Materials & Material Processing

Materials & Material Processing

Replacement Gauge Glass is available in 2 configurations.

Nov 08, 2001

Replacement borosilicate gauge glass is available in sizes from 1 to 9 in transparent and reflex configurations. High-pressure gauge glass, with flatness tolerance of 0.002 in., is also available. Transparent gauge glass lets light pass through and makes liquid level visible. For fluids that are erosive or corrosive to borosilicate glass, protective shields can be incorporated. Reflex glass uses... Read More

Materials & Material Processing

Solder Paste produces consistent joints without cleaning.

Nov 08, 2001

SolderPlus No Clean solder paste prepackaged alloy/flux blend is formulated for controlled application by automatic dispensing equipment. It provides control and speed in production soldering processes by producing consistent solder deposits without needing to remove flux residue. This tacky paste is suitable for electronic, electromechanical and telecommunications applications. Read More

Automatic ID, Materials & Material Processing

Laminates prevent ID card counterfeiting.

Nov 08, 2001

DuraGard® registered OVD (Optically Variable Device) laminates provide security through high-resolution, computer-generated holographic imagery that cannot be copied or reproduced with conventional scanning and printing systems. They provide tamper-evidence that reveals any attempt at alteration or forgery. Read More

Materials & Material Processing

Brass-on-Brass Wire for use with wire-cut EDM machine.

Nov 08, 2001

Deltacut 2 wires have layer of 65% zinc-enriched, gamma-phase brass on wire's surface. This layer has a high melting point with tenacity. High zinc content improves cutting performance and produces better surface finish at same cutting speed as brass. It can be substituted for brass wire, at same machine settings, for an 8 to 15% performance improvement. Better performance can be achieved by... Read More

Materials & Material Processing

Fluorothermoplastics insulate wires and cables.

Nov 08, 2001

FEP 6322 and PFA X 6525 high-performance fluorothermoplastics have good melt flow index, allowing high processing speeds for wire and cable jacketing. Both enable very thin walls of up to 100 µm, are resistant to chemicals and are nonflammable. Cables insulated with fluorothermoplastic meet requirements of standards VDE 0207, Part 6 and CEI 20-51. Service temperature range is up to 205°C... Read More

Materials & Material Processing

Elastomers withstand basic and amine environments.

Nov 08, 2001

Models BRE 713 IX, BRE 7132X, BRE 723 IX and BRE 7410X base-resistant elastomers are formulated to withstand conditions found in basic and amine-containing environments, most notably those involving lubricating fluids in the automotive industry such as molding gaskets, seals and O-rings. They resist amine packages found in ATF fluids, gear lubricants, engine oils and other fluids while offering... Read More

Materials & Material Processing

Curable Elastomer offers alternative to RTV silicones.

Nov 08, 2001

UV curable UV21 elastomer compound offers fast-curing alternative to conventional moisture-curing silicone materials for use in seals, gaskets, bonding and protective coatings. It resists chemicals, has good electrical insulation properties, and is not affected by exposure to moisture and other hostile environmental conditions. It adheres to many plastics, including polycarbonates and acrylics,... Read More