New Circuits Products

Pushbutton Controller Chips suit battery-powered products.

Model STM6600 and STM6601 smart pushbutton on/off controller chips block device power-up if battery is excessively discharged. Chips can also prevent power-up if fault is detected in power supply. Connecting directly to power button, ICs use smart-reset, which requires 2 pushbuttons to be held down for minimum period before reset occurs, eliminating need to hide reset button. Units have active...

HDMI Companion Chip targets controllers in portable devices.

Available in WCSP package measuring 1.6 x 2.8 mm with 0.4 mm pitch, Model TPD12S015 incorporates 8 low-capacitance ESD clamps, I2C level shifters, and DC/DC converter. Internal boost converter generates 5 V from 2.3-5.5 V battery voltage, eliminating need for on-board supply, while matched HDMI Class-C pin-mapping eliminates board design layout skew. Unit allows HDMI 1.3 data rates and provides...

Video Security Camera SoC employs vision co-processor.

Built around 300 MHz ARM926EJ-S(TM) core, DMVA1 enables full HD resolutions, offers multi-codec support, and provides diverse video quality enhancements. Integration of vision co-processor provides smart video analytics capability for functions such as people counting, trip zone, intelligent motion detection, camera tamper detection, and streaming metadata. IP camera SoC supports H.264 in high,...

Integrated Analog Front End suits ECG and EEG applications.

Featuring power efficiency of 1 mW/channel, ADS1298 suits portable and high-end electrocardiogram (ECG) and electroencephalogram (EEG) equipment as well as patient monitoring and consumer medical applications. This 8-channel, 24-bit solution integrates 8 low-noise PGAs, 8 simultaneous sampling ADCs, as well as amplifiers for right-leg drive, Wilson Central Terminal, and Goldberger Terminals....

Considerations for Choosing a Plastic Injection Molder

Choosing a plastic injection molder is no small decision. There are a number of factors that play into your selection, and it's important to consider them all to ensure you find the plastic injection molding company that suits your unique needs. This eBook is your guide to identifying those factors to help you make an informed decision.

APD Current Monitor reduces settling time for GPON modules.

Supplied in 3 x 3 mm, 14-pin TDFN package with exposed pad, DS1842A is 76 V APD (avalanche photo diode), bias-output-stage, and current-monitoring IC suited for providing bias to and current monitoring for APDs in PON-OLT and PON-ONT equipment. It integrates high-voltage current source; several current mirrors for monitoring APD current; and FET switch configured to work in conjunction with...

Downconverting Mixer suits LTE/WiMAX/MMDS base stations.

Model MAX19998, 2,300-4,000 MHz SiGe downconverting mixer features downconversion channel with 24.3 dBm of IIP3, 8.7 dB of conversion gain, and 9.7 dB noise figure. Unit has 2RF-2LO spurious rejection of 67 dBc for RF level of -10 dBm, and 62 dBc for level of -5 dBm. High- and low-side LO injection architectures for 3.1-3.9 GHz LTE and WiMAX(TM) base stations are supported, as well as 2.3-2.9 GHz...

Analog-to-Digital Converter dissipates only 89 mW.

Operating from 1.8 V analog supply, 16-bit no missing codes Model LTC2259-16 offers signal to noise ratio performance of 73.1 dB and SFDR of 88 dB at baseband. Digital outputs can be set to full rate CMOS, DDR CMOS, or DDR LVDS. Separate output power supply allows CMOS output swing to range from 1.2-1.8 V. Housed in 6 x 6 mm QFN package, 80 Msps device includes alternate bit polarity mode and...

Power Management and Audio ICs increase operational efficiency.

Extending battery life for music-enabled devices, DA9057 integrates dual-input switching USB power manager/Li-ion battery charger, true-ground Class G headphone driver, and 5 programmable DC/DC converters. Latter optimally supports 24-bit stereo audio headphone playback on 5 mW power budget. Also available, DA7201 is 3 W mono audio power amp capable of driving 4 ohm speaker loads. Its 1.5...

Optical Transceiver supports ranges up to 10 km.

Based on SystemOnGlass(TM) technology, DragonFly 40G integrates 4 transmitters, 4 receivers, and optical MUX/DeMUX into QSFP package that delivers 40 Gbps data link. Optical connectivity is based on 2 SMF LC connectors. Tx and Rx each consist of four 10 GBps CWDM channels with wavelengths in 1,300 nm range. Featuring hot-pluggable electrical interface, transceiver is compliant with 40G Ethernet...

High-Speed SMT Multiplexer IC suits 100 Gbps applications.

Designed for use in Opnext 40 and 100 Gbps coherent transponder modules and subsystems, 128 Gbps SMT multiplexer IC eliminates RF connectors and coaxial cabling. SiGe (Silicon Germanium), 0.13 Ã-µm process technology chip transmits data in 32 Gbps lanes suitable for transmission using Dual-Polarization Quadrature Phase Shift Keying (DP-QPSK) modulation scheme for 100 GbE and OTU4 transmission...

Reduce Time to Market, Improve System Uptime with Dedicated Computing Medical Solutions

Embedded computing solutions from Dedicated Computing are designed to meet unique and specific requirements. As the preferred supplier to leading healthcare OEMs, the Dedicated Computing team of expert engineers gets your product out to the market faster while helping your company avoid costly validation and verification steps. Check out our video to learn more.