Aprima Medical Software, Inc
Carrollton, TX 75006
Share:
Machinery Adhesives lock and seal nuts and bolts.
Superlock adhesives provide positive locking and sealing on both active and inactive surfaces. Screw Lock Grade 2222 low-strength threadlocker is for spiral screws less than 1/4 in. diameter. Medium-strength Grade 2242 works on nuts, bolts, and screws with diameters up to 3/4 in. Grade 2262 high-strength formula controls torque/tension and clamp load on larger bolts and nuts in applications...
Read More »
Plug-in Transducers reduce installation time.
786 Series transducers can convert 0-10 V or 4-20 mA signals into isolated 0-10 V, 0-20 mA, or 4-20 mA signal with isolation rating of 4kV. It can be plugged directly onto terminal block assembly using base receptacle blocks that are 15, 20, or 25 mm wide. Modules are protected against mismating and can be replaced in single operation during maintenance without affecting wiring. Touchproof test...
Read More »
Nylon Plastic Hinges can replace steel hinges.
Available in countersunk thru hole, tapped insert, or threaded stud versions, these hinges can be substituted for metal hinges. Constructed from reinforced nylon plastic with black matte finish, they have stainless steel hinge pins. Tapped insert is made from brass, and threaded stud is steel and zinc-plated. Both are molded in.
Read More »
Lens Bonding Adhesives are optically clear.
Lens assembly adhesives for precision bonding, mounting, laminating, and fixturing applications have good adhesion to lens construction materials and to most metal, coated or painted frames and holders. Applications include cameras, microscopes, as well as eyeglass and sunglass lenses. Special UV blocking grades are available that adhere to PVA, CR-39, and CAP. These flexible lens bonders provide...
Read More »
Portable Blackbody certifies infrared thermometers.
Model 9133 is factory calibrated and NIST traceable to be accurate to Ã-
Read More »
Transformers operate at 90% efficiency,
High efficiency R-Core transformers have silicon steel cores with two matched bobbins on each side that cancel each other's magnetic flux field, so countermeasures to reduce leakage flux are not needed. Transformers are 30% smaller, 30% thinner and 40% lighter than EI type transformers. Applications include office, A/V, CATV, and electronic equipment. Sizes are available from 5VA to 1000VA.
Read More »
Diaphragm Valves withstand corrosive environments.
All-plastic diaphragm valves for 3, 4 and 6 in. pipelines are suitable for control of liquids, gases, and slurries in both on/off and modulating services. Each has handwheel that opens or closes valve with minimal effort. Plastic valves will never fail, jam, stick, or freeze in position because of rust or corrosion; will never contaminate sensitive process fluids; and never need to be painted or...
Read More »Waterjet Cutting Process cuts flat-stock materials.
Dynamic Waterjet(TM) features Active Tolerance Control(TM), where patented software models control articulated wrist cutting heads to automatically adjust cutting angles for specific accuracy and part tolerance requirements. It cuts metal, stone, or composite parts ranging from 0.050 to 6+ in. thick.
Read More »
Labeling System prints ultraviolet/visible barcodes.
Consumer-blinded labeling system orients, prints on, and visually inspects vials and bottles at speeds up to 500-600 vials per minute with 99.95% accuracy. System is designed to adapt to changes in vile size. Consumer-blinded labeling of two-dimensional ultraviolet/visible bar codes offers invisible tracking from manufacturing site to packaging site, elimination of extensive manual tracking...
Read More »