New Multimeters Products

Electrical Kit meets contractor's everyday needs.

Electrical Kit TK-30 is comprised of DM-20 manual ranging multimeter, GT-11 voltage detector, and GT-10 polarity cube. Model DM-20 measures current of small electronic circuits, ac/dc voltage, dc amperage, resistance, and also checks 9 V batteries. Offering non-contact voltage detection, Model GT-11 provides LED and audible alarm if voltage is present. Model GT-10 troubleshoots 120 Vac grounded...

Digital Multimeters feature single probe detection.

Comprised of 4 auto-ranging TRMS and averaging multimeters, DM-300 series carries UL safety ratings of Category IV 600V and Category III 1000V. All models offer non-contact detection and can measure ac and dc voltage, check diodes, and verify continuity. Models DM-310, DM-330 and DM-350 multimeters are capable of measuring ac and dc current and capacitance and have input error warning. Model...

Hydraulic Multimeters offer flow ranges of 100 or 200 gpm.

Series DHM provides digital readout of pressure, peak pressure, volumetric efficiency, and hydraulic horsepower in addition to flow rate and fluid temperature. Two models are offered with peak pressure to 9,000 psi and temperature to 250Ã-

Test Tools combine insulation tester and multimeter.

Insulation Multimeter Models 1587 and 1577 combine 1 kV digital insulation tester with full-featured true-rms digital multimeter in single, handheld device that fits in toolbox or on tool belt. Model 1587 provides insulation resistance testing up to 2 GW with 5 output voltages from 50-1,000 V, while Model 1577 tests up to 600 MW of resistance with 500 or 1,000 V. Insulation testing is disabled if...

The Ultimate Guide To Hydra Pneumatic and Servo Cylinders

This white paper provides a guide to hydra pneumatic and servo cylinders.

Digital Multimeter measures 4.9 x 2.4 x .9 in.

With built-in leads that store snugly behind built-in test stand, PocketPro(TM) fits inside pants or shirt pocket. Three buttons and thumb switch allow electrician to select between continuity/resistance, diode, and ac/dc voltage testing, as well as cycle through test ranges and hold measurement. Unit includes 3.5 digit LCD screen, overload protection on all ranges, audible continuity, low...

Multimeter employs AutoTect(TM) and automatic backlight.

Clamp-type Model AC71 measures ac/dc volts, resistance, and continuity. AutoTect senses what type of measurement is being made when test leads are placed across measurement point. With no knob to turn, meter displays measured value along with associated unit icon. AutoTect employs lower input impedance to help determine ghost voltage or hard connection. Backlight sensor recognizes if ambient...

Process Multimeter features portable functionality.

Designed for use with webs as narrow as one strand, Spectrum 4 checks and stores speed as well as stretch and shrinkage from roll to roll. Unit can download up to 100 data points to PC, revealing speed to 0.1 yd/min and stretch or shrinkage to 0.1%. Usable for spot checks at critical places or regular QC audits, meter is available with multiple optional contact and non-contact sensors, which it...

Multimeter offers dc reading rates of 7 S/s at 7-½ digits.

Featuring 7Ã-½-digit DMM and 1.8 MS/s isolated digitizer, PXI-4071 FlexDMM uses solid-state current shunt configuration that offers 8 dc current ranges from 1 Ã-µA to 3 A and 6 ac rms current ranges from 100 Ã-µA to 3 A. Multifunction device measures voltage from Ã-

Digital Multimeters provide 24,000,000 counts dynamic range.

With true 7Ã-½-digit accuracies, Model SMX2064 PXI/cPCI DMM offers measurement rates up to 20,000 readings/sec and dc current measurement down to 50 pA. Offering scope-like triggering, it provides 6-wire guarded resistance, inductance and capacitance measurements, frequency and timing measurements, thermocouple and RTD measurements; plus V and I sourcing. Model SMX2060 7Ã-½-digit DMM...

Digital Measuring Systems offer flexible configuration.

Multi-channel Spider8-01/55 and Spider8-01/30 measure force, displacement, pressure, and other suitable quantities using strain gages or inductive transducers in single housing. Product can measure temperatures using thermocouples or PT 100 or dc voltages and dc currents. Spider8-01/55 offers four 4.8 kHz carrier frequency amps, while Spider8-01/30 includes four 600 kHz carrier frequency amps....

Cut and Bevel Pipe up to 63" Diameter with a Single Lightweight, Portable Machine

CS Unitec is a leader in power tools designed for industrial applications, with products that set the standard for robust performance and industry-leading reliability. Adding to our long list of innovation is a new line of pipe cutting machines. For cutting and beveling pipe up to 2" in thickness and diameters from 12" to 63", no other cutting system comes close. See our video to learn more.