Spectrum Power Management Systems    State College, PA 16801
Jul 28, 2009 Hybrid DC SMARTStart® combines high-power (30-100 A), direct-feed breakers with discrete, low-power (2-20 A) breaker channels. Configuration lets PDU provide remote breaker cycling capabilities within same 1U package for applications with both direct-feed high and intermediate power requirements. Available with -48, +12, and +24/+28 Vdc input voltages, PDU uses integral feature to perform Low Voltage Disconnect (LVD) without requiring additional hardware.

Spectrum Power Management Systems    State College, PA 16801
Jul 28, 2009 Hardwired into main power infrastructure, Model 74D-160FRLGN-00 provides power via 3 load banks, each featuring four 400 Vdc Anderson Power Products receptacles, one 2-pole 20 A fuse, and LED status indicator. Total current is 60 A max. Housed in slim 0U package, strip saves space for other critical devices.

UltraVolt Inc.    Ronkonkoma, NY 11779
Jul 28, 2009 Offered in packages with respective volumes of 0.08 and 0.35 in.³, XS and US Series are regulated, exhibit tight tolerances, and offer features such as soft start, no overshoot, and current limit protection. Microsize/micropower products offer output voltages from 0-100 V through 0-500 V, at 100 mW output power, and output current from 200 µA to 1 mA. Both series are optimized to meet needs of design engineers with applications such as APDs, SiPMs, and MPPCs.

Wireworks Corp.    Hillside, NJ 07205
Jul 28, 2009 Suited for applications within AV industry, LumaVue Custom Panels can serve as both connection panels and identification plates with custom engraving including company name, logo, and contact info. Units can be rear illuminated, and are rear engraved using CIM engraving system, so marking cannot be marred or destroyed. Offered in 10 colors and with gloss or matte finish, panels will not rust or tarnish. They are manufactured in 1/8 or ¼ in. thickness to meet any design requirement.

noax Technologies Corp.    Huntersville, NC 28078
Jul 28, 2009 Based on lead-gel accumulator, noax uninterruptible power supply (UPS) allows noax industrial PCs (IPCs) to remain in constant operation for up to 1 hr in case of unexpected power loss, voltage sags, or spikes. Even if battery/connection failure occurs, UPS software will recognize problem and shut down IPC according to user-programmed sequence after certain time. Solid-state unit also integrates voltage reversal, short circuit, battery discharge protection.

ITT Interconnect Solutions    Santa Ana, CA 92705
Jul 28, 2009 Designed for both RF and signal contacts, 38999 Series connector supports up to 128 contacts with EMI shielding. It is 100% scoop proof and employs corrosion-resistant aluminum alloy shell with cadmium over nickel plating. Suited for harsh industrial, petroleum, avionics, military/commercial aircraft, and satellite applications, connector is capable of withstanding 500 hr of salt spray exposure. Custom designs and space-grade materials are also available.

L-Com, Inc.    North Andover, MA 01845
Jul 28, 2009 Suited for range of voice, video and data applications, right angle TDG1026KC-R5E Cat 5E coupler fits standard .765 x .585 in. keystone openings. Coupler offers true 90° connectivity to address tight fit applications involving wall plates and some panel designs.

Larco    Brainerd, MN 56401-0547
Jul 28, 2009 Designed for automatic indoor and outdoor entryway applications, Blue Diamond Backlit Wall Switch provides blue backlighting, allowing for visibility in poorly lit areas and at night. Switch incorporates energy efficient monolithic constant-current regulator, light guiding, and LED technology. CE certified, customizable switch is available in 4.5 in. square version with stainless steel or brass finish, as well as with variety of logos and face decals.

AMETEK Solartron Metrology    Gastonia, NC 28054
Jul 28, 2009 Available in 3 models, SI1000 series panel mount display/controllers offer plug and play operation and have 7 digit red LED display that can be updated at up to 10 readings/sec. SI1100 model provides up to 0.1 µm resolution when used with Solartron's LVDT displacement and gauging transducers. With 4-20 mA and dc inputs, SI1300 suits applications where long cable runs are required, while SI1500 is designed for use with digital probes. Series has case size of only 96 x 137 x 48 mm.

Pickering Interfaces    Wobum, MA 01801
Jul 27, 2009 With both featuring 160 pin DIN41612 plug connections, Model 60-555 and Model 60-556 High Density EMR Matrix Switches are designed for applications requiring 8-Y and 4-Y axis connections and 2 pole switching, respectively. With 2 A current rating and voltage rating 300 Vdc/250 Vac, units can handle commonly encountered signals in ATE systems. X axis dimension can be selected from range of 6 versions offering sizes from 192-512 for each model.

Summit Microelectronics, Inc.    Sunnyvale, CA 94085
Jul 24, 2009 Programmable SMB136/SMB137B employ CurrentPath(TM) technology, which supports dual input source (USB or AC/DC) with arbitration, dual output for system and battery, and system operation with dead/missing battery. Based on 3 MHz, switch-mode architecture, products are supplied in 3.0 x 2.5 mm CSP; integrate TurboCharge(TM) technology; and support all battery charging standards. ICs detect input source type and automatically optimize operation for fastest and safest charging.

Optek Technology, Inc.    Carrollton, TX 75006-6905
Jul 24, 2009 Available with white, warm white, blue, green, red, amber, and yellow LEDs, OVS5MxBCR4 Series LED package feature 120° viewing angle and water clear lens. Power dissipation at 150 mA is 0.48 W for white/warm white/blue LEDs; 0.51 W for green device; and 0.33 W for red/amber/yellow packages. Luminous intensity is 4,000 4,500, and 5,000 mcd for red/amber/yellow LEDs, respectively, while luminous flux for white/warm white/blue/green LEDs is 25, 25, 6, and 25 lm, respectively.

Holophane    Granville, OH 43203
Jul 24, 2009 Available with asymmetric and symmetric reflectors and refractors, High Mast Advanced Optix (HMAO(TM)) Series luminaires can be used with 400-1,000 W high pressure sodium and metal halide lamps. Luminaires are UL listed for 40ºC, wet locations, and they have open ventilated design to minimize dirt depreciation, unitized quick disconnect ballast assembly, and tool-less lamp replacement. Suitable applications include roadways, port facilities, airports, rail yards, and storage areas.

Phihong USA    Fremont, CA 94539
Jul 24, 2009 Suited for portable equipment and access devices, universal input 24 W, 2-wire PSA24A-120(P) is available in single 12 V output. It measures 3.29 x 1.38 x 2.89 in., terminates with standard 2.1 x 5.5 mm DC barrel output connector, and weigh 5.82 oz. Rated for operation from 0-40°C, unit has maximum no-load power consumption of less than 0.3 W. Adapter is Class II double insulated, meets Class B EMI standards, and features over-current, over-voltage, and short-circuit protection.

Electro Standards Laboratories    Cranston, RI 02921 3403
Jul 24, 2009 Supporting all 8 pins of RJ45 interface and transparent to data format, Model 8081 is rated for 10/100 Base-T networks up to Cat 5. It reroutes data between 3 networks with turn of knob and requires no external power. Housed in aluminum desktop case with EMI/RFI shielding, unit features high quality sealed switch with self wiping contacts, eliminating connector wear.

NKK Switches    Scottsdale, AZ 85260-3420
Jul 24, 2009 With terminal spacing that conforms to 2.54 mm PCB grid, JB Series 10 mm square switches with straight PC, feature slanted terminals to provide spring type action, ensuring secure PCB mounting. SPST switches with momentary circuit feature rubber seal construction, operate at -25 to 70°C, and are rated at 50 mA at 24 Vdc and 125 mA at 24 Vdc maximum for standard and high operating force models, respectively. Choice of 2 actuator heights and red, green, or yellow LED colors are offered.

Hypertronics Corp.    Hudson, MA 01749 2978
Jul 24, 2009 Made with bio-compatible materials, ImplanTac Contacts for IS-1 and draft IS-4 form factors as set forth by ISO, are also available for 1.27 mm probe diameters as well as in custom sizes and configurations. Surgeons can mate implanted leads into devices without misalignment, damage to system, or risk to patient. Encapsulated into housing structure, contacts are suited for pacemakers, ICDs, neurostimulators, metabolic controls, circulation pumps, and pain management devices.

XP Power    Sunnyvale, CA 94085
Jul 24, 2009 Offering chassis mount screw terminal format option, 15 and 25 W single output models ECL15-S and ECL25-S provide nominal output voltages of +3.3, +5, +9, +12, +15, +24, or +48 Vdc. They operate at full power from -20 to +50°C, derate linearly to 50% output at +70°C, and require no additional heat sinking or forced airflow. Providing 3,000 Vac input to output isolation, units meet EN55022, level B for conducted and radiated EMC, and carry EN, UL, CSA, and CE safety approvals.

C&K Components    Newton, MA 02458
Jul 23, 2009 Available with multiple actuation options and termination configurations, RoHS-compliant 2-position OS Series slide switches feature shorting or non-shorting contacts with gold or silver contact plating. Maximum contact resistance is 20 mW, with minimum insulation resistance of 100 mW at 500 Vdc. Offering mechanical and electrical life to 10,000 cycles, switches feature dielectric strength of 500 Vac for 1 min, and operating temperature ranges from -10 to +70°C.

austriamicrosystems AG    Premstatten   Austria
Jul 23, 2009 Designed for multiband WCDMA/NCDMA applications such as mobile phones, wireless PDAs, and smart phones, AS1339 offers up to 97% efficiency, noise reduction, and high switching frequency. It integrates 110 mW bypass FET supporting 1.1 A of peak current, and two 10 mA low-noise, high-PSRR LDO's for PA biasing. Packaged in 2 x 2 mm WL-CSP, compact regulator has 2 MHz fixed switching frequency that reduces PCB footprint by allowing use of low profile inductors and capacitors.