Agfa-Gevaert Group

Septestraat 27
Mortsel BEL

Precision Power Chucks mount directly to machine spindles.

Compatible with various machining centers, ROTA NCK plus features one-piece chuck body for optimal rigidity. Precision piston guide and support minimize wear while promoting continuous clamping accuracy and tool life. Available in 2 versions, jaw interface is offered with 1.5 mm x 60Ã-

Material Handling & Storage

Gripper suits internal and external assembly applications.

Designed to fit O-rings not only to shafts, but also in holes, 6-finger Model ORG 85 features integral stroke and triple jaw sets that move independently from one another. O-ring is first released from first 3 fingers, and then released from last 3 fingers in controlled manner. Clamping width of diameter to be fitted ranges from 5-150 mm. Stroke of 2 sets of triple jaws range from 0-21 mm for...

Communication Systems & Equipment

Compensation Unit suits pick-and-place applications.

With compensation ranges of Ã-

Electrical Equipment & Systems

Clamping System utilizes electro-permanent magnets.

With MAGNOS Clamping System, 5-sided machining is possible at high holding forces, without any interfering contours of clamping device. Pole extensions that act as workpiece support allow user to position different workpieces rapidly and precisely. Uniform clamping force is possible due to poles' quadratic geometry. Pole sizes of 50, 75, and 100 mm are available, enabling holding forces to be...

Machinery & Machining Tools

Power Chucks features 6-point contact design.

Available in 165, 210, 250 and 315 mm sizes, ROTA NCR 6-jaw power chuck is designed for use when machining thin-walled and easily deformed workpieces. It consists of central chuck piston with master jaws oscillating in pairs for concentric clamping. Pendulum is connected to each set of 2 base jaws, centering workpiece between 6 points of contact in which members of each pair lie opposite one...

Toolholders are suited for rough milling applications.

Utilizing clamping principle based on expansion technology with solid body as pressure medium, Total Tooling SINO-R Universal Toolholders exhibit radial stiffness and vibration dampening characteristics that lend to workpiece surface quality and reduction of machining noise. It is available with spindle interfaces CAT 40 and HSK-A 63 in metric and inch versions. Torque wrenches are not necessary,...

Architectural & Civil Engineering Products

Compact Toolholder is suited for high-speed applications.

Offering run-out accuracy of less than 3 microns and feed rate up to 20 m/min, TRIBOS-RM is designed for cutting speeds up to 50,000 rpm in applications that require low interference. Clamping process, which uses elastic forces of material to clamp tool shank, can be done within 30 sec via SVP-2 (manual) or SVP-3 (automatic) clamping device together with corresponding reduction inserts. Due to...

Controls & Controllers

Developer's Kit helps set up and test motion systems.

Suited for dc brush, brushless dc, or step motors, ION(TM) Developer's Kit consists of ION digital drive, communication and I/O cables, Pro-MotionÃ-® development software, and documentation. Fully enclosed digital drive module provides motion control, network connectivity, and amplification. It offers serial and multiple CAN interfaces, as well as user-selectable profiling modes. Package...

Software

Software simulates drying and evaporation processes.

Featuring drying gas stream, drying material stream, and 19 unit operations, ProcesSimO v1.0 can be used to model drying process, evaporation process, or combined evaporation and drying process. Users can explore different arrangements of unit operations and experiment with operating conditions. Based on design requirements, engineers can layout heat/mass/pressure balance calculations and obtain...