New Sensors, Monitors & Transducers Products

Circuit Monitor provides power system surveys.

POWERLOGIC Series 4000 has sealed case design, allowing it to be transported to various locations within facility. Portable unit is suitable for temporary monitoring, or where existing switchgear will not accommodate permanent installation of circuit monitors. Base unit includes detachable display and necessary cables. Upgrade option adds high-speed transient-detection. Optional Ethernet...

Linear Actuator is available with encoder.

Size 17 hybrid linear actuator, with optical incremental encoder, is suitable for both high and low volume motion control applications. Encoder is offered in resolutions ranging from 50 to 1,024 counts, and is available with TTL level and quadrature outputs. It incorporates lensed LED light source and monolithic photodetector array with signal shaping electronics to produce 2-channel bounceless...

Pressure Transmitter suits semiconductor applications.

CE listed MB-4/20 Two-Wire Pressure Transmitter provides 4-20 mA output and has 1 x 1 in. square modular block pressure port fittings. It offers pressure ranges of vacuum to 10,000 psi (gage or absolute), high burst pressure of 10x full scale, and overall accuracy of Ã-

Pressure Transducer is based on silicon technology.

Model DCT combines pressure sensing with stainless steel construction, which allows it to operate under extreme environmental conditions. It is available in pressure ranges from 6 to 500 psi, and is fully digitally compensated for effects of pressure and temperature changes. Transducer accepts unregulated and regulated excitation voltages, and provides output signals such as 1-5Vdc, 1-6Vdc,...

Adhesive Tapes for Personal Protective Equipment Applications

This ebook provides an in-depth overview into adhesive tapes for personal equipment applications.

Tactile Sensor System conforms to complex-shaped objects.

Model T-2000 tactile sensor system is based on PPS-proprietary TactArray technology, employing capacitive pressure sensors that continuously deliver accurate data after 1, initial calibration. One T-2000 can be configured with 16 to 256 sensor elements in array sizes up to almost 6 sq in. System specifications include full scale ranges of 3, 12, or 30 PSI, 0.15% static noise, and 1.0%...

Linear Encoder is accurate over 100 mm stroke.

Long Stroke encoder has accuracy better than 1 micron with resolution of 0.05 micron. Signals from probe interface electronics are digital and easy to interface with PC/PLC or digital readouts. Unit is CE marked comes with calibration certificate in mm or inches. Applications include industrial and scientific tasks.

Encoder/Resolvers provide range of output types.

Snaptrak Series absolute encoder/resolvers are shaft angle position sensors that provide BCD, Binary, Greycode, Incremental, +5V TTL or 24 Volt Logic type outputs. DC Snaptrak Series provides +/-10 Vdc, 0-10 and 4-20 mA current loop outputs proportionate to absolute shaft angle. Encoder/resolvers are available in heavy duty NEMA 12 and flange mounted versions. Six wire cable is over 1000 ft long...

Smoke Detector works in hostile environments.

HARSH(TM) provides smoke detection in dirty and wet surroundings. It eliminates nuisance alarms by using small air intake fan to draw air and smoke into photoelectric sensing chamber. Micro-pore filter removes unwanted airborne particulates and water mist, while its housing protects detection chamber and electronics. Features include two 25 Micron filters, intelligent analog communication for fan...

Current Monitor offers sensitivity of 1 V/A.

By placing monitor around current carrying conductor, Model CM-100-6L measures AC and pulsed currents. 3dB bandwidth extends from 10 Hz to 30 MHz, and maximum allowable saturation value is 0.15 As. Electrostatically shielded, Model CM-100-6L provides output voltage equal to current times sensitivity, which can be read on voltmeter or oscilloscope. Device is doughnut shaped with ID of 1.6 in., OD...

String Encoders suit machine control applications.

Series D60, D61, and D62 digital-output position transducers offer measurement ranges up to 43.13 in. They have line driver quadrature output with index lines and standard resolutions up to 3598 pulses per in., -20Ã-

Ensure Safety, Reliability in Your Cement Plant with Aerzen Blowers and Compressors

Aerzen offers blowers and compressors for challenging cement applications such as pneumatic conveying from raw mill to raw meal silos, combustion air, cement silos fluidization, and more. At Aerzen, safety is our top priority. Check out our video to learn more.