Telecom Blade is based on PowerPC 750FX processor.

Telecom Blade is based on PowerPC 750FX processor.

Katana(TM) 750v cPSB blade features 2 PTMC sites, 5 Ethernet channels, and CTBus/H.110 TDM interconnect. Unit combines 800 MHz processor with Marvell MV64360 system controller, which provides high-speed access to as much as 1 GB SDRAM and 128 MB of flash memory. PTMC sites, which support 32-bit PCI data transfers at 33 MHz or 66 MHz, are equipped with dedicated CTBus and RMII interfaces. Blade's...

Read More »
PC Board offers gigabit speed communication.

PC Board offers gigabit speed communication.

Compatible with PCI bus configured PCs, Gigabit Fibre Channel (ANSI X3.230) Board enables communication at gigabit speeds for fiber optic and copper cable applications. It incorporates TLK1501 bi-directional, serial, point-to-point transceiver chip. Balanced, twisted pair Fibre Channel copper cables can be used for runs up to 200 m, and runs to 2 km are possible with fiber optic cables. Compact...

Read More »
PCI Cards feature 4096 Mbit on-board signal memory.

PCI Cards feature 4096 Mbit on-board signal memory.

Supporting all logic families, Ultrafast UF7221 full-length PCI card provides maximum output rate of 40 MHz on 32 digital channels. Each 4 bit (nibble) can be programmed with different high and low output levels from -2 to +10 V in 10 mV increments to generate ECL, PECL, TTL, LVDS, LVTTL, CMOS and LVCMOS signals. Output rate of signals can be programmed from DC to the 40 MHz max output rate. A 6U...

Read More »

Serial Port Board enables embedded system communications.

Emerald-MM-Opto PC/104 module offers 4 optically isolated serial ports with RS-232, RS-422, and RS-485 protocols, each of which is independently configurable for protocol and IRQ settings. Available in 2- or 4-port configurations, unit includes 24 digital I/O lines with programmable direction and user-configurable pull-up resistors. Product also features auto-flow control and 16C2850 UART chip...

Read More »
PCI Card suits development and simulation applications.

PCI Card suits development and simulation applications.

PCI-compatible PCI-Altera-485 includes PLX9054 and Xilinx for initial loading of Altera, and DMA transfer of data into and out of FIFOs. Altera controls 40 programmable RS-485/LVDS transceivers and 12 TTL IO. Each RS-485 channel is programmable for direction, termination, and function. Eight Cypress 22393 PLLs support Altera providing ability to synthesize multiple reference rates. PLX 9054...

Read More »

Analog Output Board suits PCI-based computers.

Model OMB-DAQBOARD-2004 offers four 16-bit 100 kHz analog outputs ranging from -10 to +10 V. Through use of Bus Mastering DMA, each D/A output can continuously output waveform, which can be read from PC RAM or file on hard disk. Program can asynchronously output value to either D/A for nonwaveform applications if D/A is not already being used in waveform output mode. Additional D/A channels can...

Read More »
PCI Cards are compatible with old and new PCs.

PCI Cards are compatible with old and new PCs.

Universal voltage, ARCNET PCI20U network interface modules are compatible with 3.3 V and 5 V computers. Six models link PCI and PCI-X bus compatible computers with ARCNET LAN. Units allow for jumperless configuration and plug-and-play functionality. Each 32-bit, 33 MHz bus card operates with NDIS driver or null stack driver in Windows environment. Two LEDs monitor network operation and bus access...

Read More »
LED Alpha-Numeric Marquee has Ethernet interface.

LED Alpha-Numeric Marquee has Ethernet interface.

Model EL-2800-902 consists of 24-30 characters wide unit with double-sided viewing. It displays alphabetic and numeric characters in 1 line of 4 in. text, static or scrolling. Firmware PP-2111-189 implements DF1CRC protocol, which makes it possible to use Allen-Bradley communication modules to connect marquee to ABEthernetIP or Controlnet networks.

Read More »
Digital Power Controller speeds product development.

Digital Power Controller speeds product development.

Power, control, and data interfaces of MultiDriver(TM) Board provide integrated system for digital controller development. Switching power stage accepts 12-48V supplies and provides 6 A half-bridge or 3 A full-bridge output current. FlexController(TM) SOC allows verification of control algorithms through PC with FTview(TM) software. Data communication is through FlexBus(TM) isolated multi-drop...

Read More »
Analog Input Card offers 30 MS/s sampling rate.

Analog Input Card offers 30 MS/s sampling rate.

High-speed, Model PCI-1714 streams continuous data from analog samples to host memory. Simultaneous sampling is provided on all 4 input channels through dedicated A/D converters. Trigger modes include software triggering, internal and external pacer triggering, post trigger acquisition, delay trigger acquisition, and pre-trigger acquisition. Card includes software for auto calibration, so no...

Read More »

All Topics