
Tool Bits perform specific welding end prep jobs.
Titanium nitride (TiN) coated Formed Tool Bits, for use with EscoLock(TM) wedge-lock blade locking system, bevel, face, and bore clad boiler tubes simultaneously without cutting oils. Suitable for Millhog end prep tools, bits work on tubes from Â-½ in. ID to 18 in. OD and cut angles from 10° to 37½Â°. In addition to peeling back clad boiler tubes, bits perform specific...
Read More »Cut-Off Machine offers integral end finishing.
Model TCC-25 Rotary Tube Cut-off machine offers integrated double end finishing, which allows square or chamfered ends to be provided on one (or both) ends of tube. It allows operator to select desired cut type (thru cut, cut and pull, or end finished) from control panel. Lengths and quantities are user-selectable, allowing the machine to be programmed for automatic operation.
Read More »
Automatic Cutter cuts wide range of materials.
MMC100 cuts round or flat material up to 3.94 in. wide and .63 in. thick. It is microprocessor-controlled and can be programmed to cut any length with 1% or better tolerance. Programmable for up to 10 batches and 3 fixed feed rates, MMC100 is rated to cut up to 7,200, four in. pieces/hr. With max cutting force of 600 lbs, it can cut copper wire and cable, silver solder, power cords, cellophane,...
Read More »
Air Powered Saw cuts round pipe square.
APS-438 3 hp saw and WrapTrack clamps around circumference to cut pipe from 6 to 60 in. dia with ±1/8 in. accuracy and no heat affected zone (HAZ). It can cut 10 in. Sch. 160 pipe in under 10 min. Saw is available with 8 to 14 in. fiberglass reinforced abrasive blades and carbide tipped blades for cutting everything from plastic to cement lined ash pipe. Saw requires 90 psi @ 80 cfm, and...
Read More »
Designing and Specifying the Right Loudspeaker System for Emergency Mass Notification in Public Venues
A guide for designing and implementing effective loudspeaker systems for emergency situations.
Read More »
Cutoff Machine processes tube and bar stock.
Adige CM 502 cutoff saw and end-finishing center automatically loads stock, saws it to length, and machines both ends of cut component. Finished parts can be produced on single machine to minimize handling and cycle time. It can also perform rotary transfer, facing, chamfering, centering, recessing, drilling, turning, threading, measuring, and washing. It also offers electronic gauging and...
Read More »
Complete Water Solutions Offers Wide Range of Water Treatment Equipment
Complete Water Solutions provides full installation tailored to your water treatment needs. Check out the video to learn more.
Read More »