Aprima Medical Software, Inc
Carrollton, TX 75006
Share:
Data-Logging Tachometer features USB output.
Intended for engineers and maintenance professionals, Series DT-2100 Contact/Non-Contact Tachometer aids diagnosis of difficult machinery measurements with on-board data logging, graphing, and statistical analysis. Maximum, Minimum, Average, standard deviation, and number of recordings as well as acceleration are calculated and reviewable. Users can view data and statistics on display or utilize...
Read More »
Stainless Steel Data Loggers employ 2 remote, flexible probes.
The OMEGA® OM-CP-HITEMP140X2-FP Series of stainless steel data loggers offer two remote flexible probes that can measure up to 350ºC (662°F) with an accuracy of ±0.1°C (±0.18°F). These narrow, lightweight probes are offered in a combination of flexible PFA insulation and bendable Stainless Steel. The OM-CP-HITEMP140X2-FP dual probes allow for simultaneous monitoring and can be used for...
Read More »
Angle Sensors target automotive and other mobile applications.
Southborough, MA – Novotechnik, U.S. introduces the new RSC3200 Series of angle sensors that feature shaft connectivity options and provide absolute, rotary position measurement. Analog outputs are 0.25 to 4.75 V or 0.5 to 4.5 V. Built-In coupling accepts D-Shaft with shaft customization available. The sensors are sealed to IP 67 or IP 69k depending on version. RSC3200 Series sensors are...
Read More »OpenVPX DSP Modules leverage Intel Xeon D-1500 CPUs.
AvailableÃ- with 8-core versions of Intelî Xeonî D-1500 CPUs and supporting forthcoming 12- and 16-core versions, 3U CHAMP-XD1 and 6U CHAMP-XD2 are designed for compute-intensive EW/C4ISR aerospace and defense applications. Rugged open architecture modules offer XMC card expansion and feature DDR4 memory and PCIe Gen 3 data paths on both data and expansion planes. While XD1...
Read More »
Power Interface Boards support VITA 62 power supplies.
Available in 3U and 6U heights in either single or dual PSU formats, Pixus VITA 62 Power Interface Boards feature header for voltage sense and IPMB for VITA 46.11 system management or other IPMI-based options. Units have several power bugs for 3.3, 5, and 12 V power as well as 26-pin header that accommodates general purpose I/O signals from PSUs. To optimize chassis cooling, breakaway tabs at...
Read More »
Balanced LNA delivers high gain and low-noise.
Suited for EW and communication systems with space constraints and low power consumption requirements, 9–18 GHz CMD223 has 50 Ω matched design that eliminates need for external DC blocks and RF port matching. Full passivation promotes reliability and provides moisture protection. At 13.5 GHz,Ã- this balanced low-noise amplifier (LNA)ÃÂ delivers >22 dB of gain with corresponding output...
Read More »
Cantilever Sidewalk lets pedestrians safely share bridge roads.
Offering facilitated installation onto existing structures, FRP corrosion-resistant and zero-maintenance cantilever sidewalk system consists of stringers, deck, and railing and weighs as little as 13 psf. FiberSPAN deck panels weigh 4–9 psf, and connection options include supports at piers for minimized superstructure or gussets that act as floor beams at diaphragms or trusses. Railing attaches...
Read More »
COM Express Module supports data-centric applications.
Measuring 125 x 95 mm,Ã- Model PCOM-B634VG utilizes Intelî Xeonî Processor D-1500 Family, which integrates up to 8 CPU cores, each with three 1.5 MB cache, of up to 12 MB in total. Module provides one PCIe x16 and eight PCIe x1 channels, one standard GbE interface plus two 1/2.5/10 GbE Intelî Ethernet interfaces in C/D pin row. Three SODIMM memory slots support...
Read More »
RF Signal Generators have 9 kHz to 3.0 GHz output frequencies.
WithÃ- full remote control capability and digital automatic level control circuit scheme, Rigol DSG800 provides RF signal source with max output of +20 dBm and frequency resolution of 0.01 Hz at any frequency. SSB noiseÃÂ is -115 dBc/Hz, andÃÂ internal clock exhibits
Read More »
Swivel Fitting enables precision blow off.
EXAIR's new Model 9204 1 NPT Swivel Fitting makes it easy to precisely adjust the position of our award-winning air nozzles. With this 303 Stainless Steel swivel, EXAIR’s powerful, efficient and quiet Super Air Nozzles can be pointed exactly where you need work to be done. A 50 degree total angle of adjustment provides the movement necessary for your nozzles to be in the best position for...
Read More »