Logic Controller offers DeviceNet(TM) Master capability.
With DeviceNet Master Module, GLC2000 series all-in-one HMI and logic controller is compatible with DeviceNet I/O network. Once module is installed, off-line menus can be used to configure slave's MAC address and baud rate. Module supports Polled, Bit-Strobe, Change of State, and Cyclic connection types as well as up to 63 slaves with up to 48 words or bits on each. Series comes with built-in...
Read More »Power Controllers provide power supply tracking and sequencing.
Models MIC2584 and MIC2585 are dual-channel, hot swap power controllers available in 16-pin and 24-pin TSSOP packages, respectively. They operate from system supply voltages from 1.0-13.2 V with input surge protection up to 20 V. Model MIC2584's default output voltage mode is tracking, whereas Model MIC2585 can be configured for output voltage tracking or staggered-mode operation. Both devices...
Read More »Profiler offers programmable stylus profiling.
DektakÃ-® 8 Advanced Development Profiler, with Low-Inertia Sensor 3 head, provides accurate characterization of MEMS, semiconductors, data storage devices, and other surfaces. It offers dual camera optics; 7.5 angstrom, 1 sigma step height repeatability; and vertical range of up to 1 mm. Overhead gantry allows for long scan roughness, planarity, and flatness measurements on samples up to 200...
Read More »
LDO Integrated Circuits provide power management.
Models MIC2213 and MIC2214 each consist of 2 low-dropout regulators, power-on reset supervisor, and open-drain driver with adjustable delay time. First regulator can source 150 mA of current, while second regulator can source 300 mA. Total current consumption is 48 Ã-µA. Suitable for portable applications, units are housed in 3 x 3 mm MicroLead Frame(TM) leadless package. They feature low...
Read More »
A Guide to Robotic Cells in Automation: Electronics & Auto Parts
This white paper provides an overview into robotic cells in automation electronics and auto parts.
Read More »
Multifunction Grip Handle suits off-road applications.
Model MFGS3 can incorporate 5 momentary switches and 2 optional rockers. Complete assembly consists of housing, cable, and switches with PCB. It achieves resistance to ingress of dust and water according to IP65, and connecting cables are contained inside internal tube. Handle includes soft-touch over-molding and adjustable palm-rest. Due to symmetrical design, grip can be used by left- and...
Read More »
Positive Hot Swap(TM) Controller offers open circuit detection.
Model LT4254 allows boards with supplies from 10.8-36 V to be safely inserted into live backplane without risking damage to connectors or causing glitches. IC provides open circuit detect output that indicates abnormally low load current conditions or no load presence, while adjustable current limit is programmable through sense resistor. Product also offers foldback current limiting Power Good...
Read More »Buck Regulator is offered in 10-pin DFN package.
Model SP6655, offered in Dual Fine pitch No lead package, occupies 3 mmÃ-² of board space and has 0.8 V internal reference that is stable with ceramic capacitors. Proprietary architecture allows 100% duty cycle operation and includes internal synchronous 0.3 ohm switches. With minimum output current of 400 mA, product operates from input voltages of 2.7-5.5 V, consumes 20 Ã-µA of...
Read More »
Signal Sources reduce baseband design iterations.
Baseband Studio N5115A provides digitally integrated single- and dual-channel fading simulation of baseband signals generated by ESG. Model N5110A allows long waveform files residing on PC hard drive to be streamed to ESG or PSG vector signal generator. Model N5101A PCI card enables fading and waveform streaming software applications. Model N5102A digital signal interface module allows ESG and...
Read More »
Digital Pressure Controller calibrates low-pressure gauges.
Model 7250LP incorporates 0-10 in. H2O range and 0-30 in. H2O range into one instrument and maintains set-point pressure to within Ã-
Read More »
Electronic Braking System suits industrial applications.
BraketronicÃ-® Controller utilizes solid-state drive technology to provide variable torque control to industrial shoe and disc brakes. Product enables single or multiple brakes to be proportionally controlled by foot pedal, master switch, or radio as well as selectively by aforementioned means. Controller may also be configured to gradually apply brakes by pre-programmed ramping, initiated by...
Read More »
Optimize Your Workforce with Weavix™ by PK Industrial
The Weavix™ platform takes productivity, quality, and visibility to a new level by providing better communication and real-time KPIs. Check out the video to learn more!
Read More »
