Micro Motion Div., Emerson Process Management    Boulder, CO 80301
Mar 19, 2012 Suited for new or retrofit installations, EtherNet/IP(TM) Module is compatible with all Micro Motion Coriolis flowmeters and is suited for hazardous areas. Device provides access to multivariable data including flow, density, temperature, and other parameters. Web browser offers network access to configuration and diagnostic interface, enabling full range of remote activities. Mounted in control cabinet, module eliminates need to run Ethernet cabling out to field.

Broadcom Corp.    San Jose, CA 95110
Mar 16, 2012 Providing integrated 40 nm single-chip solution, NetXtreme(TM) Ethernet Adapters combine media access controllers with physical layer transceivers. Units deliver full line-rate throughput across all ports. To support enterprise and data center requirements, adapters offer switch-independent NIC partitioning and IEEE 1588 time synchronization. Devices support iSCSI and FCoE offload storage protocols, and are capable of delivering up to 1.5 Million iSCSI IOPS.

Phihong USA    Fremont, CA 94539
Mar 01, 2012 Combining benefits of gigabit Base-T data rates and portability, POE16R-1AFG has output of 15.4 W at 56 Vdc for applications that include IP phones, access points, and portable networking equipment. Wall plug also utilizes R-Series field-interchangeable AC clips for worldwide compatibility. Compliant with IEEE802.3af and UL60950-2, 80 x 45 x 33 mm product weighs 200 g and comes with several protection and safety features.

Chelsio Communications    Sunnyvale, CA 94085
Sep 13, 2011 Consisting of 4 x 10Gb Ethernet, PCI 2.0 Express bus interface, Model T440-LP-CR features 32,000 offload connections and one QSFP+ port that uses standard cables or single octopus cable with QSFP+ transceiver on one end and 4 SFP+ transceivers on other end. Also featuring PCI Express 2.0 host bus interface, dual-port Model T420-BT provides two 1/10 GbE ports using RJ-45 connectors with twisted pair Cat-6a cables. Both enable unified wire for LAN, SAN, and cluster traffic.

ComNet    Danbury, CT 06810
May 09, 2011 Based on IEEE 802.3af standard for PoE, Model CWFE1POCOAX allows CCTV camera to operate at remote locations without onsite power. Unit transports IP video from camera using existing coaxial cable, while delivering operating power for devices back through same cable to provide power for Power over Ethernet camera. Product delivers 15 W of 48 Vdc power to remote devices and transports Ethernet data at rates up to 100 Mbps over distance of 230 m.

ATTO Technology Inc.    Amherst, NY 14068
Apr 07, 2011 Simultaneously enabling FCoE, iSCSI, and TCP/IP, FastFrame(TM) 10 Gbps Ethernet Converged Network Adapter foster unified networks in data-intensive environments. Products, based on Fibre Channel (FC) technology, include 4-port card option and utilize Intel® Ethernet technology. Offering seamless integration with existing FC equipment without loss in performance, adapters also leverage Advanced Data Streaming Technology(TM) for consistent bandwidth optimization with minimal latency.

Broadcom Corp.    San Jose, CA 95110
Mar 01, 2011 Packaged in low-profile PCI Express® form factor, Model BCM957712-T supports both networking and storage traffic over single 10 GbE connection. Based on BCM57712 MAC and BCM84823 PHY components, device brings full offload capabilities to 10 GbE and integrates TCP/IP and iSCSI offload on 10GBASE-T medium. Adapter uses RJ-45 connections for distances up to 100 m, and delivers bi-directional line rate throughput across both ports, and over 1 Million iSCSI IOPS.

ABB Low Voltage Drives    New Berlin, WI 53151
Feb 17, 2011 Combined with ACS355 and ACS850 drives, FECA-01 EtherCAT® Adapter offers solution for OEMs or system integrators focused on packaging, material handling, printing, rubber and plastics, and machine tool industries. Flexible plug-in fieldbus adapter provides connectivity to AC500 PLC and all other major programmable automation controllers and interfaces that support EtherCAT protocol. In addition to real-time control, solution is capable of extracting real-time data.

Red Lion Controls    York, PA 17402 9428
Dec 02, 2010 Fitted to Data Station Plus or Modular Controller series, XCENET Expansion Card allows operators to isolate machine level network traffic from enterprise level network. Card adds second 10 BaseT/100 Base-Tx Ethernet port, allowing communication on 2 distinct Ethernet networks simultaneously without addition of industrial router. Engineer can assign fixed IP address for port connected to PLCs and drives, while IT manager can select their own IP address or use DHCP to configure enterprise port.

InnovASIC, Inc.    Albuquerque, NM 87107
Nov 23, 2010 Serving EtherNet/IP adapters and Profinet devices, 1-Port RapID(TM) Platform supports EtherNet/IP November 2010 release and Profinet v2.2. It is fully functional and pre-tested for EtherNet/IP and Profinet conformance, including electronic schematics, BOM, and layout files as well as all necessary software, stacks, and development environment. Ethernet physical layer includes protection circuitry, bicolor LEDs, and magnetics integrated in connector, and cycle times down to 1 ms are achieved.

Elektrobit Group Plc.    Oulunsalo FIN-90460  Finland
Oct 07, 2010 Featuring network-agnostic design, EB Tough VoIP PoE Injector(TM) provides Power-over-Ethernet-supported data interfaces to tactical military communications equipment. By deploying system, military personnel can combine data and power supply over single Ethernet cable. Accessory can combine vehicular power supplies in voltage range of 10-30 Vdc with Ethernet data, while providing PoE connection for user devices.

Exar Corp.    Fremont, CA 94538
Aug 24, 2010 Used for access and transport applications, GEM250 SoC and included DeviceManager(TM) software to accelerate development and deployment of dual GbE transport solutions for Coarse/Dense Wavelength Division Multiplexing (C/DWDM) networks. It delivers all operations, administration, maintenance, and provisioning features inherent in SONET/SDH, enabling efficient multiplexing of GbE links into single STM-16/OC-48 for transport across point to point links or WDM networks.

ComNet    Danbury, CT 06810
Aug 04, 2010 Featuring 2 standard BNC connectors, 2 terminal blocks, and 2 standard RJ-45 Ethernet connectors, Model CNFE2CL2MC allows Ethernet-based equipment to be connected over 75 W coaxial cable or unshielded twisted pair telephone wire. Unit can extend distances between devices to as much as 500 m on coaxial cable or up to 3,000 m on UTP. Featuring environmentally hardened design, modem operates in environments with extremes in temperature and vibration.

Radicom Research    San Jose, CA 95131
Aug 03, 2010 Measuring 1 x 1 x 0.25 in., LSHM-200 connects serial devices to IP networks via 10/100BaseT interface for remote control and monitoring applications. It provides data transfer among multiple IP addresses simultaneously via Telnet ports with TCP/IP protocols under Ethernet. Onboard Ethernet functions conform to IEEE802.3 standard with automation and buffering, while integrated serial port includes serial terminal features such as flow control and 8-N-1 character length.

AXIOMTEK    Taipei   Taiwan
Jul 28, 2010 Supplied in hardened aluminum case and rated for -40 to +75°C operation, IP30-rated iCON-1141 series translates transmission signals from 100BASE-TX cable to 100BASE-FX fiber optic cable. Link fault pass-through helps identify network errors, while redundant power and relay output warning alarm help prevent damage and loss. Available in all types of fiber cabling and connector types, converters feature 768K bits buffer memory and full wire-speed forwarding rate.

Netgear Inc.    Santa Clara, CA 96054
Mar 04, 2010 HomePlug® AV-certified powerline kits include Powerline AV 500 Adapter Kit (XAVB5001) and Powerline AV+ 500 Adapter Kit (XAVB5501). Both offer speeds of up to 500 Mbps PHY rates and Gigabit link rates, and latter also integrates filtered pass-through power socket. Compatible with draft international IEEE P1901 powerline standard, energy management, prioritized QoS, and 128-Bit AES encryption are standard.

ComNet    Danbury, CT 06810
Jan 26, 2010 ComWorx(TM) CNFE1CL1MC accepts 10/100TX Ethernet data and transports it over 75 W coaxial cable or twisted pair telephone wire. Allowing cable or UPT to transport Ethernet data from different security devices to network, unit can extend distances between devices to as much as 500 m on coaxial cable or up to 3,000 m on twisted pair. Output port is standard BNC connector or terminal block and input port is RJ-45 connector. Device is resistant to extreme temperatures and vibration.

Netgear Inc.    Santa Clara, CA 96054
Jan 12, 2010 Incorporating HomePlug® AV-certified powerline technology, which provides 10/100 Ethernet connection from any electrical outlet, Powerline 200 AV Adapter Kit and Powerline 200 AV+ Adapter Kit with filtered pass-through power socket enable HD video streaming, VoIP, and large file transfers to networked devices over existing electrical wiring. Both kits cover up to 5,000 ft², and include 128-bit AES encryption as well as multi-colored LEDs that indicate network performance.

Ethernet Direct    Newburyport, MA 01950
Dec 15, 2009 Suited for hazardous environments, Models RUE-111SE-CDU and RUE-113SE-CDU are Industrial Ethernet to fiber units with one 10/100 Mbps Ethernet port and one fiber port. Model RUE-111SE-CDU features multimode port with transmission distance of 2 km, while Model RUE-113SE-CDU includes single mode fiber port with transmission distance of 30 km, both using SC connector. Supporting 12~48 Vdc and 24 Vac, units offer reverse polarity protection, 3,000 Vdc EFT protection, and 6,000 Vdc ESD protection.

GlobTek, Inc.    Northvale, NJ 07647
Dec 03, 2009 Desktop/Wall Plug-in, 3.3-48 V POE Injectors supply 0-50 W of power and feature universal input of 100-250 Vac with Class I or Class II Protective Ground configurations. In addition to regulated output, they include overcurrent, overvoltage, short-circuit, and thermal protection. Devices measure 74 x 49 x 40 mm and are enclosed in impact-resistant, nonvented polycarbonate case with thermal conduction cooling. Products meet various safety agency requirements.