Controls and Controllers

I/O Controller enables USB 3.0 to SATA data transfer.

Single-chip VIA VL700 USB 3.0-SATA Controller allows users to connect SATA hard disk drive, solid state drive, and optical disc drive devices to PC via USB 3.0 specification ports. Product supports both SATA 3 Gbps and 1.5 Gbps data transfer rates as well as Native Command Queuing, which allows HDDs/SSDs to internally optimize order in which received read and write commands are executed. Data...

Read More »
Controls and Controllers

Networking Card bridges cell- and circuit-based networks.

Based on Wintegra(TM) WinPath2(TM) on-board network processor, iSPAN® 3650 AdvancedMC(TM) (AMC) Quad OC-3c/STM-1 ATM-IP Interworking Card can support 64,000 ATM PVCs (Permanent Virtual Circuits), 1 M/s AAL2 CPS packets, and 50,000 Active CIDs supported for AAL2 PVCs. When combined with Interworking application, it becomes integrated gateway on AMC designed to support OC-3c/STM-1 interfaces...

Read More »
Wireless MCU supports ZigBee PRO applications.
Controls and Controllers

Wireless MCU supports ZigBee PRO applications.

Model JN5148 wireless MCU is designed for wireless sensor networking applications based on IEEE802.15.4 standard. It includes 32-bit RISC processor, up to 32 MIPs performance, 2.4 GHz transceiver, 128 kB ROM, and 128 kB RAM to support networking protocol stack and user application on-chip. Unit integrates power management and has operating current consumption of 18 mA when receiving and 15 mA...

Read More »
Gas Management System offers fully automatic operation.
Controls and Controllers

Gas Management System offers fully automatic operation.

Featuring onboard web server and embedded software, IntelliSwitch II(TM) Gas Switchover allows remote monitoring, secure system configuration, and e-mail notification of real-time system status and events. System offers continuous pressure and flow control from liquid or high pressure cylinder sources. It includes NO/NC relay contacts for alarm outputs; internal, switch-settable input ac power...

Read More »
Electrical Regulators

Supply Voltage Regulator suits satellite STB applications.

Single-output LNB voltage regulator is designed for supplying power/control signals from satellite STBs to low-noise blocks of single antenna ports. Unit includes current-mode boost converter and low-noise linear regulator, as well as circuitry for tone injection and pin-controllable interface. Final regulated output voltage at cathode of back diode supports operation of antenna port for single...

Read More »
DMC-12x0 - PC/104 Optima Motion Controllers, 1-8 Axes
Controls and Controllers

DMC-12x0 - PC/104 Optima Motion Controllers, 1-8 Axes

For new applications, Galil recommends the new generation, Accelera series DMC-18x6 PCI controllers. The DMC-12x0 PC/104 bus motion controller is a member of the Optima Series, Galil's prior-generation, multi-axis motion controllers. Designed to fit in an embedded PC/104 system, the DMC-12x0 controller accommodates 1- through 8-axis formats and allows control of step or servo motors on any...

Read More »
DMC-18x0 - PCI Optima Motion Controllers, 1-8 Axes
Controls and Controllers

DMC-18x0 - PCI Optima Motion Controllers, 1-8 Axes

For new applications, Galil recommends the new generation, Accelera series DMC-18x6. The DMC-18x0 PCI motion controller is a member of the Optima Series, Galil's prior-generation, multi-axis motion controllers. The DMC-18x0 controller accommodates 1- through 8-axis formats and allows control of step or servo motors on any combination of axes. Any mode of motion can be programmed including linear...

Read More »
Electrical Regulators

Low Dropout Voltage Regulator IC utilizes CMOS technology.

Consuming 9.0 Â-µA during operation, S-11L10 Series features input voltage of 1.2-3.65 V and output voltage of 0.8-3.3 V, selectable in 0.05 V steps. Positive voltage regulator has built-in overcurrent protection circuit, power-off circuit, and discharge shunt function. Ceramic capacitor of 1.0 µF or more can be used as I/O capacitor. Available in SOT-23-5 and SNT-6A(H) packages, IC...

Read More »
Circuits

Battery Protection IC monitors 1-cell packs.

Featuring voltage detection circuit and delay circuit, S-8211E Series is suitable for monitoring overcharge and overdischarge of 1-cell lithium ion/lithium polymer secondary battery packs. Overcharge detection voltage ranges from 3.6-4.4 V with accuracy of ±25 mV at +25°C and ±30 mV from -5 to +55°C. Overdischarge detection voltage ranges from 2.0-3.0 V with ±50 mV...

Read More »
Controls and Controllers

Compressor Controller operates according to air demand.

Designed to monitor, control, and optimize compressed air system, FOCUS Controller uses pressure sensor to control whether requested pressure within compressor station has been achieved. User can preset min/max pressures and control operation according to demand. In addition to remote On/Off facility and local/remote control via key switch, controller includes backlit LCD that shows...

Read More »
Precision Machining Solutions with Over 25 Years of Experience
Sponsored

Precision Machining Solutions with Over 25 Years of Experience

Quality, customer service, and unbeatable value are the hallmarks of Hogge Precision. Since 1989 we have built a reputation as the go-to precision machining source, servicing many demanding industries. For CNC machining and screw machining, there are few manufacturers that can match our capabilities and expertise. See our video to learn more.

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers