Texas Instruments, Inc., Semiconductors
Dallas, TX 75243
Share:
Wideband Amplifier suits video line driver applications.
Unity-gain stable, high-speed voltage feedback amplifier, Model OPA830, ensures low distortion operation by high gain bandwidth of 110 MHz and high slew rate of 600 V/Ã-µsec. Gain of +2 V/V bandwidth exceeds 100 MHz with typical 0.1 dB flatness beyond 25 MHz. Output swings to within 25 mV of either supply while driving 150 ohm load. Device is intended to operate on single 2.8-11 V supply, but...
Read More »
Battery Management IC ensures battery safety in electronics.
Model bq26150 identifies potentially unsafe batteries not approved by consumer electronics manufacturers for use in their devices. Unit resides in battery pack and communicates with host system's microcontroller or applications processor. Host processor interrogates battery pack upon insertion over single-wire communications line. IC calculates data obtained from secret decryption key and if...
Read More »
Wideband Amplifier suits DSL line-driver applications.
Burr-Brown OPA2614 op-amp has 5-12 V supply range for single condition and Ã-
Read More »
PCI CardBus Controllers support multiple functions.
Series PCIx515 consists of 4 pin-compatible units suited for connectivity of notebook and desktop PCs, consumer electronics, industrial control, and other PC-based applications. Units support single CardBus slot and include PC Card socket controller that provides bridging between PCI bus and PC Cards. For 1394 applications, PCIx515 family provides one 1394a 400 Mbps port. For security and...
Read More »
Analog-to-Digital Converter features 50 kHz bandwidth.
Model ADS1271 offers 1.8 Ã-µV/C offset drift with low in-band noise of 6.5 Ã-µV rms. Onboard linear phase decimation filter suppresses modular and signal out-of-band noise, providing signal pass-band of 90% of Nyquist rate with less than 0.005 db ripple. With 3 selectable operating modes, 24-bit unit offers 105 kSPS data rate, 109 dB SNR resolution, and power dissipation of 35 mW....
Read More »
DC/DC Converter powers up to 5 series white LEDs.
Available in 8-pin QFN or chip scale packages, TPS6106x 1.5 x 1.5 mm integrated circuits feature intelligent digital brightness control and 1 MHz fixed switching frequency. Synchronous boost converter provides inductor-based solution to power and control white LED backlights in handheld electronics. Models TPS61060, TPS61061 and TPS61062 integrate 400 mA power MOSFET and synchronous rectifier,...
Read More »
Power Module comes in 12 x 10 mm package.
Plug-in, point-of-load, Model PTH04070W supports up to 3 A output current and eliminates need for heat sink, providing up to 94% efficiency. Operating from 3.3 or 5 V input bus, module leverages switch-mode dc/dc topology to convert 5 V input down to 0.9 V with less than 1 W of power dissipation. Power density is 160 W/inÃ-³, and output voltage is adjustable from 0.9-3.6 V using external...
Read More »
Analog-to-Digital Converters target audio applications.
Models PCM4202 and PCM4204 are 2- and 4-channel converters featuring 118 dB dynamic range and -105 dB total harmonic distortion. Both devices support 24-bit linear PCM output data, with sampling frequencies up to 216 kHz, and can be configured to output either 64x or 128x oversampled, 1-bit direct stream digital data for each channel. DSD input mode allows 1-bit DSD to 24-bit PCM data format...
Read More »Voltage-Controlled Amplifier offers high gain adjust range.
Featuring continuously variable 80 dB gain adjust range, Ã-
Read More »
LIN Physical Interface suits automotive applications.
Stand-alone, local interconnect network transceiver, Model TPIC1021, features ESD protection up to 17 kV IEC and 12 kV HBM. It survives ISO 7637 transients and has fault protection to handle 40 V to 40 V on LIN bus. Unit functions across LIN 2.0 specified data rate up to 20.0 kBit/sec and functions equally well at lower data rates recommended by SAE J2602. To maximize EMI, receiver's input filter...
Read More »