Power Supply fits CompactPCI(R) systems.
Power Supplies

Power Supply fits CompactPCI(R) systems.

Model cPCI35ODC 6Ux8HP hot-swap supply is in compliance with PICMG(TM) 2.11 R1.0 Power Interface Spec and other CompactPCI standards. Delivering 350 W of continuous output power, unit supports standard PCI output voltages of +5 V, +3.3 V, +12 V, and -12 V with no minimum load requirement. Active current sharing and internal ORing diodes are included to support high availability (HA) applications...

Read More »
Power Supplies

UPS handles power fluctuations in CompactPCI systems.

ICP-UPS is designed for CompactPCI systems with Windows NT 4.0 or greater. It provides required power backup allowing operating system to shut down in controlled manner following power outage to maintain data integrity and ensure that next boot occurs without problems. Onboard control logic continually monitors supply line. Ni-Cd battery energizes application for up to 60 sec in the event of a...

Read More »
DC/AC Inverters meet NEBS/Telco standards.
DC to AC Power Supplies (Inverters)

DC/AC Inverters meet NEBS/Telco standards.

Topaz S4 scalable -48 Vdc DC/AC inverters offer paralleled synchronized operation while N+1 redundancy is achieved with 2 or more units connected in parallel. They use redundant power modules that are hot swappable within rack mountable receiver cabinet. Units are scalable from 3.5 kVa to 21 kVa in N+1 configuration. Noise filter limits ripple current on battery and ensures radiated and conducted...

Read More »
AC Power Sources includes 16 waveform library.
Power Supplies

AC Power Sources includes 16 waveform library.

Available with manual or programmable controller, ASX series switch-mode topology AC Power Sources achieve power conversion using pulse-width modulation. Manual controller enables users to adjust voltage and frequency from instrument's front panel. Controller includes 1 phase/ 3 phase switch selectable output, 1500 to 6000 VA output capacity, and 600 V output that covers frequency band of 15 to...

Read More »
Seal Stuff In, Seal Stuff Out
Sponsored

Seal Stuff In, Seal Stuff Out

One of the best ways to make sure that your machinery stays up and running in the face of adversity is to make sure that it's properly sealed. Of course, it's not always easy to determine whether the integrity of your seals are up to par. How can you tell when you have a problem?

Read More »
Switching Power Supplies are DIN rail mounted.
Power Supplies

Switching Power Supplies are DIN rail mounted.

DRL Series 25 to 320 W power supplies, in cage-covered packages, have snap-on, DIN-rail mounts. They accept universal inputs from 85 to 265 Vac. Thirty models provide single outputs from 5 to 48 Vdc. All have soft-start circuitry, EMI filtering, integral, power-good LED indicator, and output-adjustment potentiometer. Units operate over ambient temperature range of -10 to +60 deg C, without forced...

Read More »
DC-DC Converter generates regulated output.
DC to DC Power Supplies (Converters)

DC-DC Converter generates regulated output.

Switched-capacitor ZXCP330E6 provides 3.3V output from 2 to 4.4 V input with maximum load current of 40 mA. Short-circuit and thermal-overload protected, SOT23-6 packaged converter suits lithium-ion and alkaline battery-powered products. Operating with flying capacitor of 220nF and 10 microF bypass capacitors at input and output, typical PCB area requirement is 8 x 5.3 mm. It draws 20 microA...

Read More »
DC/AC Inverter meets NEBS/Telco standards.
DC to AC Power Supplies (Inverters)

DC/AC Inverter meets NEBS/Telco standards.

Redundant, -48 Vdc Topaz S4 meets Network Equipment Building Standards (NEBS) standard for mission-critical telecom and data applications, and has UL, CSA CE, TUV and FCC class A approvals. Inverter is scalable from 3.5 kVA up to 2l kVA in N+l configurations. Redundant power modules are hot swappable within rack-mountable receiver cabinet. AC distribution panel accommodates 20 single-pole...

Read More »
Power Supply charges capacitors at constant power.
Power Supplies

Power Supply charges capacitors at constant power.

Model 2800 Universal High Voltage Power Supply, for capacitor charging, can also be used as constant voltage, constant current, or constant power bench supply. It produces up to 15kV positive or negative output and up to 135 W max of output power, with 55 mA current limit, voltage input as low as 12 Vdc, and user selectable voltage limit. Other applications include electrophoresis and insulation...

Read More »
Power Supplies

Power Adapter delivers high power efficiently.

PSA150U adapter provides 100W of power with 85% efficiency, thus minimizing heat dissipation and allowing it to be placed in confined space. Universal ac input range eliminates switching needs. Adapter has worldwide EMC compliance, meets FCC Class B and EN55022 Class B conducted noise limits, and is approved for UL, cUL and TUV. Adapter mates with any IEC C 13 line cord. Applications include...

Read More »
Power Supplies produce 40W outputs.
Power Supplies

Power Supplies produce 40W outputs.

MKS40-Series high density enclosed switching power supplies accept universal input from 85-265 Vac and are available in 4 models that provide single outputs from 5 to 24 Vdc. All models have LED indicator, output adjustment potentiometer, 3,000 V isolation, over voltage and short circuit protection, and integral input line filtering. They operate over ambient temperature range of -10 to +60 deg C...

Read More »
Sponsored

Simple Connection – MGB with EtherNet/IP

The new MGB with EtherNet/IP is a leap forward in access door safety. Designed for easy installation, flawless performance, and long service life, it is engineered with robust features and cutting-edge technology that places it firmly at the leading edge of the door safety device industry. To learn all about the benefits of the Euchner MGB, see our video.

Read More »

All Topics