Rehm Thermal Systems
Blauberen DEU
Share:
Roll Marking System handles round or flat parts.
Series 12 combines 3 tons of marking pressure into compact 30 x 24 in. floor-mounted unit. In addition to working as a press marker, Series 12 can apply up to 4 lines of 1/8 in. characters per line of information in single roll marking cycle. No electrical connections are required. Anti-tie down dual palm buttons have pneumatic controls. Pressure is achieved with 100 psi source.
Read More »
Marine Hinges keep hatch doors closed.
Positioning-Advantage Hinge and Door-Positioning Hinge hold doors open and closed at pre-set angles without secondary mechanical supports, such as door stay or gas spring. Detent mechanisms allow hinge to mechanically stop at certain angles, thus holding door open or closed depending on how detent is set. Constructed from acetal and stainless steel, hinges meet corrosion-resistance requirements...
Read More »
Single Board Computer plugs into STD 32 bus.
Based on the low power Intel(R) Pentium(R) processor, VL-686-2 board has fanless 266 MHz CPU, no moving parts, and 0 to 60 deg C operation. It draws 16% less power than company's AMD K6 equivalent. Board has 10/100 Ethernet, SVGA flat panel, PC/104-Plus expansion, and DiskOnChip Flash socket. On-board I/O includes floppy and IDE interface, 2 COM ports, dual USB interfaces, programmable watchdog...
Read More »
Compressors feature one-to-one, direct drive technology.
BSD and CSD rotary screw compressors are 40 to 75 hp units available in flows from 158 to 361 cfm and pressures to 217 psig. They include Sigma Profile airend and Sigma Control system. Oversized airend is connected directly to motor via maintenance-free coupling. All units are fitted with high-efficiency separator system for extremely low oil carry over.
Read More »
Miniature Power Relays suit automotive use.
AZ984 20 A relays offer 2.8 mm dual in-line quick connect terminals, and 1 Form C or 1 Form A contact configurations. They are available with 6, 12, or 24 volt dc coils with optional shunt resistors. With silver tin oxide contacts, relays handle inrush currents to 120 A and survive ambient operating temperatures up to 125 deg C. They are suitable for fuel pump, air-compressor, horn, lighting, or...
Read More »
Battery Packs are supplied with wiring harnesses.
Custom Battery Packs feature lithium ion, nickel cadmium, nickel metal hydride, sealed lead acid, and all primary chemistries. Wiring harnesses are 100% crimp inspected and fabricated using automatic AMP-G press for applying interconnects as small as 1 mm, modular plugs, and various other terminals. UL/CSA-approved assemblies provide one source for all portable power, wiring, and connector...
Read More »Compounding System processes virgin and recycled polymers.
GELIMAT(R) uses thermokinetic principle to completely mix, heat, and compound products within 5 to 20 seconds. Short thermal history of polymers prevents degradation. Products attain flux temperatures in seconds and are delivered to downstream section for shaping. GELIMAT processes PE, UHMWPE, PP, PVC, PVDC, ABS, and virtually any thermoplastic or thermoset resin.
Read More »
Storage System protects tool investments.
Maximum Security tool storage system comes with Remote Patrol electronic security system, which provides keyless entry and motion detector. System features Lock n' Roll drawers with non-slip liners, tubular locking system, and non-directional rubber mat. Top chest has 16,101 cubic in. capacity and measures 21 x 54 1/4 x 24 in. Roll cab has 2 sliding parts trays and one tote tray. It can handle up...
Read More »LEDs distribute light evenly to eliminate hot spots.
Reflow solderable LP378 series LEDs offer P4 (piranha type) package; concave, water clear lens; and viewing angle of 120 deg. LEDs employ AlGaInP and InGaN technology, and are available in red (624 nm and 628 nm), yellow (591 nm), green (505 nm and 525 nm), and blue (470 nm). Intensities are rated up to 4000 mlm.
Read More »
Primer-Free Threaded Inserts resist galvanic corrosion.
Stainless steel Heli-Coil inserts, manufactured to military and metric aerospace standards, eliminate need for applying zinc chromate primer. Resin-bonded, fluoropolymer coating creates barrier between insert and parent material. Coating also provides additional lubricity, easing installation in anodized and chemically treated holes and allowing for consistent prevailing torque with screw-lock...
Read More »