Electronic Drivers

AC-DC LED Drivers power outdoor lighting applications.
Electronic Drivers

AC-DC LED Drivers power outdoor lighting applications.

Housed in miniature 1.90 x 1.31 x 0.94 in. package, BPOXL Series includes 4 W and 8 W models that offer 350 mA and 700 mA constant current operation for LED string voltages up to 12 and 9 Vdc, respectively. Output characteristics are fully maintained over 10.8-16.2 Vac input range. Specified for full-rated power over temperature range of -40 to +85°C, IP67-rated modules feature 11 in., 18...

Read More »
Electronic Drivers

LED Drivers target notebooks and tablet PCs.

Housed in 3 x 3 mm TQFN-16L package, 4-channel MAP3105 has input voltage range of 4-26 V and embedded MOSFET, which can boost output voltage to 45 V with switching range of 500 kHz ~ 2 MHz. Six-channel Model MAP3106, offered in QFN package measuring 4 x 4 mm, has input voltage of 5-24 V and embedded MOSFET which can boost output voltage to 40 V with switching range of 330 kHz ~ 1 MHz. Both...

Read More »
Electronic Drivers

LED Driver IC drives LEDs using buck topology.

Employing average current mode control, Model HV9861A does not produce peak-to-average error, optimizing accuracy and line/load regulation of LED current. Unit requires no loop compensation or high-side current sensing. With internally regulated voltage of 7.5 V, it is suited for variety of solid-state lighting applications, including TV and monitor backlighting, signage, decorative, and general...

Read More »
Electronic Drivers

LED Driver targets street light installations.

Providing single-step conversion from 347 or 480 Vac down to less than 57 Vdc, Model LXMG221D-0700040-D2F(TM) eliminates step-down transformers. Device supports constant current single 700 mA string applications using ~12-17 LEDs without flickering, and includes fault detection and management capabilities. With power factor greater than 0.9 and THD of less than 15% across input voltage range at...

Read More »
Optocoupled Gate Driver supports power MOSFETs and IGBTs.
Electronic Drivers

Optocoupled Gate Driver supports power MOSFETs and IGBTs.

Capable of providing 2.5 A of peak drive current, Model IX3120 features supply voltage range of 15-30 V and common mode rejection of 25 kV/Â-µsec at VCM = 1,500 V. Input signal is provided by LED, which is optically coupled to IC that contains high-speed CMOS power output stage. This combination provides isolated driver capabilities without use of isolation transformers. Model IX3120 is...

Read More »
LED Driver includes on-chip diagnostic read-back function.
Electronic Drivers

LED Driver includes on-chip diagnostic read-back function.

Operating from 3.0-5.5 V supply voltage, Model AS1123 is optimized for LED panels where only single LED is connected per output. Constant-current, 16-channel device features integrated diagnostics for over-temperature, open-LED, and shorted-LED conditions. Low-current diagnostic mode eliminates display flicker during global fault testing. Adjustable up to 40 mA/channel using external resistor,...

Read More »
Electronic Drivers

AC/DC LED Drivers operate from -40 to +80°C.

Housed in IP68-rated waterproof cases, AMExRx-AZ Series provides free air convection cooling, output current control for adaptive lighting control systems, and active PFC of greater than 0.9. Units accept 90-277 Vac at 47-440 Hz and 120~390 Vdc, while delivering 30-151 W and 5-50 Vdc. With efficiency up to 91% and input-to-output isolation up to 3,000 Vac, drivers are suited for street signs,...

Read More »
GlacialTech Announces Their HS10P / HS15P Series & HS25P Series LED Drivers
Electronic Drivers

GlacialTech Announces Their HS10P / HS15P Series & HS25P Series LED Drivers

The LED driver HS10P / HS15P series & HS25P series offers optimized performance and functions for industrial power supplies for industrial equipments. New Delhi, India: GlacialTech Inc., an eco-friendly solution provider of cost-effective cooling, power, LED products, etc. for industrial and commercial applications, is going to launch two new series of lower wattage LED Drivers with PFC: HS10P /...

Read More »
Photo-flash LED Drivers come in space-saving packages.
Electronic Drivers

Photo-flash LED Drivers come in space-saving packages.

Available in WL-CSP packages, AS364x family ranges from high light output 2000 mA flash LED drivers to cost-efficient 320 mA flash LED drivers. They feature DC-DC boost converter with 4 MHz operation, I2C programmable output currents and timings, variety of security features, as well as features for improving picture quality in mobile environment. Each device in operates directly from a Li-Ion...

Read More »
IP67 LED Drivers have constant current/voltage architecture.
Electronic Drivers

IP67 LED Drivers have constant current/voltage architecture.

Comprised of constant voltage and constant current LED drivers, DLG series meets needs of outdoor lighting, security, and machine vision applications. Waterproof units, efficient up to 90%, cover power ranges of 50, 75, 100, and 150 W. Available constant voltage outputs include +12, + 24, +36, or +48 Vdc, and +15, +30, +54, or +57 Vdc outputs are also available. Depending on power range, constant...

Read More »
Delivery Equipment That Really Delivers
Sponsored

Delivery Equipment That Really Delivers

Are you in need of safer, more efficient transportation equipment? Do you feel like your delivery equipment could really use an upgrade? Check out this video, and learn about Halo Ramp Company's patented safety platforms, and how they help you bypass your trickiest delivery challenges.

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers