New Power Supplies Products

DC/DC Converters provide isolated output.

Series 5E 25/30 W DC/DC converters feature pi-input filter and 2:1 input voltage ranges of 9-18, 18-36, and 36-72 Vdc. Regulated, low ripple, single, dual, and triple outputs are available. CMOS/TTL-compatible, remote on/off control allows output to be put into powered down, stand-by mode. Single-output converters have external Output Trim that allows output voltage to be set within Ã-

Power Supplies suit bus-networking applications.

FieldLinkÃ-® Power Supplies are available in models designed specifically for AS-interface, Foundation Fieldbus, DeviceNet, Modbus, and Profibus PA and DP. Solid-state circuitry limits current output under overload or short-circuit conditions and restricts power to 100 W. Potential damage to networking components is eliminated. Units are DIN rail mounted and comply with requirements for Class...

DC-DC Converters offer current sharing/parallel operation.

Series T1UDC single output, 600 W converters feature output voltages of 3.3, 5, 12, 24, and 48 V. Inputs range from 22-32 Vdc or 42-56 Vdc. Units include remote turn-on/turn-off, Ã-

POL Converter delivers up to 80 A at 0.9-1.8 Vdc.

VÃ-·I Chip Voltage Transformation Module, Model V048K015T80 achieves response time of less than 1 Ã-µs and delivers up to 80 A while converting 48 V to 1.5 V. It has 1 MHz bandwidth and can provide bi-directional power flow with load. Depending on output regulation needs of application, unit can be operated open- or closed-loop. It meets demands of DSP, FPGA, ASIC, processor cores, and...

Ergonomics Is Good Economics

While you don't need an MD to know that ergonomic designs are good for physical health, you probably didn't realize that these designs can actually be good for your economic health too.

DC-AC Inverter powers 2-lamp LCD modules.

Series SE2 fully vacuum-encapsulated, PC-mountable DC-AC inverter is less than 0.420 in. high and 0.75 in. wide x 2.98 in. long. It is resistant to harsh environments, including shock, vibration, and humidity. Unit provides up to 5 W of output power and features external pulse width modulation dimming. It is suitable for virtually any product employing LCD powered by 2 single cold cathode...

Switching Power Supplies support signal-interface line.

Series PS5R offers 6 models to accommodate power requirements from 12.5-240 W with 5, 12, or 24 Vdc output for driving company's signal conditioners and distributed I/O modules. Input voltages are 85-264 Vac and 105-370 Vdc compatible. Terminal design facilitates installation. User inserts wire into opening on side of power supply, and pushes down finger-safe terminal screws while tightening....

DC/DC Converter delivers 250 mA/channel without inductors.

Model LTC3252 spread spectrum, step-down DC/DC converter can deliver 250 mA continuous output to 2 separate channels. It operates from 2.7-5.5 V, making it suitable for single cell Li-Ion or multi-cell NiMH/Alkaline applications. Both outputs are resistor programmable from 0.9-1.6 V. Switched capacitor fractional conversion enables it to attain efficiencies as high as 88%. Switching frequency...

POL DC/DC Converters deliver 28 Amps.

Series LEN non-isolated, point-of-load DC/DC converters accept 12 V Ã-

AC/DC Switching Power Supply is fully enclosed.

Active power factor corrected Series SP500 provides output power of 500 W, 85-265 Vac universal input, and single outputs from 12-48 Vdc. Series offers soft-start circuitry with integral EMI filtering and includes power-good LED indicator, output adjustment potentiometer, and 0 to +40Ã-

DC Power Supplies suit bench-top laboratory applications.

Models 1665, 1666, and 1667 compact, switching, power supplies utilize 115 Vac outlet as power source and provide continuous operation up to 200 W. Products provide max current output continuously with minimal thermal drift and offer fine output voltage and current limiting controls. Equipped with front panel mounted 3Ã-½ digit LED, units are offered with voltage output range from 1-20, 1-40,...

Tekna Manufacturing LLC Announces NFPA 99 Compliant Model 7200 Multiplace Chamber

Tekna is a leader in Monoplace and Multiplace Hyperbaric Chambers for Hyperbaric Oxygen Therapy (HBOT), offering products that set the standard for quality and innovation. Our new 7200 series of multiplace chambers is a state-of-the-art system that integrates advanced engineering with a plethora of features and options making it the industry's premier HBOT system. To learn more, see our video.