Aprima Medical Software, Inc

Multiplexer combines 16 inputs into 1 output.
Communication Systems & Equipment

Multiplexer combines 16 inputs into 1 output.

Model 2100-M Series 16 Channel Multiplexer is available in models that handle milliamp (2100-M-I), RTD (2100-M-R), voltage (2100-M-V), and thermocouple inputs (2100-M-T). Each model is field programmable for industry standard inputs and outputs, and comes in DIN rail-mountable enclosure. It can multiplex up to 16 inputs into 1 output, selectable by PLC or data logging system.

Read More »
In-Line Checkweigher fits under packaging machine.
Test & Measurement

In-Line Checkweigher fits under packaging machine.

CentriWeigh monitors, detects deviations for trending and fill adjustments, rejects underweights, and alarms at line speeds up to 600 packages per minute. It can be installed directly under vertical form fill seal packaging machine and meets speed, accuracy, and reliability requirements for in-line checkweighing applications. Compact unit requires no maintenance, does not drift, and is simple to...

Read More »
Motion Control Chip drives stepper motors.
Agricultural & Farming Products

Motion Control Chip drives stepper motors.

2-axis PCD-4521 controls two-phase unipolar or bipolar stepper motors. Sequence logic for both full and half-step modes is built-in. It can output CW/CCW pulses or excitation signals directly to drive chips, provides independent control of each axis, and controls simultaneous start and stop of all axes. Features include linear or S-curve acceleration and deceleration and idling pulse output for...

Read More »
Spectrometer expands into spectrophotometric system.
Laboratory and Research Supplies and Equipment

Spectrometer expands into spectrophotometric system.

USB2000 incorporates 3 accessories to enable its users to expand it into complete spectrophotometric system. Optimized for measurements from 390-900 nm, Direct-Attach Accessories combine application-specific sampling chamber with light source in small all-in-one package. USB-ISS-T model is designed for use with 12 mm OD test tubes. USB-ISS-VIS and USB-FHS hold 1 cm square cuvettes and 1 in. or 2...

Read More »
Epoxy Resin bonds to most materials.
Adhesives & Sealants

Epoxy Resin bonds to most materials.

TRA-BOND 2111 thixotropic epoxy resin and hardener formulation is developed for industrial adhesive, staking, laminating, repair, and manufacturing applications where long pot-life, good wetting, non-sag, and non-drip properties are required. Two-part system contains no volatile solvents, and cures at room temperature. It bonds to glass and glass fabrics, ceramics, wood, leather, most metals, and...

Read More »
Current Sense Monitor operates with 20V to 2.5V inputs.
Communication Systems & Equipment

Current Sense Monitor operates with 20V to 2.5V inputs.

Model ZXCT 1010 comes in SOT23 5-pin package, and measures load current with its high side sense resistor. Monitoring voltage across its shunt resistor and translating it into proportional output current, this current sense monitor IC uses 1 scaling resistor to convert proportional current into ground referenced output voltage. Features include separate pin to ground that produces output offsets...

Read More »
Rejection Filters address SATCOM market.
Communication Systems & Equipment

Rejection Filters address SATCOM market.

Series 12086 transmit rejection filters are installed between antenna and LNA in receive segment of satellite earth terminals. They are used in C-band transceiver applications to isolate uplink and downlink signals. Units offer low loss, typically less than 0.04 dB on receive signals, while providing high degree of transmit rejection, ranging from 50 to 80 dB. Construction is 100% dip brazed...

Read More »

All Topics