Arc-Resistant Controller suits medium-voltage environments.
Controls and Controllers

Arc-Resistant Controller suits medium-voltage environments.

CENTERLINE ArcShield controller provides Type 2 arc-resistant protection for safety of personnel working in environments that require voltages from 2,300-7,200 V. Products are available in 18 in. incoming units and 400 A, one-high full-voltage non-reversing (FVNR) controllers. Safety features include arc vents on roof, sealed low-voltage panel, cabinet with 12-gauge steel sheets, and isolated...

Read More »
Electrical Regulators

Switching Regulator suits mobile phone applications.

Optimized for RF power amplifiers in 2.5G and 3G CDMA and W-CDMA mobile phones, 2 MHz PWM synchronous Model MIC2224 features 2.7-5.5 V input voltage with DAC-adjustable output from 0.3-3.6 V. By adjusting voltage applied to RF power amplifier, transmit power can be made to match environmental operating conditions. In PWM mode, MIC2224 supplies more than 600 mA of output current through fully...

Read More »
Controls and Controllers

Module interfaces between joystick and machine controls.

CL-407 module, configurable as slave module in CAN system, has 4 A available on outputs and 60 mA 5 Vdc regulated supply for providing power to external input devices. Features include 2 switch-to-battery or 8-bit analog inputs, three 0-5 Vdc 12-bit analog inputs, and 7 PWM or digital 4 A sourcing outputs. Module is housed in aluminum extrusion NEMA 4 case with Deutsch DT connectors.

Read More »
Temperature Controllers utilize microprocessor for accuracy.
Controls and Controllers

Temperature Controllers utilize microprocessor for accuracy.

Model 2696-C is designed for cold on/off temperature control while model 2697-C provides cold control with added functionality of defrost cycle control. Controllers provide high accuracy on/off control for temperatures between -40° and +50°F. Model 2696-H suits hot on/off control for temperatures from 32-285°F. Applications include commercial and consumer appliances, cooking...

Read More »
Controls and Controllers

Intrusion Detector delivers open-source network security.

Using proprietary Meta Traffic Processor, MTP-1G wire-speed Gigabit Ethernet Network Intrusion Detection and Prevention System supports open-source network security and monitoring applications. Cards pass Gigabit Ethernet traffic between system's 2 ports with 400 ns latency while performing wire-speed, stateful, packet inspection. When determining whether to capture or block packets, cards can...

Read More »
External Isolation I/O Modules suit harsh environments.
Modules

External Isolation I/O Modules suit harsh environments.

Connecting directly with PCI-1751 and PCI-1753 TTL-level digital I/O boards, PCLD-8751 has 48 isolated digital input channels, while PCLD-8761 has 24 relay channels and 24 isolated digital input channels. Digital input channels have 3,500 Vdc isolation protection, 5-30 V input range, and wet or dry contact setting through DIP switch selection. Relay output channels feature 1,500 Vdc isolation...

Read More »
Directional Control Valve incorporates on-board electronics.
Controls and Controllers

Directional Control Valve incorporates on-board electronics.

Model 4DP03-3B is rated at 100, 200, or 300 l/min flow rates with 5 bar-per-spool-edge pressure drop, or 500 l/min in double path configuration. It conforms to ISO 4401-07-06-0, CETOP 7, and NFPA 7 standards. Standard M12 connector socket with O-ring seal is supplied for interface connection, providing ramps adjustable up to 10 sec, and 10 V reference voltage for external potentiometer. Optional...

Read More »
Controls and Controllers

PWM Controllers offer PFC shut-down feature.

Current Mode Controllers Series NCP1230 and NCP1231 allow power supply designers to shut-down power factor correction stage in light or no-load conditions. Units offer cycle skipping at light loads, internal ramp compensation, and frequency dithering. Both series are available in 65, 100, and 133 kHz frequency options. Series NCP1230 integrates 2.5 ms soft-start, while Series NCP1231 offers...

Read More »
Embedded Controllers suit industrial automation applications.
Computers

Embedded Controllers suit industrial automation applications.

Power PC Model EPPC-405 incorporates IBM PPC405GP, 32-bit processor with 200 or 266 MHz, enabling performance up to 375 MIPS. It supports IEC61131-3 programming as well as LINUX, RTLinux, QNX, vxWorks, and RTOS operating systems. Unit features Ethernet interface, 1 or 2 electrically isolated CAN interfaces and controllers, and one or two RS-232 serial interfaces. Model EPPC-405-UC offers 2 USB...

Read More »
Electrical Regulators

Switching Regulators suit high-output voltage applications.

Manufactured in 2 x 1 x 0.39 in. metal case with 6-sided shielding and industry standard pinout, SRAD20 series includes SRAD20S200/5 and SRAD20S200/12 models with input voltage ranges of 6-10 and 9-18 Vdc, respectively. Both have 20 W constant frequency, current mode, adjustable output, step-up switching regulators that provide adjustable output voltage from Vin to 200 Vdc. Series offers line and...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers