DME Company LLC

D-M-E Internal Latch Locks Refine Ejection Process for High Volume Molding
Fasteners & Hardware

D-M-E Internal Latch Locks Refine Ejection Process for High Volume Molding

Madison Heights, Mich. - D-M-E Company will be exhibiting its line of Internal Latch Locks at NPE 2009 in its West Hall Booth #103000. This technology was designed to ensure mold plates are positioned consistently and precisely during processing for applications using stripper plate ejection. Stripper plates are most often found in high-cavitation, high-speed applications such as caps and...

Read More »
Mold Counter monitors mold operation and validates data.
Test & Measurement

Mold Counter monitors mold operation and validates data.

Using non-resettable, mechanical, 7-digit counter, CounterView records accurate number of mold cycles, and relies on sensor that detects when mold has closed. Each mold cycle triggers display to increase or decrease counting mechanism based on user preference. CounterView also validates process monitoring data and assists mold maintenance procedures. Operating to 250°F, product is available...

Read More »
Micromolding Solution offers application flexibility.
Machinery & Machining Tools

Micromolding Solution offers application flexibility.

Along with conductive tip design and precise heat profiling, Stellar 5000 series has solid titanium point gate retainer that optimizes heat isolation and shielded mini-coil heater that hastens heat transfer for commodity-grade materials. Embedded brass heater is available for use with engineering-grade materials, and thru-hole tip sub-assembly maximizes wear resistance. Round and rectangular...

Read More »
Material Processing

Hot Runner Systems enable molding of multi-cavity parts.

Suitable for applications where volume of melt can differ, Polivalve Valve Gate Hot Runner Systems enable injection flow in simultaneous or sequential filling to create parts with unusual or complex, hard-to-fill geometries. Users can also mold multiple parts of different shapes and sizes in one cycle. Low-shear flow and uniform melt temperature control provide optimized surface quality, free of...

Read More »
Interlocks feature interchangeable inserts.
Construction Equipment and Supplies

Interlocks feature interchangeable inserts.

Providing accurate alignment of plastic mold halves, Series IN2(TM) INovative INterlocks utilize interchangeable inserts, eliminating need to replace entire side interlock set during maintenance. Graphitic steel inserts are held in place with interference-fit design that retains them when interlocks are installed on mold. There are no coatings, which could peel away under severe conditions.

Read More »
Hot Runner System suits micromolding applications.
Material Processing

Hot Runner System suits micromolding applications.

Designed for mold bases with tight center-to-center distances, externally-heated Stellar(TM) Hot Runner System works well with commodity and engineering grade resins in high-cavitation applications. Nozzles feature front-loaded design for tips, heaters, and thermocouples. Modular nozzle bodies are interchangeable and can be attached to manifold by threaded or compression connections. Multi-nozzle...

Read More »
Two-Stage Ejectors offer cut-to-length adaptability.
Fluid & Gas Flow Equipment

Two-Stage Ejectors offer cut-to-length adaptability.

Hardened-Steel, Two-Stage Ejectors offer Bottom Last and Top Last styles in 20, 26, and 32 mm diameters. They control sequence of movement of 2 sets of ejector plate assemblies inside mold's ejector box. Both first stage and second stage strokes can be set independently. Once ejector system is installed, fixed strokes cannot be tampered with or accidentally modified. Latching mechanism eases...

Read More »

All Topics