature. Four-pad, 5mm x 7mm surface-mount oscillator packages are compatible with SMT pick-and-place assembly equipment. Temperature ranges include 0 to 70°C for commercial... Read More