New Electrical Equipment & Systems Products

High Speed Interfaces offer guide post option.

Series QTE/QSE-GP .8 mm pitch interfaces use Guide Post to accurately align connector when mating. They are rated for use up to 2.33 GHz, depending on application and interface. Mounting configurations allow for traditional parallel board stacking, and perpendicular mating of boards such as in daughtercard applications and horizontal (coplanar) type applications. Interfaces are suitable for...

DC-DC Converter provides 88% efficiency.

Dual-output, quarter-brick Series ALQ15 offers output voltages of 3.3/2.5, 3.3/1.8, and 2.5/1.5 V. Rated to deliver up to 15 A from either output, series provides a full 60 W of clean, regulated, low-noise DC power. Unit can start up into high-capacitance loads of up to 10,000 microFarads per output. Features include over-temperature, over-current, and over-voltage protection. Input voltage range...

Linear Motors suit medical and scanning applications.

Miniaturized ThrustTube Micro motor modules can be combined to create miniature x - y platforms. Motor block weighs 76 g and is constructed from polymer and epoxy to achieve accelerations of 30 G while retaining sub-micron positional accuracy. Use of polymers eliminates eddy currents in device, making motors able to achieve speeds of 10 m/sec. Modules are 60 mm wide x 48 mm high and up to 600 mm...

Capacitive Switch activates by light touch.

Momentary/latching Model CSE15 uG (Capacitive Switch Element under glass) is actuated by touch or by approaching surface. It offers adjustable sensitivity and point illumination in varying colors. Connecting illumination directly to switched output signal results in on/off feedback. Electronic parts are molded into plastic frame, impervious to dust, dirt, moisture, and heat. Switches can be...

Microcontrollers in Power Electronics

This white paper explores the power supply advantages of digital microcontrollers, as well as how digital power supplies can be used to manage entire systems.

Trapped-Key Locks fit on valves for added safety.

Valve Interlocks ensure safe sequence of steps is followed when operating hazardous process equipment. They eliminte operator error from process, pipeline, and maintenance operation. Insertion of key unlocks equipment from either open/on or closed/off position. Units are constructed from stainless steel and are lubricated for life. Interlocks are also offered for access guards, switches, tanker...

Four-Wire Connector and Plug have IP68 rating.

Model 4M20 Male Plug and 4F20 Female Connector provide complete protection against dust and allow for continuous submersion in up to 6 ft of water when capped or mated. Designed to eliminate GFI system problems, male plugs and female connectors are rated for 15 to 25 A at 600 V (max). Connectors are available molded to Type SOW-A Cable on No. 14 AWG rated 15 A, No. 12 AWG rated 20 A, and No. 10...

Cabinets house electrical controls and instruments.

Lockable telephone cabinets, with wood back panel, can also be used as wiring boxes, junction boxes, pull boxes, or communication cable terminations. Cabinets are available with surface or flush cover and removable trim. Continuous hinge holds cabinet door open up to 180Ã-

Lay-In Wireway provides efficient installation.

Made of 16 and 14 ga galvanized steel, Type 3R wireway consists of open-sided sections and fittings that provide access along entire wiring run. Self-connecting system offers quick-release cover latches for access to internal wires and cables. Complete selection of sections and fittings is available in 3 sizes: 4 x 4 in., 6 x 6 in., and 8 x 8 in. Wireway protects against rain, sleet, and snow, as...

Converters provide 95% efficiency.

Non-isolated, point-of-load (POL), 10 A DC/DC Series SIL10, for use with 3.3 and 5.0 V on-board bus levels, employs synchronous-buck topology, using fixed-frequency switching and low on-resistance MOSFETs. Power density is 107 W/in3. Fixed-output converter provides 8 voltages from 0.8 to 3.3 V, and accommodates input voltage of 3.0 to 5.5 V. Wide-output trim model requires 4.5 to 5.5 V input....

Cages and Connectors suit optical transceiver applications.

OptoCage(TM) SFP (Small Form-factor Pluggable) cages complement 20-pin connectors (MECT series). With one-piece design, EMI suppression characteristics, and rigid materials and construction, OptoCage ensures stability and retention force. SMT connectors and cages (including press-fit, PCI press-fit, and solder lead versions) are designed to exact SFP specification, making them compatible with all...

SpillVak Absorbs Up to 6X More Fluid Than Rock- and Clay-based Absorbents

Are you struggling to find an absorbent that doesn't result in at least some leaching? SpillVak outperforms all rock and clay-based materials. Check out our video to learn more.