RedLine Communications Inc.
Seattle, WA 98188
Sep 17, 2009 RedMAX 4C SC-100e incorporates IEEE 802.16e-2005 technology and operates in 1.8, 2.5, and 3.5 GHz spectrum bands. Based on PHY and MAC, it supports up to 3 high-power radios, using 1, 2, or 3 frequencies, within single 1U base station unit. System includes GPS and multisector support, simplifying network planning, and also supports distributed coverage for indoor and outdoor deployments. Optical interface and external AC/DC converter are also included.

K-Tek
Prairieville, LA 70769
Jul 06, 2009 Enabling transmitting of data between process sensors/DCS or SCADA systems, DX80 Wireless Transmitter and Receiver includes wireless transmitter node accepting up to 2 analog and 2 discrete switch inputs. Including wireless receiver gateway that accepts up to 55 nodes, system has embedded site survey tool which analyzes strength of radio signal between gateway and specified node. Housed in IEC IP67, NEMA 6 rated enclosure, product offers line of sight range of 3 miles.

Circuit Design, Inc.
Nagano 399-8303  Japan
Jun 23, 2009 Programmed with 4 channels, transmitter Model CDP-TX-05M-R and receiver Model CDP-RX-05M-R feature narrowband FM 25 kHz channel spacing and operating temperature of -20 to +65°C. Using TCXO as reference oscillator circuit of radio component ensures frequency stability. With output of 10 mW authorized for narrow band FM and double superheterodyne receivers with receive sensitivity in European harmonized ISM band, communication range of 600 m line-of-sight is possible.

Honeywell
Golden Valley, MN 55422 3935
Jun 01, 2009 Approved for hazardous areas, STXW 500 and STTW 401 convert any measurement device with contact-closure switch input into wireless input. Products can transmit signals from up to 3 contact switches; STXW 500 accepts 3 discrete/digital inputs, while STTW 401 accepts thermocouple input and 2 discrete/digital inputs. Both work under OneWireless(TM) industrial wireless mesh network and are suited for applications such as monitoring level switches, pump status, and system alarms.

Digital Monitoring Products
Springfield, MO 65803
May 22, 2009 Two-input wireless transmitter 1103 combines internal reed switch, on-board terminal block for contact wiring, and end of line resistor. Both internal and external contacts can be programmed to operate simultaneously, yielding 2 independent zones from one transmitter. Built-in survey capability for one-person installations is provided by on-board LED, eliminating need for external survey kit. Unit includes lithium ion battery and hardware pack and is available in white plastics.

KORENIX Technologies
Taipei 231  Taiwan
May 21, 2009 Featuring integrated Intel TDMA technology, JetWave 2600 Series communicates over distances of at least 40 km without sacrificing transmission quality. JetWave 2610 and 2620 are built on IEEE 802.11a standard for wireless transmission networks and use 5 GHz bandwidth as operating frequency, while JetWave 2640 adopts dual band, IEEE 802.11a and 802.11g standards technology. All support base station, CPE, relay, point-to-point, and point-to-multipoint modes of operation.

Emerson Process Management
Austin, TX 78754
May 13, 2009 Establishing secure WirelessHART self-organizing network, Smart Wireless Field Starter Kit delivers greater than 99% communications reliability in steel and concrete environment of plants. Kit includes any combination of 5 or more wireless pressure, temperature, DP level, DP flow, vibration, or pH transmitters and discrete switches; Smart Wireless Gateway; AMS® Suite predictive maintenance software; Wireless SNAP-ON for AMS Suite; and Smart Start(TM) Services for full network health assessment.

CP Technologies
Irvine, CA 92614
May 12, 2009 Model WBR-3800 LevelOne MobileSpot(TM) Portable Wireless Hotspot allows users to share Internet connection by plugging compatible 3G notebook adapter into device's CardBus slot. Offering mobile broadband connections and Wi-Fi, it is Mac- and PC-compatible and 802.11b- and 802.11g-compliant. For security, it has WPA, WPA-PSK/WPA2-PSK authentication with TKIP/AES encryption, and Internet firewall. Unit is 5.1 x 4.8 x 1.3 in. and 11.2 oz and also incorporates 10/100 Mbps Ethernet switch.

Rohrback Cosasco Systems
Santa Fe Springs, CA 90670
May 05, 2009 Microcor Wireless Transmitter uses high-resolution metal loss measurement that provides 18-bit resolution and is rated for operation in hazardous locations in temperatures from -40 to +70°C. Based on Microcor® technology, unit provides accurate corrosion rates in any process media in real-time. Each device will work as node in self-organizing mesh network to ensure consistent delivery of data and provides adaptive solution for data transfer.

Rohrback Cosasco Systems
Santa Fe Springs, CA 90670
Apr 27, 2009 Available with Hazardous Area Certification, Microcor® Wireless Transmitter provides corrosion rates in any process media at speeds approaching real time. Unit uses high-resolution metal loss measurement, providing 18-bit resolution and operating from -40 to 70°C. Transmitter works as node in self-organizing network to ensure consistent delivery of data. In event temporary obstruction blocks direct connection, network automatically reroutes signal to adjacent device.

ELCA Srl
Mussolente 36065  Italy
Mar 31, 2009 Offering frequency band of 868.0125-869.9875 MHz with up to 24 different possibilities, MITO is designed to work with recovery vehicles, winches, small cranes, and other industrial applications. System consists of IP67 protected transmitter and receiver, internal lithium battery, and battery charger. Listen Before Transmit feature allows unit to automatically scan, find, and lock onto clear and available frequency by pressing start button.

Proxim Corp
SunnyVale, CA 94086
Mar 27, 2009 Specifically created for ISP market and bundled in 20 pack with power injectors for each unit, Tsunami(TM) 5012-CPE WiMax Radios feature Wireless Outdoor Routing Protocol technology. Units provide throughput rates of 12 Mbps downlink and 1 Mbps uplink, allowing ISPs to provide basic data services as well as VoIP and IPTV applications. Advanced encryption with AES protects over-the-air transmission, while intracell blocking forbids direct communication between subscriber units.

Emerson Process Management, Rosemount Div.
Chanhassen, MN 55317
Mar 17, 2009 Suited for high density temperature measurement, Rosemount® 848T wireless temperature transmitter monitors up to 4 independently configurable RTD, thermocouple, ohm, millivolt, and 4-20 mA inputs, allowing for proactive maintenance of key assets. It includes Electronic Device Display user interface, which provides graphical screens to deliver important configuration and information. Self-powered unit utilizes SmartPower(TM) technology to provide intrinsically safe power module.

Redpine Signals, Inc.
San Jose, CA 95131-2019
Feb 26, 2009 Based on Lite-Fi(TM) 802.11n technology, SenSiFi(TM) module (RS9110-N-11-31) provides all control and standards-compliant WLAN functionality with WPA2 security required to build and deploy wireless sensor nodes. It can collect full range of telemetry information through standard A/D sensor interfaces, and MCU implements embedded OS. Supplied in 31 x 44 mm QFN package, self-contained module also includes network stack that terminates TCP/IP and UDP connections with IPv6 capability.

Airfonix
Los Angeles, CA 90066
Jan 21, 2009 Intended for users of Mac or PC, Model AFX-19UB001 provides uncompressed, 16-bit, pop-free wireless connectivity transmission from any USB-enabled audio source to any passive or active speaker equipped with Airfonix wireless receiver. Device gives users freedom to place speakers anywhere without wiring them to audio source. Housed in weathered industrial aluminum die-cast chassis, transmitter offers 50 m minimum transmission range and is suited for indoor/outdoor audio setups.

Broadcom Corp.
Irvine, CA 92618
Dec 18, 2008 Providing up to 50 Mbps of wireless throughput, Model BCM4329 enables mobile phones to support media and data applications without impacting size or battery life. Device uses single-stream 802.11n to transmit and receive data, and employs space time block coding, which enables mobile devices to maintain connection with access point anywhere within expanded coverage area. Dual-band capabilities allow Wi-Fi users to leverage 5 GHz spectrum for media applications that require faster bandwidth.

Perpetuum Ltd.
Southampton   United Kingdom
Oct 20, 2008 Wireless sensor node assessment kit, wSNAK, confirms advantages of condition monitoring systems powered by vibration energy-harvesting. Its 4 energy harvester-powered wireless sensor nodes send vibration/temperature data to laptop-based receiver, and each sensor node runs IEPE accelerometer with integrated temperature sensor on flying lead. Data is sent from each node, via IEE802.15.4 transmitter, to receiver situated up to 100 m away.

Exalt Communications Inc.
Campbell, CA 95008
Sep 23, 2008 Carrier-class EX-r GigE series delivers up to 440 Mbps aggregate throughput at link ranges up to 15 miles with 99.999% availability. Secured with AES 128- and 256-bit encryption, tri-band platform delivers true native Ethernet and native TDM support integrated in one system and delivers bandwidth needed for campus connectivity, camera backhaul, 3G/4G backhaul, WiMAX backhaul, and HD video broadcast.

Circuit Design, Inc.
Nagano 399-8303  Japan
Sep 11, 2008 With narrow band FSK modulation, CDP-TX-02E-R and CDP-RX-02E-R Radio Modules are resistant to noise and achieve line-of-sight communication distance of more than 600 m with only 10 mW power. Radio frequency can be selected from 32 pre-programmed channels in 25 kHz steps, or by setting arbitrary frequency channel. Operating from -20 to +60°C, modules are designed for embedding in industrial equipment and are suitable for indoor and outdoor use.

Hanwell Instruments Ltd.
Centerbrook, CT 06409
Aug 13, 2008 Enabling wireless monitoring, rl4106 temperature and humidity transmitter features real-time alarm notification and allows historical analysis of data. Unit includes onboard temperature sensor and humidity sensor, which can be mounted internally to transmitter body, externally on case, or remotely on probe. Powered by 3.6 V AA Li-Ion battery, it includes LCD screen that simultaneously displays recent readings and predicted battery life.