SEVAAN GROUP Pty Ltd
Minto AUS
Share:
Fluid Containment Bench collects spills.
Model 030474 Fluid Containment Bench eliminates unsafe spills. Suitable for areas of repair or service, fluid containment bench includes reinforced stainless steel top with a 1/2 in. lip on all sides and an offset drain. It measures 48 in. wide x 32 in. deep x 41 in. high.
Read More »
Straightener/Feeder features computer control.
LCC-HF2 Straightener/Feeder, equipped with HM-type Computer Control System (CCS), handles metals from 1.97 in. to 39.37 in. wide and up to 0.18 in. thick. It accepts maximum coil weights up to 10 tons and maximum coil O.D.s of 60 in. Features include no-loop detector, photo sensor loop control, pilot roll, handwheel adjustment, end-of-stock detector, and pneumatic or hydraulic expansion systems.
Read More »
Jack provides cable strain relief.
Xcelerator(TM) GX2 Jack features QuickLace(TM) termination process and universal wiring format. It includes white IDC tower for visual contrast and smoke-gray stuffer cap that provides positive snap-latch feel and strain relief when jack is installed.
Read More »
Spectrophotometer is available with a range of accessories.
Model 1200 visible spectrophotometer, with 5 nm narrow bandwidth, functions in visible range of 325-1000 nm. Multiple types of cuvette and test tube holders are available. Universal holder can hold sample test tube between 8 to 25 mm. Accessories include water-jacketed cell holder with base and panel for temperature control, longpath 4-cell holder, and 4-cell holder for 10xl0 mm cuvettes.
Read More »
Granulators minimize dust and fines.
Available in 3 sizes, EX Series Screenless Granulators feature 2 HP low-speed gearmotor, cyclodial speed reducer, hardened 8620 alloy steel cutters and combs, and interlocking double front doors. Feed chute adjusts 360-
Read More »
Machine installs internal O-rings and seals,.
Internal O-Ring and Seal Installation Machine installs O-rings or seals into internal grooves with semi-automatic operation. Operator places part into holding fixture and actuates machine. O-ring or seal is automatically installed into internal grooves. Machine achieves rates of up to 30 parts per minute, and can be tooled to accommodate different sized O-rings and seals. It can also be...
Read More »
Transmitter is designed for difficult humidity locations.
Model IN-HWD uses microprocessor to provide 4 to 20 mAdc output for humidity and temperature. Humidity output is accurate to 1.0% and temperature output is accurate to 0.1%. Inputs are wet bulb and dry bulb that can be either RTDs or electrical equivalent of wet and dry bulb. Outputs are available as mV, V or current. Constructed of 316 stainless steel, Model WDT-DW humidity tank with wet and dry...
Read More »
Industrial CCD Camera has megapixel progressive scan.
Compact, switchless CV-A1 has 1392 x 1040 resolution, analog output and RS232 set-up. It operates at 16 frames/sec and its software-configurable partial scan/binning capability allows rate to be increased to 124 frames/sec at reduced resolution for faster acquisition in applications where full-frame vertical resolution is not required. Camera measures 1.14 x 1.73 x 2.6 in. Reliability is...
Read More »Epoxy features built-in cure indicator.
CHIPSHIELD 1455HD low-viscosity UV curable epoxy is designed to perform as chip coating both in smart cards and as a protective glob on PC surface-mounted chips. It is cured with long wave UV, 325-380 nm wavelength. Epoxy is light powder blue before cure, and faint rose to amber after cure, indicating cure has been completed. With Tg of 80-
Read More »UV Lamp delivers light to hard-to-reach places.
Spectroline-® AP-800 UltraWand(TM) 8-watt UV lamp is 1 in. in diameter and 30 in. long. It plugs into ac outlet or generator with 12 ft cord. Lamp delivers steady-state UV irradiance of 4,800 pWM/cm2 at 1 in., so inspectors can see cracks and defects. Applications include inspecting inside of pipelines for defective welds or hydrocarbon contamination and conducting internal wet magnetic-particle...
Read More »