New Electrical Equipment & Systems Products

One-Handed Clamp uses self-restraining technology..

AdelokÃ-® helps assemble clamped components by holding itself closed and in place during installation. It is suitable for rapid clamp assembly and improved stacking methods for fluid lines and hoses, wire bundles, power cables and fire detection sense lines. Juggling of fasteners, standoffs, washers, ties and grommets is eliminated. Clamp can handle payloads of 0.062 to 3.50 in., and can be...

Plug-in Transducers reduce installation time.

786 Series transducers can convert 0-10 V or 4-20 mA signals into isolated 0-10 V, 0-20 mA, or 4-20 mA signal with isolation rating of 4kV. It can be plugged directly onto terminal block assembly using base receptacle blocks that are 15, 20, or 25 mm wide. Modules are protected against mismating and can be replaced in single operation during maintenance without affecting wiring. Touchproof test...

Transformers operate at 90% efficiency,

High efficiency R-Core transformers have silicon steel cores with two matched bobbins on each side that cancel each other's magnetic flux field, so countermeasures to reduce leakage flux are not needed. Transformers are 30% smaller, 30% thinner and 40% lighter than EI type transformers. Applications include office, A/V, CATV, and electronic equipment. Sizes are available from 5VA to 1000VA.

Shielded Connector minimizes electrical interference.

Micro-Link connector has 360Ã-

Saving Energy with Efficient Belt Drives

By introducing energy efficient belts on electric motor drives, you can implement a simple, cost-effective solution to achieve energy savings in your facility.

Tough Pushbuttons resist vandals and the environment.

Series 76-95 sealed pushbutton switches are made of stainless steel with vandal-resistant chrome button and bezel. Button only protrudes 0.10 in. from front panel, making it difficult for vandals to pry switch from its mounting. Switches can also withstand impacts of significant force. Snap-in switch elements are UL listed and CSA certified, have silver or gold contacts with current-carrying...

Direct Drive Motor comes in two parts.

Brushless ULT frameless motor has separate rotor and stator that can be integrated into precision mechanical assemblies. Low profile motor has axial lengths as small as 10 mm, diameters up to 165 mm, and through holes up to 120 mm, making it suitable for direct drive rotary applications. Models are available with 30 to 600 oz-in of torque output. Its three phase motor will run on any sinusoidal...

Level Switch uses tuning fork sensor.

LZ10 Tuning Fork Level Switch vibrates at nominal frequency of 400 Hz. As switch becomes immersed in liquid or slurry, corresponding frequency shift occurs. When measured frequency shift reaches setpoint value, switch changes state indicating presence of liquid or solid medium. It is suitable for liquid applications with light to medium coating or scaling-type characteristics, or lightweight...

Pushbutton Switches provide security in harsh environments.

AV series pushbutton switches are suitable for applications where control panels are in high traffic or unsupervised locations, such as process control panels. Each has metal bezel with low profile shape that prevents attempts to remove switch from front of panel, anti-jamming construction, reduced actuator travel to prevent insertion of foreign parts, and solid mechanical stop inside metal bezel...

Fuse Covers retrofit most installations up to 100 A.

SAMI covers protect terminals and contacts against accidental contact by maintenance personnel. They comply with NFPA70E Standard for Electrical Safety Requirements for Employee Workplaces. Covers are available for Class J, RKI, RK5, H, K5, CC, G (0-30A), Class T (600 volt, 0-60A, non-indicating only) and Midget fuses. Voltage ratings include non-indicating 0-600 volt ac/dc and indicating 90-600...

Stacked D-SUB has three mounting options.

PC99-colored D-SUB with plastic bracket is used with motherboards using ATX or Micro ATX configurations. It is available with parallel port atop two serial ports or one serial port and one VGA connector. It is also available with parallel port atop single serial port, which can be either left or right aligned. D-SUB is made of UL 94V-0 rated PBT thermoplastic; contact material is phosphor bronze...

Acoustic and Thermal Solutions for Original Equipment Manufacturers

Technicon's products solve the most complex noise pollution and thermal problems and improve product marketability. Check out the video to learn more.