Fairchild Semiconductor Corp.
San Jose, CA 95134
Share:
MOSFET saves space in battery-management applications.
Model FDZ299P P-channel MOSFET, with PowerTrench-® technology, is housed in 1.5 x 1.5 mm BGA package. It reduces parasitic system power drain by providing low-loss switching with max steady-state current of 4.6 A. RDS(on) at 4.5 V Vgs is 55 mOhm, and 80 mOhm at 2.5 V Vgs. Package height of 0.8 mm fits under RF shields and internal subassemblies and displays. Applications include cell phones,...
Read More »
CMOS Amplifiers suit low power applications.
Models LMV321, LMV358, and LMV324 are single, dual, and quad amplifiers, respectively. They consume supply current of 120 microamps max at 2.7 V and typically 100 microamps at 5 V. Units provide rail-to-rail output and offer supply voltage of 2.5-5.5 V. With gain bandwidth of 1.4 MHz at 5 V and slew rate of 1.5 V/microsecond at 5 V, amplifiers are suitable for portable applications such as...
Read More »
MOSFET combines SyncFET(TM) and FLMP technology.
Model FDS7066SN3, 30 V, 19 A, N-Channel MOSFET utilizes SO-8 Flip Leaded Molded Package (FLMP) and SyncFET(TM) silicon technology. With integrated titanium Schottky diode, product offers thermal resistance junction-to-case of 0.5 -°C/W and low RDS(on) of 4.5 mOhms typical at 10 Vgs. Suited for low-side switch used in synchronous-buck DC/DC converter applications, product offers respective Gate...
Read More »
Logic Level Translator provides low-noise buffered interface.
Available in leadless chip-scale packaging or 5-lead SC70, FXLP34 single-bit, dual-voltage translator buffer enables designers to mix and match different voltage levels, providing low-noise buffered interface between any 1.0-3.6 V logic state. Product utilizes 2 separate supply voltages to translate between logic voltages within 0.9-3.6 V range. Translation propagation delays vary according to...
Read More »
Dual Driver/Receiver comes in single TSSOP package.
LVDS Model FIN1049 provides high-speed control and data transfer and combines functionality of 2 single D/R devices in 16-lead, TSSOP package. With 400+ Mbps bandwidth, device provides low channel-to-channel and pulse skew of 350 ps max. Rail-to-rail, common-mode range accommodates LVPECL and LVCML logic signals, and power consumption of 90 mW (max) optimizes system power resources and protects...
Read More »
Infrared Switch suits limited space, non-contact switching.
QVE00033 phototransistor infrared transmissive switch with miniature infrared sidelookers is for non-contact switching in disk drives, card detectors, and controllers. Optical switch has temperature resistant black plastic housing and is 7.50 x 4.05 x 5.40 mm. GaAs LED faces silicon phototransistor across 2 mm gap with 0.4 mm aperture. Peak transmission wavelength is infrared at 940 nm and...
Read More »LED and LED Driver ICs simplify designs within displays.
Surface-mount QTLP6XX series low VF LEDs offer low voltage operation and narrow forward voltage range without requiring auxiliary circuitry. FAN56XX LED driver ICs accommodate architectures from serial and parallel to matrix configurations and use active matching techniques. Offered with built-in digital, analog, and PWM control, products allow LED current to be programmed with 1 external...
Read More »
Quad-Channel Transceiver offers built-in self-test via JTAG.
Suited for use as general-purpose physical layer device (PHY) for proprietary backplanes, model FIN7216-01 offers operating range of 100 Mbps to 1.36 Gbps, redundant serial I/O, and ESD protection. Rated 2.2 W, true Quad Gbps PHY alternate source can operate at lower power when unused functions are disabled. Product withstands up to 2 KV to protect against potential chip- and system-level...
Read More »PWM Controller meets IEA 1-W initiative.
Model FAN7601 programmable frequency, current mode PWM controller reduces standby power losses to below 1 W. With operating frequency up to 300 kHz and operating current of 4 mA max, unit is suitable for off-line switch-mode power supply and DC/DC conversion applications. Controller includes programmable 20 mS soft start and start-up switch, overvoltage protection, thermal shutdown, and under...
Read More »
Analog Switch replaces two SPDT switches.
Model FSA3357 single pole/triple throw CMOS analog switch features RDS(on) of 6 Ohms, resulting in minimal signal attenuation. Total harmonic distortion of 0.01% coupled with 60 dB crosstalk ensures signal integrity. Wide bandwidth of 250 MHz and rail-to-rail signal handling guarantees clip-free transfer of analog and digital signals. VCC range of 1.65-5.5 V makes device suitable for battery...
Read More »