Aprima Medical Software, Inc
Carrollton, TX 75006
Share:
Back Pressure Regulators are designed for challenging applications.
Made from Advanced PE resin, Chem Proline-® Frank Series V86 exhibit resistance to chemicals and stress. Mechanical parts are isolated from media via EPDM diaphragm, and regulator itself is adjustable under working conditions. While offered in respective size ranges of ½–2 in. and ½–1 in., inline and angled configurations are both available with either butt/IR or socket...
Read More »
Radiometer measures very low powers down to 300 fW.
Integrating photodiode sensor and 18 Hz chopper,- Model RM9-PD measures power of very low level CW or quasi CW sources with response time of 3.6 sec. Sensor is calibrated over entire range of wavelengths, from 0.2–1.1 µm, rather than single wavelength. Featuring digitally synthesized lock-in amplifier that minimizes external noise, sensor can measure power levels from 300 fW to 300...
Read More »Smart Antenna reduces complexity of vehicle electronics.
Combining transceiver, tuner, and antenna in single unit, Smart Antenna links- range of services including radio, GPS, mobile communication, eCall, TV, and Car-to-X in one central point, outside of head unit. Design minimizes in-car distances traveled by analog HF signals between antenna and receiver, which optimizes signal quality. Direct signal processing and position on vehicle roof are...
Read More »Battery Chargers support lead acid and lithium-ion batteries.
Providing 900 and 1,200 W of DC output power, respectively, Models IC900 and IC1200 are available in 24, 36, and 48 V models suitable for use with electric and hybrid scissor lifts, boom lifts, and other aerial work platforms. Units are designed to withstand difficult operating conditions faced by construction and rental equipment. With IP66 rating, chargers are sealed against dirt and fluids....
Read More »
Buck-Boost Battery Charger supports USB Type-C connector.
Featuring 5–20 V input voltage capability,- ISL9237 Narrow VDC Battery Charger supports 2-way power delivery in ultrabooks, tablets, and power banks using reversible USB Type-C™ connector. Single-chip device is capable of providing buck-mode, buck-boost-mode, and boost-mode for 1-to-3 cell Li-ion batteries. It also supports USB On-The-Go with 5 Vout reverse buck-mode. R3™ modulation...
Read More »
USB-C Controller supports direct 3.3-20 V operation.
Based on 48 MHz ARM-® Cortex®-M0 processor, EZ-PD™ CCG3 Controller with Power Delivery integrates independent 20 V V(BUS) gate drivers for provider and consumer power paths, two 1 W V(CONN) Field-Effect Transistors that provide power to USB-C cables, and USB Billboard Controller that informs USB host of supported Alternate Modes and failures. Programmable single-chip device streamlines...
Read More »Blood Glucose Meter simplifies self-monitoring.
Featuring ColourSure™ technology, OneTouch Verio Flex™ shows arrow pointing to whether result is low (blue), within range (green), or high (red). Meter's ranges can be customized to each person's blood sugar target range, as recommended by their healthcare provider. Requiring just 0.4 -µl of blood which can be applied to either side of test strip, meter includes Bluetooth®...
Read More »PHY Control Processor supports baseband applications.
Featuring scalable VLIW/SIMD architecture, 128-bit SIMD,- and support for both fixed- and floating-point operations, CEVA-X unifies control and DSP processing for high-end smartphones, Machine-Type-Communication, and wireless connectivity. Multi-RAT multi-carrier device also includes dedicated 32-bit zero-latency ISA, 32-bit hardware division and multiplication, dynamic branch prediction, and...
Read More »USB UHF RFID Reader supports EPC Global Gen2 tags.
Based on Micro LTE UHF RFID module,- ThingMagic® USB Pro RFID Reader lets solution developers support applications that require desktop reading and writing of EPC Global Gen2 tags. Unit is controlled and powered by host PC or laptop via USB interface and supports autonomous operation. In addition to supporting effective data writing to high-memory tags, RAIN™-compatible unit can read...
Read More »Modular Channel Emulation Platform address 5G challenges.
Able to scale in field from 2–32 channels for wireless RF testing, Spirent Vertex addresses uses spanning basic RF device tests to complex MIMO beamforming base station antenna tests. Channel emulator, suited for those focusing on MIMO Beamforming, Carrier Aggregation, and MIMO OTA, simplifies complex test setups by minimizing required hardware, providing intuitive GUI optimized for usability,...
Read More »