Electronic Converters

Electronic Converters

DAC Modules allow engineers to customize ATE systems.

Model SMP3620 is high-density DAC with 24-channels/plug-in with programmable outputs from 0-35 Vdc, while SMP3625 provides 16 channels of 70 V peak-to-peak 400 Hz output. Interfacing to VXIbus, SMP7000 allows engineers to add custom circuits to system designs. All provide ability to mix and match signal switching and analog output and multiple functions can be accommodated in 1- or 2-slot...

Read More »
Protocol Converters provide high-speed character conversion.
Electronic Converters

Protocol Converters provide high-speed character conversion.

With serial character rates up to 3,000 characters/sec, SmartPipe(TM) USB-331 and USB-335 ASCII RS-232 to USB Keyboard Code Converters enable continuous stream of ASCII characters at 19,200 baud to be converted to USB keyboard codes. High rate is useful in barcode reader applications, which generate burst of continuous characters. Other applications include industrial control, PoS,...

Read More »
Electronic Converters

Stereo Audio IC suits portable multimedia applications.

Supplied in 5 x 5 mm, 32-pin QFN package, AT73C240 integrates 20-bit stereo DAC with 90 dB dynamic range and 1 W (max) audio power amp. Stereo DAC comprises multi-bit sigma-delta modulator with dither, continuous time analog filters, and analog output drive circuitry. Master clock is 256 or 384 times sampling frequency, allowing choice of input data rate up to 50 kHz. Also, stereo 32 ohm headset...

Read More »
Portable Fiber Converter has maximum rate of 500 Kbps.
Electronic Converters

Portable Fiber Converter has maximum rate of 500 Kbps.

Equipped with multiple serial interfaces, series GAO227 automatically detects serial signal baud rate which allows for continued transmission of signal through RS-485, RS-422, or RS-232 to fiber converter. Unit extends serial transmission distance up to 2 km on multi-mode fiber or up to 20 km on single-mode fiber. Converter features high isolation voltage, anti-electromagnetic interference, and...

Read More »
The Next Wave of Intelligent Design Automation
Sponsored

The Next Wave of Intelligent Design Automation

In the amount of time it takes to set up a meeting to discuss just one design, engineers can now explore designs exponentially. Generative design has catalyzed a paradigm shift in product development. This shift not only drastically decreases the time it takes to design a product. It also opens the door to design options that might never have been imagined by engineers on their own.

Read More »
Ethernet Media Converters meet IEEE 802.3 network standard.
Electronic Converters

Ethernet Media Converters meet IEEE 802.3 network standard.

Supporting both full- and half-duplex communication, Plug and Play Ethernet media converters are designed to convert data signals between 10/100 Base-Tx and 100 Base-Fx fast Ethernet. They are used as standalone unit or as slide-in module to converter rack or in central wiring closet. Converters come with built-in remote diagnostic capability and feature switch chip design, 512 Kb SSRAM buffer,...

Read More »
Electronic Converters

ADC PMC Module has 400 MHz sampling rate, 14-bit resolution.

Quad-channel ICS-1556B suits for applications where conversion of analog data into digital information in as close to real-time as possible is required. It can simplify VHF and some UHF radios by digitizing these spectra directly and allowing intermediate analog down conversion stages to be eliminated, all with minimal peripheral hardware. Along with 64-bit/133 MHz PCI-X® interface, module...

Read More »
ADCs integrate 2-10 ppm/°C reference.
Electronic Converters

ADCs integrate 2-10 ppm/°C reference.

Featuring internal 1.25 V reference, LTC2460 can measure single-ended input from 0-1.25 V, while LTC2462 can measure differential input up to ±1.25 V. Both offer 16-bit DC performance of 1LSB integral nonlinearity error, 2.2 Â-µVrms transition noise, and 0.25% maximum gain error. Drawing 2.5 mA supply current at 60 Hz maximum sample rate, they operate up to 60 conversions/sec for use...

Read More »
Electronic Converters

Analog-to-Digital Converters enable temperature measurement.

With data rate of 2 kSPS and 2.56 mW power dissipation, 24-bit Models ADS1248 and ADS1247 integrate dual matched current DACs, low drift internal reference, oscillator, temperature sensor, burnout detection, and 8 general purpose I/Os. Model ADS1248 features 4 differential/7 single-ended inputs, while Model ADS1247 provides 2 differential/3 single-ended inputs. Housed in TSSOP-20 package,...

Read More »
Ultrasonic Flowmeter Converter incorporates DSP technology.
Electronic Converters

Ultrasonic Flowmeter Converter incorporates DSP technology.

Housed in NEMA 3X enclosure to resist exposure to rain, Series PUX2 is paired with Series PSX2 sensors to utilize transit-time difference for measuring flow rates in pipes from outside. Portable unit is capable of 12 hours of continuous operation with built-in battery, which requires only 3 hours to recharge. Layout of function keys aids user with page selecting and setting changes, while...

Read More »
Electronic Converters

Dual-Channel ADCs consume 33-376 mW/ch.

Comprised of 18 pin-compatible, dual-channel ADCs with resolutions from 10-16 bits and speeds from 20-125 MSPS, AD92xxBCPZ series lets system engineers increase channel counts without increasing product's board area or power consumption. ADC cores use multi-stage, differential pipelined architecture with integrated output error-correction logic. Other features include programmable clock and data...

Read More »
Locon Sensors Withstand Extreme Temperatures
Sponsored

Locon Sensors Withstand Extreme Temperatures

Locon Sensor Systems offer robust sensor solutions for even the most severe environmental conditions. Their line of high-temp inductive sensors and their cylindrical photoelectric series can operate in temperatures up to 250 degrees Celsius. See our video to learn more.

Read More »

All Topics