Power Management Devices feature dynamic voltage scaling.
Designed to optimize multimedia processor performance, LP3971 power management unit (PMU) and LM3370 integrated, dual-channel, step-down DC-DC converter feature digital I2C compatible interface that enables customization of electrical specifications. Digitally programmable, multiple-output power management devices include buck regulators that provide over 90% efficiency throughout entire load...
Read More »DC-DC Converters operate from 300 V nominal output.
With input range of 180-375 V, Micro DC-DC Converters include two 50 W models rated 3.3 and 5 Vout, and five 75 W models at 12, 15, 24, 28, and 48 Vout. Units have power densities up to 90 W/cu-in. with efficiencies up to 90%. Measuring 2.28 x 1.45 x 0.5 in. with above board height of 0.43 in., RoHS-compliant modules are suited for designing off-line power systems for industrial and process...
Read More »
Point-of-Load Converters suit space-sensitive applications.
Intended for computer, storage, and networking applications, RoHS-compliant LDO-C and SIL-C2 models are available with choice of vertical or horizontal through-hole mounting and horizontal surface mounting. LDO-C models offer choice of 3, 6, and 10 A outputs, while SIL-C2 models offer 20 or 40 A outputs. Protected against short-circuit and overvoltage conditions, converters use fixed frequency...
Read More »DC/DC Converters are positively regulated.
Charge pump DC/DC Converter Models MCP1256/7/8/9 automatically switch between 1.5x and 2x boost operation. All have low-noise ripple of less than 20 mVpp at load currents up to 100 mA. Extended temperature operation of -40 to +125Ã-
Read More »
Reshoring in Metal Stamping
This white paper provides an overview into the reshoring of metal stamping and other manufacturing processes.
Read More »PoE Device Controller works with low-voltage sources.
Designed for PoE devices that operate from alternative power sources or PoE-enabled network, LM5071 Powered Device interface and dc-dc converter IC is IEEE 802.3af-compliant PWM controller with programmable oscillator frequency to 1 MHz. Single-chip solution features current-mode dc-dc controller, user-programmable under-voltage threshold and hysteresis, and fault current control loop. With 50%...
Read More »Step-Down DC/DC Converter delivers up to 300 mA.
Using constant frequency and current mode architecture, synchronous buck regulator, Model LTC3410 operates from input voltage of 2.5-5.5 V and generates output voltages as low as 0.8 V, allowing it to power DSPs and microcontrollers. Switching frequency of 2.25 MHz enables use of tiny ceramic capacitors and inductors with less than 1 mm profile. Housed in SC70 package, converter uses internal...
Read More »
Converters minimize need for external components.
Miniature, non-isolated, point-of-load dc/dc converters reduce board space and design complexity by eliminating need for additional components. LSM2 surface mount and LSN2 through-hole modules can power CPUs, programmable logic, and mixed-voltage systems with minimum noise and heat. With input voltage of 2.5-5.5 V and 9-14 V, they are suitable for use in distributed power and intermediate bus...
Read More »DC-DC Converter is optimized for 3G WCDMA applications.
LTC3444 synchronous regulator delivers up to 400 mA of continuous output current to outputs between 0.5-5 V from single cell Li-ion input. Buck-boost design enables it to operate from input voltages above, below, and equal to output voltage. Available in 3 x 3 mm DFN package, LTC3444 features 1.5 MHz switching frequency, over-voltage protection, internal soft-start, and thermal shutdown. Device...
Read More »Signal Splitters offer 2,000 VRMS full optical isolation.
Series 4390 IsoSplitterÃ-® transmitters accept 2 dc voltage or current inputs and split them into 2 optically isolated dc voltage or current outputs. Suited for applications where one measurement must be monitored or recorded by 2 separate devices, products enable each I/O channel to be independently configured for dc ranges such as 0-100 mV, 0-5 V, 0-10 V, Ã-
Read More »DC/DC Converters suit GSM phone applications.
Available in fixed or programmable versions, Models AAT1146 and AAT2512 are designed for portable systems powered by single cell lithium-ion/polymer batteries. AAT1146 step-down converter delivers output as low as 0.6 V. AAT2512 is dual-channel synchronous buck converter. Featuring integrated temperature protection, both devices maintain 27 Ã-µA quiescent current, deliver load current up to...
Read More »
Neagle Choice, LLC Announces New Available Services
Neagle Choice has long been known as a quality source for commercial sewing, printing, die cutting, and the manufacturing of a wide range of custom products. Enhancing our service capabilities has been the key to our success, and has driven our growth into many new and exciting markets. Continuing on this trajectory, we now offer precision laser cutting and etching, adding to our long line of manufacturing services. See our video to learn all about it.
Read More »
