Acromag, Inc.

Carrier Card supports 32-bit, 66 MHz PCI interface.
Computer Hardware & Peripherals

Carrier Card supports 32-bit, 66 MHz PCI interface.

Model APC-PMC enables use of PMC mezzanine I/O modules in standard PCI computer system. It acts as adapter to route PCI bus signals to and from PMC module through PCI card slot edge connector. Modules with front or rear connections for I/O cable access may be used. Both 5 and 3.3 V signaling are accommodated. Typical uses include data acquisition, process control, test and measurement, motion...

Read More »
I/O Board provides secure front panel connections.
Controls & Controllers

I/O Board provides secure front panel connections.

Model AVME9668 non-intelligent slave board interfaces IP modules to VMEbus. The 6U board holds 4 IP modules. Field I/O connections are made through front panel of carrier board. To accommodate rugged, high-performance applications, front-panel SCSI-2 connectors provide screw-down or spring latch connections that hold cables securely. With support for 8 and 32 MHz clocks, data can be processed at...

Read More »
Modules offer sixteen 16 bit D/A converters per board.
Controls & Controllers

Modules offer sixteen 16 bit D/A converters per board.

IP231 Industry Pack mezzanine module allows simultaneous D/A conversion across all channels, which enables unit to write sixteen 110 V outputs in 135 seconds for high-speed processing. Users can populate VME, PCI, or CompactPCI mezzanine carrier card with up to 5 IP231 modules for high-density single-slot solution. Optional versions offer extended temperature ratings for harsh environments.

Read More »
Remote I/O Modules eliminate need for buscoupler devices.
Controls & Controllers

Remote I/O Modules eliminate need for buscoupler devices.

BusWorks® 900EN modules have built-in network port and can interface up to 12 analog or discrete I/O signals directly to network. Certified via ODVA(TM) conformance tests, buscoupler- and controller-independent modules provide isolated EtherNet/IP(TM) 10/100 Mbps network interface. No software is required. Offered as discrete I/O modules, analog input modules, or analog output modules, all units...

Read More »
Serial Communication Modules have 8 asynchronous ports.
Display & Presentation Equipment

Serial Communication Modules have 8 asynchronous ports.

Models PMC520 (octal 232) and PMC521 (octal 422/485) provide 8 asynchronous serial communication ports from a single PMC carrier slot. Each port is equipped with 64 byte transmit and receive FIFO buffers that minimize CPU interactions, and Baud rate is programmable with data rates of up to 250 Kbps. RTS and CTS handshake support are provided for interface with modems. Other functions include...

Read More »
Isolators protect process equipment and power input devices.
Electrical Equipment & Systems

Isolators protect process equipment and power input devices.

AC/DC-powered 630T Series isolators and signal splitters feature internal excitation supply to drive up to two 2-wire transmitters or other input loop devices. Multi-channel isolators provide space-efficient solution to eliminate ground loops, filter signal noise, and block high voltage surges. Measuring 1 in. wide, single/dual-channel isolators receive 4-20 mA inputs and provide fully isolated...

Read More »
Digital Panel Meter is offered in various configurations.

Digital Panel Meter is offered in various configurations.

Equipped with sunlight-readable display, APM765 Series is available in configurations from LED data display to models with transmitter, alarm, pump control, and networking capabilities. Units display data collected from process current, DC voltage, and temperature inputs. Output options convert display into transmitter with proportional 4-20 mA output or serial communication interface to...

Read More »
Ethernet I/O Modules control up to 6 devices.
Controls & Controllers

Ethernet I/O Modules control up to 6 devices.

BusWorks® 972EN and 973EN Analog Output Modules deliver data from Ethernet Modbus/TCP 10/100 network as voltage or current signals to as many as 6 measurement or control devices. Each 1 in. wide module contains 12-bit D/A converter, microcontroller, and Ethernet interface. Operating off 15-36 Vdc supplies, 972EN models provide user-selectable dc current output ranges of 0-1, 0-20, and 4-20 mA,...

Read More »
Ethernet DC Input Modules suit remote I/O functions.
Controls & Controllers

Ethernet DC Input Modules suit remote I/O functions.

BusWorks® 961EN and 962EN directly interface 6 differential DC voltage or DC current signals from remote sites to Ethernet Modbus/TCP 10/100 network. Embedded web pages allow configuration via web browser, and automatic negotiation arbitrates 10/100 Mbps and full/half-duplex communication. Measuring 1 in. wide, DIN-rail mounted products support up to 10 sockets and include watchdog timers,...

Read More »
RTD Input Modules suit remote I/O functions.
Controls & Controllers

RTD Input Modules suit remote I/O functions.

BusWorks® 966EN Input Modules interface up to 6 RTD or resistance signals directly to Ethernet Modbus/TCP 10/100 network. Each unit accepts universal RTD/resistance inputs with user-selectable ranges for platinum, nickel, or copper RTD sensors and 0-500 ohm signals. Three-way 1,500 Vac isolation between input, network, and power circuits protects against surges and ground loops. Each module...

Read More »

All Topics