Materials

Magnetic Bar attaches to broom frame.
Magnets

Magnetic Bar attaches to broom frame.

Heavy-duty magnetic bar attachment picks up nails, screws, steel shards, and other metal refuse, increasing job-site safety while reducing tire damage on service vehicles. Mounted in aluminum casing, magnet comes in 48, 60, and 72 in. lengths. It can pick up debris from as high as 5 in. from road or floor surface. Magnet assembly fastens to SweepEx broom frame and hangs in front of bristles using...

Read More »
Optical Domes provide environmental protection.
Domes

Optical Domes provide environmental protection.

Sapphire Optical Domes offer angles to 160° that protect and extend viewing angle of electronic detectors and sensors exposed to moving particles. They transmit from UV to IR and provide up to 85% transmission uncoated and up to 99% with A/R coatings on 2 sides. Domes are made to specification in sizes up to 4 in. OD and exhibit Moh 9 surface hardness, with

Read More »
Media

Coalescing Media saves compressor oil.

Formix(TM) media causes small drops of oil from compressor air stream to coalesce and collect in common area. Once oil is collected, it is then re-injected back into compressor. Media is available in variety of shapes and configurations for air/oil separators for industrial compressors. Separators using Formix media use less energy and take up less space than traditional pleated or wrapped...

Read More »
Blackening Agent is a low-heat liquid.
Blacking

Blackening Agent is a low-heat liquid.

PX-5-L single-component liquid blackening agent works on martensitic, ferritic, austenitic, and duplex stainless steels, plus cast and malleable irons. It has low boiling temperature of 250 to 260°F, and is operated in 7 stages: heated alkaline cleaner, cold water rinse, acid activation, cold water rinse, 10-15 min. of immersion in blackening bath, cold water rinse, and oil. It meets...

Read More »
Epoxies

Epoxy Compound features one to one mixing ratio.

Type 20-3650 electronic grade epoxy potting, casting, and encapsulating system exhibits excellent physical, thermal, and electrical insulation properties. Tensile strength is 11,000 psi and compressive strength is 15,500 psi. Compound is DOT non-hazardous, easy to mix, and will cure at room temperature or with mild heat. Operating temperature range is -60 to +150°C. Type 20-3650 is suitable...

Read More »
Tiny Plastic Balls replace steel stampings.
Balls

Tiny Plastic Balls replace steel stampings.

With 1/16 in. dia, plastic balls are manufactured to precision of ±.001 in. dia tolerance with .001 in. sphericity to ensure uniform size, positioning, and feel of Braille-based sign letters. Plastic balls, engineered of acrylic for stiffness and impact strength, improve legibility for control over size, shape, height, and placement of each raised dot. They are available in smooth and...

Read More »
Bactericide/Fungicide suits metalworking applications.
Fungicides

Bactericide/Fungicide suits metalworking applications.

Triadine® 20 microbiostat, available in 16 oz and 1 gal sizes, is formulated as fast acting sump side additive that eliminates microbes and offers protection against odors, clogged filters, and fluid breakdown. Used for bacteria and fungus, it is EPA registered and suitable for use in cutting, cooling, and lubricating fluids. Triadine 20 eliminates need for separate antibacterial and fungal...

Read More »
1553 Interface Cards fit PC/104 format.
Cards

1553 Interface Cards fit PC/104 format.

BU-65567/68 data bus interface cards for MIL-STD-1553 are suitable for military avionics and ground-vehicle applications. Both cards are supported by free software, including C library and drivers for DOS and VxWorks, which eliminate need for most low-level programming. BU-65568 has 4 dual-redundant bus controller/remote terminal/monitor (BC/RT/MT) channels. Both are 16-bit convection-cooled...

Read More »
Thermal Film suits digital print market.
Laminates

Thermal Film suits digital print market.

SuperStick(TM) thermal film allows for successful thermal lamination of digital prints with high toner levels or fuser oil. It laminates at temperatures between 230° and 290° with minimal tension and pressure adjustments. SuperStick wets out smoother and clearer, and improves overall appearance and clarity of prints. It is available on several thicknesses and finishes of Nylon and...

Read More »
EDM Wire has paraffin-free surface.
Mechanical Wire, Cable and Rope

EDM Wire has paraffin-free surface.

MEGACUT® grip brass wire, with composition of 63/37Zn, has tensile strength of 900 N/mmÂ-², for part straightness and accurate geometry. Physical straightness and paraffin-free surface provide reliable automatic threading and smooth unwinding in Japanese wire machines. Wires are available on conventional spools, or 12-sided, non-rolling bedra® spool.

Read More »

All Topics