ERICSSON INC.    PLANO, TX 75024
Jun 06, 2011 Via PMBus interface, 3E series BMR462 can be configured to dynamically minimize energy consumption under all load conditions. Up to 7 of these 12 A devices can be paralleled to deliver up to 84 A to load. Measuring 0.827 x 0.5 x 0.323 in., product offers synchronization capability and respective input and output ranges of 4.5-14 and 0.6-5 V. At half-load, 5 Vin and 3.3 Vout, typ efficiency is 97.1%. Uses include information communications, industrial, and automation applications.

Protek Power North America, Inc.    Hudson, MA 01749
Jun 06, 2011 Compliant with UL60601-1 and TUV 60601-1 medical safety standards, PM400 Series delivers 300 W in convection cooled environments and 400 W with forced air. Units accept universal input voltage of 90-264 Vac and provide output voltages from 12-48 Vdc, with standby output of 5 Vdc at 100 mA. Housed in 4 x 7 x 1.58 in. package, RoHS-compliant power supplies offer efficiencies greater than 88%, leakage currents as low as 300 µA at 264 Vdc, and 4,000 Vac input-output isolation.

National Semiconductor Corp.    Santa Clara, CA 95051-0695
Jun 06, 2011 Operating from 6-70 V input, LM3466 conducts up to 1.5 A and incorporates 70 V, 1.5 A N-Channel MOSFET. Easy integration enables LM3466 along with one resistor and one capacitor to drive each LED string from any AC/DC constant-current power supply. Complete fixture can be constructed by repeating strings in parallel, and dynamic current equalizing control scheme enables communication between each linear LED driver to divide current equally or ratiometrically among multiple active LED strings.

Powerex, Inc.    Youngwood, PA 15697
Jun 06, 2011 J-Series transfer molded power module (T-PM), CT300DJH060, is primarily intended for hybrid and electric vehicle applications. This 600 V/300 A power module incorporates 2 Carrier-Stored Trench Gate Bipolar Transistor (CSTBT(TM)) IGBT chips and utilizes direct lead bonding technology for optimal reliability. Built to be completely Pb free, including terminal plating, design also offers optimized power and temperature cycle lifespans.

Larson Electronics, LLC    Kemp, TX 75143
Jun 06, 2011 Mounted to coated steel frame with integrated skids, Magnalight MGS-15KVA-120-240-30AFT takes 480 Vac current and steps it down to 120 and 240 Vac commonly used with commercial power equipment. Transformer distributes 120 Vac through 10 GFCI protected receptacles and 240 Vac through 2 GFCI protected outlets, enabling multiple connections from 1 power source. Power is fed to fused ON/OFF disconnect switch via 20 ft of Line Power SO Cord, which manages power feed for 15 KVA, 480 V transformer.

NKK Switches    Scottsdale, AZ 85260-3420
Jun 06, 2011 Along with 5-tumbler locking mechanism, CKM Series features sliding silver contacts and vertically rotating self-cleaning switching mechanism. Switches are standard size with 16 mm double flatted bushings that sit securely in panel. Contact section is sealed away from key section to protect contacts, and keys come in flat or tubular styles. Rated 3 A @ 250 Vac, switches have SPDT circuit configuration with choice of 2 or 3 key positions. Circuit options are On-On or On-Off-On.

Electro Standards Laboratories    Cranston, RI 02921 3403
Jun 06, 2011 Telephone and Telecom Test Kit offers 13 cables designed to facilitate test and access of high-speed data interfaces. Bantam Plug to Two Mini-Grab Test Hooks cable, Catalog No. 940322-006, consists of miniature 3-conductor nickel phone plug connected to 2 mini-grab test hooks that have one red and one black body. This 26 AWG, shielded, twisted pair cable has high-flex PVC jacket. Mini-grab test hooks enable user to spring hook onto hard-to-reach circuit points.

Electro Standards Laboratories    Cranston, RI 02921 3403
Jun 06, 2011 Employing MEMS-based switches, QuickSwitch® Model 6190 enables users to access 2 separate devices, ports A and B, via device connected to Common port of switch. Unit supports multimode, 50/125 micron fiber with wavelengths of 850 nm and 1300 nm. Local control is via front-panel pushbutton, and remote access is by way of RS-232 commands sent through Remote Serial Port or by optional GUI. Users can remotely monitor status, control switch functions, lock front panel use, and query status.

Texas Instruments, Inc. (TI)    Dallas, TX 75243-4136
Jun 06, 2011 Model TPS55010, 2 W, 6 V primary-side feedback transformer driver features Fly-Buck topology to provide isolated power and remove ground loops from analog circuitry and communication interfaces, from unregulated 3.3 or 5 V input. Output voltage is set by resistor divider and transformer turns ratio. Providing up to 85% efficiency, unit has switching frequency range of 100 kHz to 2 MHz, and operates over temperature range of -40 to +150°C. It comes in 3 x 3 x 1 mm monolithic QFN package.

Absopulse Electronics, Ltd.    Carp, ON K0A1L0  Canada
Jun 03, 2011 Featuring 132 x 64 x 300 mm enclosure, HBC 500 industrial-quality AC/DC power supplies include 2 output terminals. Redundant terminal has output voltage of 24 Vdc/20 A, 48 Vdc/10 A, or 125 V/4 A, while direct terminal has output voltage that is one diode drop higher. Input accepts 230 Vac/115 Vac or 220 V to 370 Vdc. Resistant to shock and vibration, products also include current limiting on input and output as well as short-circuit protection and thermal shutdown on output.

Suntech Power Holdings Co., Ltd.    Jiangsu Province 214028  China
Jun 03, 2011 Powered by crystalline silicon cells, STP250S-20/Wd+ BlackPearl(TM) consists of 60-cell module comprised of 6 in. black square cells. This 250 W product features +0 to +5% positive power tolerance and minimized oxygen content that lends to resistance to light-induced degradation. Suited to rooftop installations, module withstands all weather conditions, including 3.800 N/m² wind load and 5.400 N/m² snow loads; and features anti-reflective, hydrophobic, self-cleaning surface.

Rautaruukki    Helsinki   Finland
Jun 02, 2011 Integrating photovoltaic system into fully glazed facade, Solar Panel Facade converts sun rays into energy, which is used to meet building's needs or is fed into electricity grid. Since system relies only on radiation, not on sun's warmth, power can be produced even in areas with no direct sun rays. In snowy areas and next to water, system increases output from reflected rays. Based on thin-film technology, PV panels have even black coloring and use no visible fasteners.

K&H Industries, Inc.    Hamburg, NY 14075
Jun 02, 2011 Explosion Proof Work Lights include 220 V, 50/60 Hz models and low-voltage models with 12 V inline step down transformer. Certified and listed for Class I Division 1 locations, including Groups C/D, intrinsically safe 26 W fluorescents and 100 W incandescents feature non-sparking aluminum guards and swivel hooks. All models (except cordless) come with 16/3 AWG SOOW cable that meets Federal Specifications JC-580-A. Uses include marine, petrochemical, mining, and aerospace applications.

Aimtec, Inc.    Dollard Des Ormeaux, QC H9G3B9  Canada
Jun 01, 2011 Model AMLB-Z step up LED drivers feature 4:1 input range of 9-36 Vdc that steps up to output voltage range of 14-48 Vdc as well as constant output currents from 150-700 mA. Ripple and noise are 350 mV p-p. Modular and RoHS-compliant, units also have remote ON/OFF function, continuous short circuit protection, and adjustable PWM and analog dimming functions to ensure consistent brightness.

Aviel Electronics    Las Vegas, NV 89118
Jun 01, 2011 Model CO-SMB-JKMA-3P01, panel-mount SMB jack adapter features interface that allows external sealing and .060 axial shift when mated with standard off-the-shelf SMB plug. This special adapter also allows RF electrical connection to non-standard unit, ensuring compatibility with standard RF connectors.

Tumbler Technologies, Inc.    Santa Clara, CA 95054
Jun 01, 2011 Operating at 90-264 Vac, 47-63 Hz universal input, TVW7 series AC/DC power adapters deliver 5-7 W of continuous output power and have output voltage range of 3-27 V. They consume 0.3 W standby power at no load and include overvoltage, overload, and short-circuit protection. Fully loaded at -10 to +40°C ambient temperature, they require 25% derating at +50°C. Models with 5 V/1 A output feature USB socket, while other models are equipped with 5 ft DC output cable and barrel plug.

Sensirion Inc.    Westlake Village, CA 91361
Jun 01, 2011 Based on digital MEMS chip, Model LG01 detects liquid flows down to 0.25 ml/min with max flow rate up to 220 ml/min, output signal of 0 or 5 V, and response time below 100 ms. Fluidic connections can be made via ¼-28 standard fittings, suitable for connecting plastic tubing with O.D. of 1/8 or 1/6 in. Chemical resistance and bio-compatibility are ensured by non-invasive measurement through wall of straight, 1.8 mm dia internal glass capillary and fluidic connectors made of PEEK(TM) plastics.

C&K Components    Newton, MA 02458
Jun 01, 2011 Offered in vertical and right angle versions, ITS Series features dome contact that provides crisp tactile feedback to positively indicate circuit transfer. Units employ insert-molded terminals to lock out flux, solvents, and other contaminants used with automated soldering processes. Supplied in thru-hole and SMT termination styles, switches come in many different single LED colors as well as bi-color options that are independent from switching function.

Key Digital Systems, Inc    Mount Veron, NY 10553
Jun 01, 2011 Fat Boy Series(TM) KD-MSA8x8Pro audio matrix switcher, designed for distributed audio applications, allows control of different audio zones. Unit switches 8 analog and PCM digital audio or composite video sources to 8 independent zones/outputs, and provides audio control for each output, including volume, multi-band equalizer, and lip sync control. Operated via Serial IR, Flasher IR, TCP/IP, or RS-232, programmable switcher also has circuitry that allows for cable runs up to 300 ft.

FZLED    New Taipei City   Taiwan
Jun 01, 2011 Available to fit GU5.3, GU10, E11, E14, E17, E26, E27, and B22 sockets, MR16-04 Series offers non-dimming, low-voltage TriAC-dimming, and high-voltage TriAC-dimming options. Other options include beam angles of 15°, 25°, or 40°. With CCT of 3000K or 6000K, 3 W models emit 180 or 230 lm and have CRI higher than 80 or 75. Models rated at 5 W are identical to 3 W models but produce 250 lm @ 3000K CCT or 300 lm @ 6000K CCT.