Engineering By Design
San Jose, CA 95131
Share:
Fiber Winder has alphanumeric display and interface.
Machine transfers fiber to target spool or holder for making erbium doped fiber amplifiers or for re-spooling fiber, wire, tubing or similar materials at speeds to 120 fpm with programmable tension. It measures 35 x 18 x 12 in., weighs 65 lb, and handles spools up to 5 in. high and 12 in. dia. Pinch roller with one-way clutch simplifies process of changing target holders. Interface is used for...
Read More »
Punch automates filter-cutting process.
Frit punch/place machine presses 8 sharpened SST tubes into precut sheet of filter paper to cut frits and pick them up inside tubes. It positions first row of microtiter tray under tubes and places frits into bottom of each well using ejection pins. Machine keeps track of where each set of holes is punched from filter sheet and indexes over one pitch to always get clean set of frits. After 12...
Read More »
Coil Winder has machine vision.
Double Vision device winds fine filaments around spinning mandrel to produce micro coils, stents and catheters. It has menu-selectable variables, digital readout of parameter set points and values, and closed-loop tension and slack control. It provides wind speeds up to 6,000 mandrel rpm. Maintaining steady tension of 0.2 g and wind angle of 0.1 deg make it possible to produce coil with 0.0004...
Read More »
Extrusion Puller resizes and cuts.
Machine resizes plastic coated, braided tubing with heated die, checks for exposed wires, and cuts sections to any length. Hot die is located between two independent pinch drives. Each pinch drive is electronically geared to programmed speed or input from upstream size feedback. It has alphanumeric color touch screen for menu-selectable die heat, cut length and relative speeds for each pinch...
Read More »
Fiber Winder has alphanumeric display and interface.
Machine transfers fiber to target spool or holder for making erbium doped fiber amplifiers or for re-spooling fiber, wire, tubing or similar materials at speeds to 120 fpm with programmable tension. It measures 35 x 18 x 12 in., weighs 65 lb, and handles spools up to 5 in. high and 12 in. dia. Pinch roller with one-way clutch simplifies process of changing target holders. Interface is used for...
Read More »
Punch automates filter-cutting process.
Frit punch/place machine presses 8 sharpened SST tubes into precut sheet of filter paper to cut frits and pick them up inside tubes. It positions first row of microtiter tray under tubes and places frits into bottom of each well using ejection pins. Machine keeps track of where each set of holes is punched from filter sheet and indexes over one pitch to always get clean set of frits. After 12...
Read More »
Coil Winder has machine vision.
Double Vision device winds fine filaments around spinning mandrel to produce micro coils, stents and catheters. It has menu-selectable variables, digital readout of parameter set points and values, and closed-loop tension and slack control. It provides wind speeds up to 6,000 mandrel rpm. Maintaining steady tension of 0.2 g and wind angle of 0.1 deg make it possible to produce coil with 0.0004...
Read More »
Extrusion Puller resizes and cuts.
Machine resizes plastic coated, braided tubing with heated die, checks for exposed wires, and cuts sections to any length. Hot die is located between two independent pinch drives. Each pinch drive is electronically geared to programmed speed or input from upstream size feedback. It has alphanumeric color touch screen for menu-selectable die heat, cut length and relative speeds for each pinch...
Read More »