Ophir Optics, LLC

New Ophir NanoScan 2s Pyro/9/5-MIR Scanning Slit Laser Beam Profilers are Intended for Smaller Beam Diameters
Controls & Controllers

New Ophir NanoScan 2s Pyro/9/5-MIR Scanning Slit Laser Beam Profilers are Intended for Smaller Beam Diameters

The new Ophir NanoScan 2s Pyro/9/5-MIR scanning slit laser beam profilers are designed to measure mid IR Wavelengths from 900nm to 5µm. The profilers can measure smaller beam diameters, accommodating beam widths as small as 20µm up to 6mm using moving slits. The product also includes a built-in digital controller that provides 16-bit digitization of the signal for a high dynamic range (up to...

Read More »
Beam Profiling Camera is embedded with BeamGage® analysis software.
Optics & Photonics

Beam Profiling Camera is embedded with BeamGage® analysis software.

Used for measuring pulsed and CW lasers from 13 to 355 nm and 1.06 to >3000 µm, Pyrocam™ IV USB Beam Profiling Camera comes with 320 x 320 pixel pyroelectric array that can profile beams up to 25 mm. Featuring 16-bit A/D converter for analysis of large and low level signals in laser beam wings, unit offers 1000:1 signal to noise ratio. Camera provides quick connection to PCs for beam analysis,...

Read More »
Thermal Laser Power Sensor has wide dynamic range, low noise.
Sensors, Monitors & Transducers

Thermal Laser Power Sensor has wide dynamic range, low noise.

With 0.8 sec response time and 0.5 mW noise, fan-cooled F50A-BB-18 measures powers from 10 mW to 50 W and energies from 6 mJ to 50 J. This sensor, designed for continuous use, has spectrally flat BB (broadband) coating usable from far UV to far IR, 17.5 mm aperture, and 0.19–20 µm wavelength range. Linearity results in precision readings of power stability over time without any...

Read More »
Photometric System measures LED luminares up to 610 x 450 mm.
Test & Measurement

Photometric System measures LED luminares up to 610 x 450 mm.

Featuring compact, all-in-one design that uses 2 pi geometry, FluxGage measures flux, color, and flicker for evaluating performance of LED-based products. Photometric test system incorporates photodetector for flicker measurements and spectrometer for color measurement of spectrum, CCT, CRI, Duv, and chromaticity. As light detector, system uses solar panels which are arranged on inside walls of...

Read More »
Laser Power/Energy Meter has multi-format color display.
Laboratory and Research Supplies and Equipment

Laser Power/Energy Meter has multi-format color display.

With Ophir thermal, pyroelectric, and photodiode laser sensors, StarBright measures power, single shot energy, repetitive energy, frequency, and beam size. Handheld instrument also measures irradiance and dosage with PD300RM radiometer sensors as well as laser beam size and beam position with BeamTrack power/position/size laser sensors. Other uses include measuring instantaneous power...

Read More »
Ophir Photonics Announces the Helios Laser Power Meter for Measuring High Power Lasers in Industrial Automation Applications
Test & Measurement

Ophir Photonics Announces the Helios Laser Power Meter for Measuring High Power Lasers in Industrial Automation Applications

North Logan, UT - Ophir Photonics Group, a Newport Corporation company celebrating 40 years of excellence as the global leader in precision laser measurement equipment, has announced the Helios, a compact laser power meter for measuring high power lasers in industrial processing applications. The Helios measures high power solid state lasers – such as diode, fiber, and Nd:YAG lasers – with...

Read More »
Laboratory and Research Supplies and Equipment

Photodiode Sensor measures scanned/intermittent laser beam power.

Able to measure any wavelength overÂ- 400–1,100 nm spectral range, BC20-V1 laser sensor automatically subtracts background from both scanned and static beams. Sensor can measure power of laser bar code scanners as well as laser printer scanners and peak power of pulsed mode lasers. Aperture is 10 x 10 mm, and power measurement range is 0.1–20 mW. Supplied with 1.5 m cable and...

Read More »
Radiometer measures very low powers down to 300 fW.
Sensors, Monitors & Transducers

Radiometer measures very low powers down to 300 fW.

Integrating photodiode sensor and 18 Hz chopper,Â- Model RM9-PD measures power of very low level CW or quasi CW sources with response time of 3.6 sec. Sensor is calibrated over entire range of wavelengths, from 0.2–1.1 µm, rather than single wavelength. Featuring digitally synthesized lock-in amplifier that minimizes external noise, sensor can measure power levels from 300 fW to...

Read More »
New Ophir NanoScan 2s Pyro/9/5-MIR Scanning Slit Laser Beam Profilers are Intended for Smaller Beam Diameters
Controls & Controllers

New Ophir NanoScan 2s Pyro/9/5-MIR Scanning Slit Laser Beam Profilers are Intended for Smaller Beam Diameters

The new Ophir NanoScan 2s Pyro/9/5-MIR scanning slit laser beam profilers are designed to measure mid IR Wavelengths from 900nm to 5µm. The profilers can measure smaller beam diameters, accommodating beam widths as small as 20µm up to 6mm using moving slits. The product also includes a built-in digital controller that provides 16-bit digitization of the signal for a high dynamic range (up to...

Read More »
Beam Profiling Camera is embedded with BeamGage® analysis software.
Optics & Photonics

Beam Profiling Camera is embedded with BeamGage® analysis software.

Used for measuring pulsed and CW lasers from 13 to 355 nm and 1.06 to >3000 µm, Pyrocam™ IV USB Beam Profiling Camera comes with 320 x 320 pixel pyroelectric array that can profile beams up to 25 mm. Featuring 16-bit A/D converter for analysis of large and low level signals in laser beam wings, unit offers 1000:1 signal to noise ratio. Camera provides quick connection to PCs for beam analysis,...

Read More »
Thermal Laser Power Sensor has wide dynamic range, low noise.
Sensors, Monitors & Transducers

Thermal Laser Power Sensor has wide dynamic range, low noise.

With 0.8 sec response time and 0.5 mW noise, fan-cooled F50A-BB-18 measures powers from 10 mW to 50 W and energies from 6 mJ to 50 J. This sensor, designed for continuous use, has spectrally flat BB (broadband) coating usable from far UV to far IR, 17.5 mm aperture, and 0.19–20 µm wavelength range. Linearity results in precision readings of power stability over time without any...

Read More »
Photometric System measures LED luminares up to 610 x 450 mm.
Test & Measurement

Photometric System measures LED luminares up to 610 x 450 mm.

Featuring compact, all-in-one design that uses 2 pi geometry, FluxGage measures flux, color, and flicker for evaluating performance of LED-based products. Photometric test system incorporates photodetector for flicker measurements and spectrometer for color measurement of spectrum, CCT, CRI, Duv, and chromaticity. As light detector, system uses solar panels which are arranged on inside walls of...

Read More »
Laser Power/Energy Meter has multi-format color display.
Laboratory and Research Supplies and Equipment

Laser Power/Energy Meter has multi-format color display.

With Ophir thermal, pyroelectric, and photodiode laser sensors, StarBright measures power, single shot energy, repetitive energy, frequency, and beam size. Handheld instrument also measures irradiance and dosage with PD300RM radiometer sensors as well as laser beam size and beam position with BeamTrack power/position/size laser sensors. Other uses include measuring instantaneous power...

Read More »
Ophir Photonics Announces the Helios Laser Power Meter for Measuring High Power Lasers in Industrial Automation Applications
Test & Measurement

Ophir Photonics Announces the Helios Laser Power Meter for Measuring High Power Lasers in Industrial Automation Applications

North Logan, UT - Ophir Photonics Group, a Newport Corporation company celebrating 40 years of excellence as the global leader in precision laser measurement equipment, has announced the Helios, a compact laser power meter for measuring high power lasers in industrial processing applications. The Helios measures high power solid state lasers – such as diode, fiber, and Nd:YAG lasers – with...

Read More »
Laboratory and Research Supplies and Equipment

Photodiode Sensor measures scanned/intermittent laser beam power.

Able to measure any wavelength overÂ- 400–1,100 nm spectral range, BC20-V1 laser sensor automatically subtracts background from both scanned and static beams. Sensor can measure power of laser bar code scanners as well as laser printer scanners and peak power of pulsed mode lasers. Aperture is 10 x 10 mm, and power measurement range is 0.1–20 mW. Supplied with 1.5 m cable and...

Read More »
Radiometer measures very low powers down to 300 fW.
Sensors, Monitors & Transducers

Radiometer measures very low powers down to 300 fW.

Integrating photodiode sensor and 18 Hz chopper,Â- Model RM9-PD measures power of very low level CW or quasi CW sources with response time of 3.6 sec. Sensor is calibrated over entire range of wavelengths, from 0.2–1.1 µm, rather than single wavelength. Featuring digitally synthesized lock-in amplifier that minimizes external noise, sensor can measure power levels from 300 fW to...

Read More »

All Topics