TE Connectivity
Berwyn, PA 19312
Vertical Headers suit blindmate applications.
Based on 4.2 x 4.2 mm centerlines, PE Series consists of wire-to-wire, wire-to-board, and wire-to-panel connectors available in even position sizes from 2-24. Contacts are rated for 9 A max and 600 Vac. Using headers, designers can create systems where exact positioning of connectors is aided by funnel lead-in of housing to permit alignment and mating. Applications include power supplies, vending...
Read More »Circular Plastic Connectors suit medical applications.
Featuring shock resistant housings, push-pull mating, and self-latching mechanism, CPC - Medical Connectors come in 5, 6, 7, and 10 contact positions with max current ratings of 7, 6, 5, and 3 A, respectively. Wire-to-panel units are sterilizable via autoclave, STERRAD 100 S1, CIDEX +, and EtO. With mating force of 2.5 lb and unmating force of 1 lb, connectors are suited for surgical instruments,...
Read More »Linear Power Amplifier is designed for PHS applications.
Supplied in Pb-free 3 mm 12-lead PQFN package, M/A-COM MAAP-000082 is suited for space-restricted PHS (Personal Handy-phone System) applications that require high gain and efficiency. This 1.9 GHz, 3-stage power amplifier is equipped with ESD protection and withstands electrostatic discharges up to 1,000 V without performance degradation. Consuming 200 mA of current, it provides 21 dBm of linear...
Read More »Digital Transmitter supports GPRS, EDGE, CDMA2000, and UMTS.
Featuring single closed-loop digital polar design, DTx radio architecture enables true multi-band, multi-mode operation from 2.5-4 G for GPRS/EDGE, W-CDMA, CDMA 2000, and HSPA as well as LTE, EVDO, and WiMax air interfaces. It allows modulation of signals with over 30 MHz of bandwidth, and includes full transmitter subsystem with calibration and corrections algorithms, enabling tight control over...
Read More »
SPDT Switch suits broadband applications.
Model M/A-COM MASWSS0201 achieves less than 0.9 dB of insertion loss and 65 dB of isolation at 100 MHz in 75 ohm system. Switch is designed to have P1 dB of 21 dBm at 100 MHz and 28 dBm at 900 MHz. Greater than 40 dB isolation is maintained up to 2.5 GHz with corresponding insertion loss less than 1.5 dB. It is configurable to have absorptive or reflective RF1, RF2 port matches, and when...
Read More »DSCC Approves Tyco Electronics MIL-DTL-24308 Connectors
Zinc Plated Connector Shells Introduced HARRISBURG, Pa. - June 18, 2007 - Tyco Electronics Corporation recently obtained approval from the Defense Supply Center Columbus (DSCC) for MIL-DTL-24308 connectors with zinc plating and chromate coating. This most recent approval from DSCC is for roughly 90 part numbers and includes printed circuit board-mount plug and receptacle connectors in vertical...
Read More »
Splicing Tape suits underground electrical applications.
Combining thermoplastic rubber with butyl rubber sealant, FSTW Tape provides complete rejacketing solution in one pass and delivers submersible watertight seal. With 50 mil thickness, FSTW offers puncture protection. It is available in point-of-purchase packages of five 4 ft rolls or bulk packaging of twelve 6 ft rolls. Tape is suited for repairing cable jackets, sealing low voltage splices, and...
Read More »
Clamps, Plugs, and Bushings suit commercial construction.
Made of fire-rated plastic, AMP Connector Clamps secure and install nonmetallic sheathed cable to steel boxes or panels. Units accommodate 1 or 2 wires, are rated for 60 lb pull-out, and are available for Ã-½ or Ã-¾ in. knockout holes. Designed for plugging unused knockouts in boxes or panels, AMP Plugs fasten securely to any round open hole from Ã-½-2 in. Offered in round or square,...
Read More »
RFID Reader Modules cover worldwide frequency range.
Receive I/Q (In-Phase/Quadrature) modules - MAIA-007860-000100 (low local oscillator drive), MAIA-007859-000100 (medium LO drive), and MAIA-007775-000100 (high LO drive) - cover 850-960 MHz frequency range with phase balance under 2.5Ã-
Read More »
Radiating Cable Antennas operate over 400-6,000 MHz range.
Compatible with cellular, Bluetooth, and WLAN frequency bands, M/A-COM Antennas feature flexible coaxial cable construction, which incorporates radiating apertures in cable's outer conductor. End-to-end FEP jacket protects apertures and prevents moisture ingression. Suited for transmit, receive, and simultaneous Tx/Rx applications, antennas meet requirements for operating temperature, thermal...
Read More »