Saelig Company Inc

ComfilePi Touch-Panel PC comes with piezo buzzer.
Computer Hardware & Peripherals

ComfilePi Touch-Panel PC comes with piezo buzzer.

ComfilePi Touch-Panel PC features Raspberry Pi 3’s 1.2GHz 64 bit quad-core ARM Cortex-A53 processor, a Broadcom VideoCore IV GPU and 1GB of RAM. Unit is offered in CPi-A070WR and CPi-A102WR models with screen sizes 7 in. and 10.2 in. respectively. Product offers 22 x ESD-protected GPIO lines, 3 x USB 2.0 host ports, 1 x RJ-45 Ethernet port, 1 x I2C port and 2 x RS-232C ports. Operated in a...

Read More »
PSU-HV Series Programmable DC Supplies offer adjustable slew rate.
Electrical Equipment & Systems

PSU-HV Series Programmable DC Supplies offer adjustable slew rate.

PSU-HV Series Programmable DC Supplies are available in 100V/15A, 150V/10A, 300V/5A, 400V/3.8A, and 600V/2.6A models. Unit comes with LAN, RS-232 with RS-485, USB Host, USB Device and isolated analog interfaces. Featuring over-voltage and over-current protection, unit provides constant voltage / constant current selection that protect device under test. These single output programmable units...

Read More »
Sol Chip Pak™ Power Modules are suitable for GPS vehicle tracking.
Controls & Controllers

Sol Chip Pak™ Power Modules are suitable for GPS vehicle tracking.

Featuring a rechargeable battery and power management circuits, SCP-R2801 Sol Chip Pak™ Power Modules are based on Sol Chip’s Saturn cells which provide power in office light conditions. Units are offered with 1, 2, 3 or 6 Saturn solar cells. Product’s battery offers output voltage of 3.6V. Modules are suitable for agriculture, farming, drip-irrigation systems, weather testing, security,...

Read More »
Saelig's Comb Generators come in 3 and 3.5 oz.
Agricultural & Farming Products

Saelig's Comb Generators come in 3 and 3.5 oz.

Available in TBCG1 and TBCG2 models, TekBox TBCGx Comb Generators are used for testing radiated noise measurements. TBCG1 generator comes in 3.2 x 2.4 x 1.1 in. size and powered by 9V alkaline cell. With built-in dipole antenna, TBCG1 is used to emit vertically or horizontally-polarized signals and consumes current of 175mA. TBCG2 generator comes with N female input connector and N male output...

Read More »
Vector Network Analyzer offers 0.005dB RMS trace noise.
Laboratory and Research Supplies and Equipment

Vector Network Analyzer offers 0.005dB RMS trace noise.

Featuring Quad RX four-receiver architecture, PicoVNA 106 Vector Network Analyzer captures 500 point 2-port S2P Touchstone file. Supporting isolation correction and unknown thru calibration methods, unit comes with dynamic range of 118dB at 10Hz and bandwidth of 140kHz. Embedded with Microsoft Windows-compatible software, product is suitable for 5G, IoT, radar, and tissue and materials imaging...

Read More »
CS448 Oscilloscope is equipped with attenuating probes.
Test & Measurement

CS448 Oscilloscope is equipped with attenuating probes.

Designed to measure high voltage, fast slew-rate signals, CS448 Oscilloscope features built-in isolated 65MHz signal generator, RS232, SPI, I2C ports and built-in link port. Providing stimulus signals and eight isolated 100Mb/s logic inputs, unit comes in 9.75 x 6.5 x 2.2 in. compact size. Weighing 5.5lb, product comes with input ranges of ±0.8V and ±8.0V. Offering >110dB CMRR at 50 MHz,...

Read More »
IO-Warrior56 USB I/O Controller supports alphanumeric and graphic LCD modules.
Controls & Controllers

IO-Warrior56 USB I/O Controller supports alphanumeric and graphic LCD modules.

Offering 8-channel 14-bit A/D converter and 16-bit PWM generator, IO-Warrior56 USB I/O Controller is available as 56-pin IC, PCB module or as starter kit. Delivering sample rate of 7800Hz when running in single channel mode, unit’s PWM generator uses an internal 1kHz, 250kHz, 2MHz, or 48MHz clock and generates output signal up to 12MHz. Designed with USB, I2C master, 50/100/400kH and SPI master...

Read More »
Mercury™ T2C USB Protocol Analyzer comes with non-intrusive probing.
Laboratory and Research Supplies and Equipment

Mercury™ T2C USB Protocol Analyzer comes with non-intrusive probing.

Featuring CATC Trace™ display, comprehensive USB class decoding and PD 2.0 protocol analysis, Mercury™ T2C USB Protocol Analyzer supports USB Type-C and Power Delivery 2.0 standards. Available with USB 2.0, USB PD, or USB and PD analysis, unit sits in-line between host and device. Capturing USB transactions, product incorporates hardware-based event triggering and 256MB of memory. Supporting...

Read More »
Programmable DC Loads come with 4.3 in. color TFT LCD display.
Construction Equipment and Supplies

Programmable DC Loads come with 4.3 in. color TFT LCD display.

Featuring static (constant current, voltage, resistance and power) and dynamic (continuous, pulsed, toggled) operation modes, DL3000 Programmable DC Electronic Loads are suitable in automotive electronics, aerospace, and fuel cells industries. Designed with RS232, USB, and LAN interfaces, units come with built-in battery test function, over-current, over-power test, factory test function and...

Read More »
WaveSurfer 510 Oscilloscope comes with 12.1 in. touch-screen display.
Test & Measurement

WaveSurfer 510 Oscilloscope comes with 12.1 in. touch-screen display.

Delivering 10GSs/s of sample rate simultaneously on 4 channels with 1GHz bandwidth and 32 Mpts memory, Teledyne LeCroy WaveSurfer 510 Oscilloscope comes with MAUI OneTouch gesture control interface design. Featuring MS-500-36 mixed-signal option for capture long digital records, unit provides a memory of 50Mpts/channel. Suitable for embedded systems with 16-bit or 32-bit microcontrollers, product...

Read More »

All Topics