Acromag, Inc.

Electrical Equipment & Systems

Ethernet Switches feature redundant ring technology.

Web-managed Model EIS-408 provides six 10/100Base-TX copper ports and two 100Base-FX fiber ports, while unmanaged Model EIS-308 provides eight 10/100 copper ports and is also available without redundancy. All models include auto MDI/MDI-X crossover and auto-polarity, IEEE 802.3 and 802.3u compliance, IEEE 802.3x flow control on full-duplex, and back pressure on half-duplex. They feature IP30...

Read More »
Controls & Controllers

Ethernet I/O Modules combine 3 functions in one model.

Combo 951EN and 952EN Ethernet I/O Modules feature 4 analog input channels, 2 analog output channels, and 6 discrete I/O channels on single 1 in. wide unit. They support Ethernet/IP and Modbus TCP/IP protocols as well as i2o(TM) communication technology. Since Combo modules have inputs and outputs, they can function as transmitters and receivers to independently interface signals. Three-way 1,500...

Read More »
Ethernet I/O Modules speak directly to each another.
Controls & Controllers

Ethernet I/O Modules speak directly to each another.

Featuring i2o(TM) technology, BusWorks® 900EN input modules can send measured signal data directly to output modules without PLC, PC, or other controller in between. Analog input modules measure current, voltage, or temperature signals and transmit data to analog output modules that provide proportional 4-20 mA or 0-10 V DC output. Discrete I/O modules control local devices based on level status...

Read More »
I/O Modules feature reconfigurable FPGA.
Controls & Controllers

I/O Modules feature reconfigurable FPGA.

Series PMC-AX performs A/D and D/A functions under control of user-programmable FPGA. Application-specific logic routines and algorithms can be downloaded into on-board Xilinx® Virtex-II® FPGA with up to 32,000 logic cells for control operation of I/O channels. Inputs are sampled at up to 65 MSps and processed by FPGA without CPU intervention. Models are available with 1 M, 2 M, or 3 M-gate...

Read More »
Carrier Card supports 32-bit, 66 MHz PCI interface.
Cleaning Products & Equipment

Carrier Card supports 32-bit, 66 MHz PCI interface.

Model APC-PMC enables use of PMC mezzanine I/O modules in standard PCI computer system. It acts as adapter to route PCI bus signals to and from PMC module through PCI card slot edge connector. Modules with front or rear connections for I/O cable access may be used. Both 5 and 3.3 V signaling are accommodated. Typical uses include data acquisition, process control, test and measurement, motion...

Read More »
I/O Board provides secure front panel connections.
Cleaning Products & Equipment

I/O Board provides secure front panel connections.

Model AVME9668 non-intelligent slave board interfaces IP modules to VMEbus. The 6U board holds 4 IP modules. Field I/O connections are made through front panel of carrier board. To accommodate rugged, high-performance applications, front-panel SCSI-2 connectors provide screw-down or spring latch connections that hold cables securely. With support for 8 and 32 MHz clocks, data can be processed at...

Read More »
Modules offer sixteen 16 bit D/A converters per board.
Controls & Controllers

Modules offer sixteen 16 bit D/A converters per board.

IP231 Industry Pack mezzanine module allows simultaneous D/A conversion across all channels, which enables unit to write sixteen 110 V outputs in 135 seconds for high-speed processing. Users can populate VME, PCI, or CompactPCI mezzanine carrier card with up to 5 IP231 modules for high-density single-slot solution. Optional versions offer extended temperature ratings for harsh environments.

Read More »
Remote I/O Modules eliminate need for buscoupler devices.
Controls & Controllers

Remote I/O Modules eliminate need for buscoupler devices.

BusWorks® 900EN modules have built-in network port and can interface up to 12 analog or discrete I/O signals directly to network. Certified via ODVA(TM) conformance tests, buscoupler- and controller-independent modules provide isolated EtherNet/IP(TM) 10/100 Mbps network interface. No software is required. Offered as discrete I/O modules, analog input modules, or analog output modules, all units...

Read More »
Serial Communication Modules have 8 asynchronous ports.
Cleaning Products & Equipment

Serial Communication Modules have 8 asynchronous ports.

Models PMC520 (octal 232) and PMC521 (octal 422/485) provide 8 asynchronous serial communication ports from a single PMC carrier slot. Each port is equipped with 64 byte transmit and receive FIFO buffers that minimize CPU interactions, and Baud rate is programmable with data rates of up to 250 Kbps. RTS and CTS handshake support are provided for interface with modems. Other functions include...

Read More »
Isolators protect process equipment and power input devices.
Electrical Equipment & Systems

Isolators protect process equipment and power input devices.

AC/DC-powered 630T Series isolators and signal splitters feature internal excitation supply to drive up to two 2-wire transmitters or other input loop devices. Multi-channel isolators provide space-efficient solution to eliminate ground loops, filter signal noise, and block high voltage surges. Measuring 1 in. wide, single/dual-channel isolators receive 4-20 mA inputs and provide fully isolated...

Read More »

All Topics