
Charged-Plate Monitor evaluates air ionization systems.
Model 158 includes color graphics display to permit viewing of discharge waveforms and offset voltage in time domain. It stores test data and waveforms from hundreds of ionizer tests on removable PCMCIA flash memory card. Unit is line or battery operated. Over-the-shoulder portability allows operator to move about facility unencumbered. Model 158 resolves 0.1 V plate voltage.
Read More »
Current Transducer offers closed loop control.
DCSA Series loop powered, linear output current transformer provides output directly proportional to RMS AC current passing through external LCSC10T12 toroidal sensor. It provides either analog current or voltage: 4 to 20 mA, 1 to 5 Vdc, or 2 to 10 Vdc. Each unit is factory calibrated for monitoring (with LCSC10T12) 0 to 5, 0 to 10, 0 to 20, or 0 to 50 A. Transducer senses current draw on...
Read More »Isotropic Analyzers check magnetic and electrical fields.
Model EFA-200 and EFA-300 analyze low-frequency magnetic and electrical fields to determine safety or potential for harm from high-voltage utility lines and industrial equipment such as resistance welders. Analyzers use Shaped Time Domain (STD) technology to measure in low frequency range of 5 Hz to 32 kHz. They calculate and display field strength levels as percent of industry or government...
Read More »
Current Sensor is self-powered.
TCS Series Go/No Go Sensor/PLC interface can be directly connected to PLC's digital input module or to load rated up to 1 A. It can detect overcurrent or undercurrent events, and signal PLC or switch load device to ON or OFF. Onboard toroidal sensor monitors current flow through ac loads up to 50 A steady, 300 A inrush. TCS Sensor is available with adjustable or factory-fixed actuation point.
Read More »
Choosing an Optimal Custom Label Printer: 5 Key Factors
Read about the 5 primary key factors you should consider when choosing an optimal label printer for your company.
Read More »
Plug-in Transducers reduce installation time.
786 Series transducers can convert 0-10 V or 4-20 mA signals into isolated 0-10 V, 0-20 mA, or 4-20 mA signal with isolation rating of 4kV. It can be plugged directly onto terminal block assembly using base receptacle blocks that are 15, 20, or 25 mm wide. Modules are protected against mismating and can be replaced in single operation during maintenance without affecting wiring. Touchproof test...
Read More »
3Sixty Mission Critical Launches New Service Offering UPS as a Service As A Cost Effective Alternative to UPS Equipment Ownership
At 3Sixty Mission Critical, we specialize in maintaining the performance and uptime of our customer's mission-critical applications. Our services are comprehensive and designed to take on the entire burden of maintenance. Our "UPS as a service" is just another example of how we develop out of the box solutions to help our customers operate more efficiently; see our video to earn more.
Read More »