Texas Instruments, Inc., Semiconductors

Analog-to-Digital Converter operates at 125 MSPS.
Electrical Equipment & Systems

Analog-to-Digital Converter operates at 125 MSPS.

Model ADS5500 14-bit converter features 70 dB SNR and 85 dB SFDR at 100 MHz input frequency. Low power dissipation of 750 mW reduces power supply requirements and need for thermal management. When combined with Model GC5016 digital up/down converter, unit allows oversampling and undersampling of input IF signal. Device comes in 64-TQFP PowerPad(TM) package and is suited for wireless...

Read More »
DC/DC Converter features integrated MOSFET.
Electrical Equipment & Systems

DC/DC Converter features integrated MOSFET.

Model TPS54350 SWIFT(TM) DC/DC Converter supports input voltage from 4.5-20 V at continuous output current of 3 A in small 16-pin HTSSOP package. It provides greater than 90% efficiency and can adjust output voltages down to 0.891 V with 1% accuracy. Unit integrates high-side MOSFET and gate driver for optional low-side external MOSFET. Switching frequency can be fixed at 250 or 500 kHz or...

Read More »
Single-Chip MCU suits electronic flow measurement.

Single-Chip MCU suits electronic flow measurement.

Model MSP430FW427 microcontroller unit (MCU) combines ultra-low-power Flash MCU with programmable communication capabilities, integrated volume scan interface, and LCD driver on one chip. Features include watchdog timer, brownout protection, supply voltage supervisor, 2 multi-channel PWM timers. It has 32 kB on-chip Flash memory, 1 kB RAM, and comes in 64-pin quad flat package. Unit is also...

Read More »
Multi-Phase DC/DC Controllers support 40-120 A.
Electrical Equipment & Systems

Multi-Phase DC/DC Controllers support 40-120 A.

Series TPS4009x synchronous, DC/DC buck controllers manage 2, 3, or 4 phases and can operate each phase at switching frequency up to 1 MHz, resulting in ripple frequency up to 4 MHz at input and output in 4-phase applications. Single-chip, PWM devices include current sense fault protection, programmable over current protection, and individual phase current detection. They offer more than 90%...

Read More »
Audio Power Amplifier features DC volume control.
Communication Systems & Equipment

Audio Power Amplifier features DC volume control.

Model TPA2008D2 5 V, Filter-Free, Class-D Amplifier will drive 6 W into 3 ohm speakers at full power with no external heat sink. Gain is controlled by DC voltage applied to VOLUME pin. Half power total harmonic distortion plus noise is 0.045% at 1 kHz, and noise floor is -80 dBV. Amplifier comes in standard PowerPAD(TM) surface-mount, 24-pin TSSOP package and is suited for 15-17 in. LCD TVs and...

Read More »
Capacitor-Free LDOs include reverse-current protection.
Controls & Controllers

Capacitor-Free LDOs include reverse-current protection.

Series TPS731xx, TPS732xx, and TPS736xx linear regulators come in 5-pin, SOT-23 packages. Units do not require output capacitor for stability and consume less than 1 Â-µA in shutdown mode. Characteristics include low-dropout voltage of 30 mV, low noise of 30 Â-µVrms from 10 Hz to 100 kHz, and standard output voltages from 1.5-5 V. Products incorporate NMOS Topology and thermal-shutdown...

Read More »
DC/DC Boost Converters have linear regulation functionality.
Electrical Equipment & Systems

DC/DC Boost Converters have linear regulation functionality.

Utilizing synchronous rectifier based on PWM controller, TPS6102x family of synchronous, 1.5 A switch DC/DC boost converters provide up to 96% power conversion efficiency from input voltage range of 0.9-5.5 V. ICs can operate in down-mode with linear regulation if input voltage reaches or exceeds output voltage. Available in 10-pin, 3 x 3 mm QFN package, products have power save mode, 25 Â-µA...

Read More »
Analog-to-Digital Converter achieves 4 msps.
Electrical Equipment & Systems

Analog-to-Digital Converter achieves 4 msps.

Model ADS7881 combines 12-bit resolution, 1 LSB linearity, -91 dB harmonic distortion, 71.5 dB signal-to-noise, and 95 mW power dissipation. It addresses high-speed data acquisition needs by providing specification with input signal frequency as high as 1.8 MHz. Suited for optical networking, imaging, and telecommunications, SAR-based unit integrates internal reference and reference buffer, and...

Read More »

All Topics