Electronic Converters

Rack-Mount Converter turns SATA device into USB 3.1 storage.
Electronic Converters

Rack-Mount Converter turns SATA device into USB 3.1 storage.

Rack-mount SATA to USB 3.1 Converter turns any SATA device into SuperSpeed+ USB 3.1 storage solution. When connected to a USB 3.1 port, product enables delivery of up to 10 Gbps throughput. Backwards compatibility with previous USB standards enables any SATA hard drive, SSD, and optical drive to be converted into USB 3.1 storage. Also available, model with WRITE-PROTECT function includes all...

Read More »
Analog-to-Digital Converters integrate fault detection.
Electronic Converters

Analog-to-Digital Converters integrate fault detection.

Housed in 9.7 x 6.4 mm TSSOP, Models ADS1262/ADS1263 provide 32-bit resolution and low noise of 7 nV(RMS) at 2.5 SPS, enabling measurement of small signals, which is essential for bridge applications where typical full-scale signals are 10 mV or less. ADS1262 integrates programmable gain amplifier, 2.5 V reference, oscillator, level shifter, temperature sensor, dual-excitation current sources,...

Read More »
NBCUniversal Control of Satellite Amplifiers through Perle Industrial Switch and Media Converters
Electronic Converters

NBCUniversal Control of Satellite Amplifiers through Perle Industrial Switch and Media Converters

300ft Ethernet limitation ruled out simple cable run NASHVILLE, TNÂ- – Perle Systems, a manufacturer of advanced device networking hardware, reveals that NBCUniversal uses its Industrial Switch and Media Converter to enable network control of satellite amplifiers. NBCUniversal needed to extend its infrastructure beyond the boundaries of the office building and out to satellites which were...

Read More »
Electronic Converters

Power Conversion Systems have grid resilient design.

Delivering transformerless isolation, 125 kW power conversion system features Power Packet Switching Architecture™ (PPSA) and is scalable to greater than 1 MW for large-scale applications. This wall-mount, 425 lb unit offers bidirectional capability and AC/DC Ports in addition to 50/60 Hz compatibility, microgrid forming capabilities, and SunSpec-compliant interface. Also available, 125 lb 30...

Read More »
Analog-to-Digital Converter provides 8 channels at 2.6 GSPS.
Electronic Converters

Analog-to-Digital Converter provides 8 channels at 2.6 GSPS.

Based on Virtex-7 FPGA and 4-core PowerPC, Model ATC136 provides 10-bitÂ- at 2.6 GSPS performance and also has single DAC, 14-bit at 2.8 GSPS. Board is equipped with 64-bit DDR3 memory (4 Gb on FPGA and 4 GB on PowerPC) as well as Flash memory and removable MicroSD card. Front panel ports include 8 SMA, JTAG, dual RJ-45, Clock-In/Sync Out, and dual MicroUSB.

Read More »
MAZeT Amplifies Signals Delivered by Optoelectronic Sensors
Electronic Converters

MAZeT Amplifies Signals Delivered by Optoelectronic Sensors

Transimpedance Amplifiers and Current-to-Digital Converters Turn even Minute Signal Levels into Measurable Signals Quickly and Dynamically Jena, Germany –Â- Integrated signal amplifiers and converters from MAZeT GmbH, specialized in the development and custom production of embedded systems and optoelectronics, convert sensor signals from optical sensors in high resolution and for the...

Read More »
Next-Gen TX, RX, and Timing Modules by TRAK at IMS 2015
Electronic Converters

Next-Gen TX, RX, and Timing Modules by TRAK at IMS 2015

TRAK Microwave has chosen IMS 2015 in Phoenix to announce the availability of several new aerospace and SATCOM communication system subassemblies and precision network timing products. These new products demonstrate the latest size, weight, and performance (SWaP) requirements for integrated multi-function assemblies and synchronization in both civilian and military communications. Ku-Band Block...

Read More »
Electronic Converters

A/D Converters offer maximum sampling rate of 200 Msps.

Housed in 124-lead VTLA packages, Series MCP37DX0-200 and MCP372X0-200 feature 12- and 14-bit pipelined A/D converters with 67 dB SNR and over 96 dB SFDR. Converters operate at 338 mW including LVDS digital I/O for 12-bit devices and 348 mW for 14-bit devices. In addition to digital processing features, units include decimation filters for optimized SNR and phase, offset and gain adjustment. Data...

Read More »
ADCs and DVGA promote optimal wideband equipment performance.
Electronic Converters

ADCs and DVGA promote optimal wideband equipment performance.

Offering 2 channels in 10 x 10 mm package, 16-bit ADS54J60 offers traits — >70 dBFS SNR at 1 GSPS, -159 dBFS/Hz noise floor, 86 dBc SFDR — that promote spectral purity and enable finding of weak signals in presence of large, unwanted blockers. As 14-bit, 500 MSPS ADC, ADS54J54 offers 4 channels in 9 x 9 mm package. Both ADCs work together with 4.5 GHz LMH6401 fully differential digital...

Read More »
Inductance-to-Digital Converters offer 28-bit resolution.
Electronic Converters

Inductance-to-Digital Converters offer 28-bit resolution.

Offering 2 or 4 matched channelsÂ- in single IC, Series LDC1614 provides precise position and motion sensing in almost any environment. Multiple, well-matched channels enable differential and ratiometric measurements, allowing designers to compensate for environmental aging conditions. With up to 28-bit resolution, devices can detect submicron changes in distance. Converters are powered by...

Read More »
Fresh Air Intake Designed to Meet ASHRAE 62.2 standards
Sponsored

Fresh Air Intake Designed to Meet ASHRAE 62.2 standards

Alan Manufacturing has a long history of developing innovative solutions for HVAC applications. With over 1,000 product designs under our belt, we have gained a reputation as the go-to source for HVAC dampers, hardware, duct supports, zone control systems, and much more. Adding to this extensive list of achievements we now announce the release of our new line of Fresh Air Intake products. Designed to meet ASHRAE 62.2 standards, they are the most robust and high-performance product of their kind. See our video to learn more.

Read More »

All Topics